Related references
Note: Only part of the references are listed.Identification of wire electrical discharge machinability of SiC sintered using rapid hot pressing technique
Meinam Annebushan Singh et al.
CERAMICS INTERNATIONAL (2020)
Micro-electrical discharge machining of difficult-to-machine materials: A review
Ved Prakash et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2019)
Fabrication of microelectrode with large aspect ratio and precision machining of micro-hole array by micro-EDM
Zhengkai Li et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2019)
Minimizing drum-shaped inaccuracy in high-speed wire electrical discharge machining after multiple cuts
Cong Deng et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2019)
Research on wire-cut electrical discharge machining constant discharge probability pulse power source for silicon crystals
Luochen Liu et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2019)
Improving EDM performance by adapting gap servo-voltage to machining state
Ming Zhou et al.
JOURNAL OF MANUFACTURING PROCESSES (2019)
Super-high-thickness high-speed wire electrical discharge machining
Chengrang Li et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
Study on volt-ampere characteristics of spark discharge for transistor resistor pulse power of EDM
Yin-Sheng Fan et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2018)
Increasing process efficiency of HSWEDM based on discharge probability detection
Xiaoxiao He et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Enhanced debris expelling in high-speed wire electrical discharge machining
Hongwei Pan et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Machinability analysis of multi walled carbon nanotubes filled alumina composites in wire electrical discharge machining process
Meinam Annebushan Singh et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)
Interelectrode discharge mechanism in high-speed wire electrical discharge machining
Zhang Yueqin et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2016)
Surface burning of high-speed reciprocating wire electrical discharge machining under large cutting energy
Wang Wei et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2016)
Study of the mechanism of multi-channel discharge in semiconductor processing by WEDM
Hao-ran Chen et al.
MATERIALS SCIENCE IN SEMICONDUCTOR PROCESSING (2015)
Automatic control of WEDM servo for silicon processing using current pulse probability detection
Liu Zhidong et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2015)
Fatigue response of Udimet 720 following minimum damage wire electrical discharge machining
M. T. Antar et al.
MATERIALS & DESIGN (2012)
An Integrated Approach to Optimization of WEDM Combining Single-Pass and Multipass Cutting Operation
S. Sarkar et al.
MATERIALS AND MANUFACTURING PROCESSES (2010)
Surface quality improvement of wire-EDM using a fine-finish power supply
Mu-Tian Yan et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2007)
State of the art in wire electrical discharge machining (WEDM)
KH Ho et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2004)
State of the art electrical discharge machining (EDM)
KH Ho et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2003)
Improvement of EDM efficiency of silicon single crystal through ohmic contact
M Kunieda et al.
PRECISION ENGINEERING-JOURNAL OF THE INTERNATIONAL SOCIETIES FOR PRECISION ENGINEERING AND NANOTECHNOLOGY (2000)