4.7 Article

Cost effective and facile low temperature hydrothermal fabrication of Cu2S thin films for hydrogen evolution reaction in seawater splitting

Journal

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY
Volume 47, Issue 72, Pages 30819-30829

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.ijhydene.2021.06.153

Keywords

Hydrothermal; Cu2S thin film; Hydrogen evolution reaction; Seawater splitting

Funding

  1. UGC-SAP, DST-FIST, DST-PURSE, MHRD-RUSA
  2. Project on Collaborative Innovation and Environmental Construction Platform of Guangdong Province [2018A050506067]

Ask authors/readers for more resources

Electrolysis of seawater for hydrogen production is an attractive approach for renewable energy technologies. In this study, Cu2S electrocatalyst was fabricated on Ni foam using a low temperature hydrothermal growth method. The Cu2S catalyst grown for 1 hour exhibited low overpotentials and superior electrocatalytic behavior for hydrogen evolution reaction in both deionized water and seawater. The results suggest that the cost-effective and low temperature fabrication of Cu2S electrocatalyst holds great potential for large-scale seawater splitting.
Electrolysis of seawater gets an attention to produce hydrogen for renewable energy technology. It significantly reduces the use of fresh water instead of seawater. Develop-ment of low temperature fabrication of electrocatalyst can explore seawater splitting by avoiding chloride reduction during the hydrogen production. In the present work, we fabricated low temperature hydrothermal growth of Cu2S electrocatalyst on Ni foam at constant temperature of 80 degrees C at different growth times of 1-3 h. The prepared Cu2S electrocatalyst grown for 1 h exhibited low overpotentials of 76 and 118 mV at 10 mA/cm(2) (289 and 358 mV overpotentials at 100 mA/cm(2)) in 1 M KOH deionized water and seawater, respectively for hydrogen evolution reaction (HER). The Tafel plot of Cu2S catalyst grown for 1 h showed lesser Tafel slope value of 128 mVdec-1 than that of other growth times 2 h (136 mVdec(-1)) and 3 h (142 mV dec(-1)) indicating elevated electrocatalytic behaviour of Cu2S grown for 1 h. Electrochemical impedance spectroscopy (EIS) showed charge transfer resistance of 12.8U, 19.6 U and 25.7U, for Cu2S grown for 1, 2 and 3 h, respectively, this lower charge transfer resistance indicated higher charge transfer properties. The Cu2S electro-catalyst grown for 1 h sustained retention of 80% after 12 h continuous stability test. Therefore, the cost-effective and low temperature fabrication of Cu2S electrocatalyst pro-ceeds for development of largescale seawater splitting for hydrogen production. (c) 2021 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available