Related references
Note: Only part of the references are listed.Thickness effect on spring-in of prepreg composite L-profiles - An experimental study
Erik Horberg et al.
COMPOSITE STRUCTURES (2019)
Cost efficiency, integration and assembly of a generic composite aeronautical wing box
M. K. Hagnell et al.
COMPOSITE STRUCTURES (2016)
Dimensional stability of epoxy-based and cyanate-based carbon fiber-reinforced plastics
Yoshihiko Arao et al.
JOURNAL OF COMPOSITE MATERIALS (2015)
Local micromechanics of moisture diffusion in fiber reinforced polymer composites
Deepak Jain et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2014)
Process distortions in prepreg manufacturing - An experimental study on CFRP L-profiles
E. Kappel et al.
COMPOSITE STRUCTURES (2013)
Investigation into failure of laminated composite T-piece specimens under bending loading
F. Helenon et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2013)
Experimental identification of process parameters inducing warpage of autoclave-processed CFRP parts
D. Stefaniak et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2012)
Hygrothermal Properties of Highly Toughened Epoxy Adhesives
A. Ameli et al.
JOURNAL OF ADHESION (2010)
Mechanisms generating residual stresses and distortion during manufacture of polymer-matrix composite structures
MR Wisnom et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2006)
Development of spring-in angle during cure of a thermosetting composite
N Ersoy et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2005)
Experimental and numerical study of the effect of cure cycle, tool surface, geometry, and lay-up on the dimensional fidelity of autoclave-processed composite parts
G Fernlund et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2002)
Spring-in and warpage of angled composite laminates
C Albert et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2002)
Hygroscopic aspects of epoxy/carbon fiber composite laminates in aircraft environments
HS Choi et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2001)
Separating sources of manufacturing distortion in laminated composites
DW Radford et al.
JOURNAL OF REINFORCED PLASTICS AND COMPOSITES (2000)
Development of the transient simulated laminate (TSL) methodology for moisture ingression studies using unsymmetric laminates
YJ Wu et al.
JOURNAL OF COMPOSITE MATERIALS (2000)