Pressureless sintering and tribological properties of in-situ TiC-Ni3(Al,Ti)/Ni(Al,Ti) composites

In this study, we report on the microstructure and tribological characterization of in-situ TiC and gamma'-Ni-3(Al,Ti) reinforced gamma-Ni(Al,Ti) matrix composites, synthesized by in-situ reaction of Maxthal211 (Ti2AlC-Ti3AlC2, MAX phase) and Ni precursors. Three composites were elaborated from 10, 20 and 30 wt% of the MAX phase precursor which fully reacted with Ni-matrix at 1080 degrees C sintering temperature for 4 h; the MAX phase decomposed into TiC, and the released Al and Ti atoms diffused in Ni matrix forming gamma-Ni(Al,Ti) solid solution and gamma'-Ni-3(Al,Ti) intermetallic. Scanning Electron Microscopy (SEM), X Rays Diffraction (XRD) and Raman spectroscopy were used to study the different microstructures and worn surface characteristics. Dry sliding properties of the composites under different normal loads were studied using a ball-on-disc tribometer. Addition of 10 wt% MAX phase procured the highest hardness (1.35 GPa) which is two times higher than that of pure Ni. Whereas all the reinforced composites exhibited better wear resistance. The formation of a lubricious layer during sliding and the good in-situ bonding between Ni/reinforcement phases, were the main cause to the enhanced wear resistance.

Automated summary

This study investigated the microstructure and tribological characterization of in-situ TiC and gamma'-Ni-3(Al,Ti) reinforced gamma-Ni(Al,Ti) matrix composites. The addition of 10 wt% MAX phase precursor resulted in the highest hardness and all reinforced composites showed improved wear resistance. The formation of a lubricious layer during sliding and good in-situ bonding between Ni/reinforcement phases were identified as the main reasons for the enhanced wear resistance.