☆ 4.7 Article

Effects of fluorinated ethylene propylene contents in a novel gas diffusion layer on cell performance of a proton exchange membrane fuel cell

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2022)

Related references

Note: Only part of the references are listed.

Article Energy & Fuels

Polypyrrole nanowires as a cathode microporous layer for direct methanol fuel cell to enhance oxygen transport

Xudong Fu et al.

Summary: A novel cathode MPL based on polypyrrole nanowires grown on carbon paper via in situ electropolymerization shows improved performance in DMFCs compared to traditional MPLs, with higher power density and enhanced oxygen transfer due to decreased PTFE content and reduced ohmic resistance.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

Add to Collection

Article Energy & Fuels

PtCooncontinuous-phasegraphene asPEMfuel cell catalyst

Fatma Gul Boyaci San et al.

Summary: The research shows that increasing the atomic ratio of PtCo up to 1:3 significantly enhances the electrode activity for both membrane and gas diffusion layer, resulting in higher power densities. In contrast, the best performance for the cathode is achieved with 1:2 and 1:1 PtCo compositions on the membrane and gas diffusion layer respectively.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

Add to Collection

Article Energy & Fuels

Effect of pore size distribution in the gas diffusion layer adjusted by composite carbon black on fuel cell performance

Guangyi Lin et al.

Summary: The research found that the newly prepared gas diffusion layer with composite carbon black has significantly improved performance compared to traditional GDL, and the optimal fuel cell performance is confirmed to be composed of 70% Acetylene Black carbon and 30% Vulcan XC-72.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

Add to Collection

Article Energy & Fuels

Numerical simulation of particulate matter interaction with the gas diffusion layer of proton-exchange membrane fuel cells under various relative humidity conditions

Amir Panahi et al.

Summary: This study investigates the interaction of particulate matter (PM) in the gas stream and their capture efficiency by fibrous structure of gas diffusion layers (GDLs) at different levels of relative humidity (RH) and particle sizes. It is found that high humidity levels result in higher diameter and lower density of PM, leading to lower air density and particle bounce. The increase in humidity level decreases capture efficiency for small particles but increases it for large particles, highlighting the importance of installing a filter for removing large particles in the reactant gas supply line to prevent PM accumulation in GDL structure.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

Add to Collection

Article Energy & Fuels

A novel hydrophilic-modified gas diffusion layer for proton exchange membrane fuel cells operating in low humidification

Zhicheng Liu et al.

Summary: A novel hydrophilic-modified gas diffusion layer (GDL) with Polyacrylonitrile (PAN) has been fabricated to improve the performance of proton exchange membrane fuel cells (PEMFCs) under low humidity. The addition of PAN in the cathode GDL significantly increases the power density by 30% under low humidity, without affecting the performance under full humidity.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

Add to Collection

Article Energy & Fuels

Influence of perforated gas diffusion layer micropore shape parameters on water removal in a proton exchange membrane fuel cell flow channel

Xuan Xie et al.

Summary: The impact of microporous GDL flow channel with different depths, radiuses, and spacings on water transport and water removal is discussed. The resistance can be reduced, and water removal can be accelerated greatly in the perforated GDL. When the micropore depth is 50 mu m, radius is 50 mu m, and spacing is 200 mu m, the flow channel has a better drag reduction performance.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2021)

Add to Collection

Article Energy & Fuels

Rapid degradation characteristics of an air-cooled PEMFC stack

Lizhong Luo et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2020)

Add to Collection

Article Chemistry, Physical

Enhanced low-humidity performance in a proton exchange membrane fuel cell by developing a novel hydrophilic gas diffusion layer

Sanying Hou et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Add to Collection

Article Materials Science, Multidisciplinary

Preparation of hierarchical-pore gas diffusion layer for fuel cell

Tianya Li et al.

JOURNAL OF MATERIALS SCIENCE (2020)

Add to Collection

Article Chemistry, Physical

Structural design of gas diffusion layer for proton exchange membrane fuel cell at varying humidification

Liang Chen et al.

JOURNAL OF POWER SOURCES (2020)

Add to Collection

Article Energy & Fuels

Reduced graphene oxide-coated anode gas diffusion layer for performance enhancement of proton-exchange membrane fuel cell

Yi-Chen Lin et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2019)

Add to Collection

Article Energy & Fuels

Experimental investigation on the performance and durability of hydrogen AEMFC with electrochemical impedance spectroscopy

Xu Xie et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2019)

Add to Collection

Article Energy & Fuels

Effects of an MPL on water and thermal management in a PEMFC

Fereshteh Salimi Nanadegani et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2019)

Add to Collection

Article Electrochemistry

A Gas Diffusion Layer Impregnated with Mn3O4-Decorated N-Doped Carbon Nanotubes for the Oxygen Reduction Reaction in Zinc-Air Batteries

Drew Aasen et al.

BATTERIES & SUPERCAPS (2019)

Add to Collection

Article Thermodynamics

Gas diffusion layer development using design of experiments for the optimization of a proton exchange membrane fuel cell performance

Brahim Laoun et al.

ENERGY (2018)

Add to Collection

Article Energy & Fuels

Determination of oxygen transport resistance in gas diffusion layer for polymer electrolyte fuel cells

Z. H. Wan et al.

INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2018)

Add to Collection

Article Chemistry, Physical

Enhancement of proton exchange membrane fuel cell performance by titanium-coated anode gas diffusion layer

Sheng-Yu Fang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

Add to Collection

Article Chemistry, Physical

Ultra thin gas diffusion layer development for PEMFC

Chien-Hsin Hung et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2012)

Add to Collection

Article Chemistry, Physical

Investigation of sintered stainless steel fiber felt as gas diffusion layer in proton exchange membrane fuel cells

Peiyun Yi et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2012)

Add to Collection

Article Chemistry, Physical

Microporous layer coated gas diffusion layers for enhanced performance of polymer electrolyte fuel cells

Tatsumi Kitahara et al.

JOURNAL OF POWER SOURCES (2010)

Add to Collection

Article Electrochemistry

A catalytic gas diffusion layer for improving the efficiency of a direct methanol fuel cell

Ming-Chi Tsai et al.

ELECTROCHEMISTRY COMMUNICATIONS (2007)

Add to Collection

Article Chemistry, Physical

Innovative gas diffusion layers and their water removal characteristics in PEM fuel cell cathode

Kui Jiao et al.

JOURNAL OF POWER SOURCES (2007)

Add to Collection

Article Green & Sustainable Science & Technology

The effects of porosity distribution variation on PEM fuel cell performance

R Roshandel et al.

RENEWABLE ENERGY (2005)

Add to Collection

Article Chemistry, Physical

Effects of flow distributor geometry and diffusion layer porosity on reactant gas transport and performance of proton exchange membrane fuel cells

WM Yan et al.

JOURNAL OF POWER SOURCES (2004)

Add to Collection

Article Electrochemistry

Effects of hydrophobic polymer content in GDL on power performance of a PEM fuel cell

C Lim et al.

ELECTROCHIMICA ACTA (2004)

Add to Collection

Article Chemistry, Physical

Effect of PTFE contents in the gas diffusion media on the performance of PEMFC

GG Park et al.

JOURNAL OF POWER SOURCES (2004)

Add to Collection

Article Chemistry, Physical

Effects of porosity change of gas diffuser on performance of proton exchange membrane fuel cell

HS Chu et al.

JOURNAL OF POWER SOURCES (2003)

Add to Collection

Article Chemistry, Physical

Improvement of water management by a microporous sublayer for PEM fuel cells

ZG Qi et al.

JOURNAL OF POWER SOURCES (2002)

Add to Collection

© Peeref 2019-2024. All rights reserved.