Related references
Note: Only part of the references are listed.An isogeometric framework for the optimal design of variable stiffness shells undergoing large deformations
Francesco S. Liguori et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2021)
A Modeling Method of Continuous Fiber Paths for Additive Manufacturing (3D Printing) of Variable Stiffness Composite Structures
Andrei Malakhov et al.
APPLIED COMPOSITE MATERIALS (2020)
In-line variable spreading of carbon fibre/thermoplastic pre-preg tapes for application in automatic tape placement
Gearoid Clancy et al.
MATERIALS & DESIGN (2020)
A study of the influence of processing parameters on steering of carbon Fibre/PEEK tapes using laser-assisted tape placement
Geardid Clancy et al.
COMPOSITES PART B-ENGINEERING (2019)
Postbuckling optimisation of a variable angle tow composite wingbox using a multi-modal Koiter approach
Francesco S. Liguori et al.
THIN-WALLED STRUCTURES (2019)
Design, Manufacture and Test of an In-Situ Consolidated Thermoplastic Variable-Stiffness Wingbox
Vincenzo Oliveri et al.
AIAA JOURNAL (2019)
Finite Beam Elements for Variable Stiffness Structures
T. Macquart et al.
AIAA JOURNAL (2018)
A Rayleigh-Ritz approach for postbuckling analysis of variable angle tow composite stiffened panels
V. Oliveri et al.
COMPUTERS & STRUCTURES (2018)
Curvilinear variable stiffness 3D printing technology for improved open-hole tensile strength
Sadben Khan et al.
ADDITIVE MANUFACTURING (2018)
Stress calculation and optimization in composite plates with holes based on the modified integral equation method
Olesya Maksymovych et al.
ENGINEERING ANALYSIS WITH BOUNDARY ELEMENTS (2017)
Stiffness tailoring of elliptical composite cylinders for axial buckling performance
Mohammad Rouhi et al.
COMPOSITE STRUCTURES (2016)
A review on the mechanical behaviour of curvilinear fibre composite laminated panels
Pedro Ribeiro et al.
JOURNAL OF COMPOSITE MATERIALS (2014)
Continuous tow shearing for manufacturing variable angle tow composites
Byung Chul Kim et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2012)
Local compliance, stress concentrations and strength in orthotropic materials
Juhun Rhee et al.
JOURNAL OF STRAIN ANALYSIS FOR ENGINEERING DESIGN (2012)
On the stress concentration around a hole in an infinite plate subject to a uniform load at infinity
Milan Batista
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2011)
Tailoring for strength of composite steered-fibre panels with cutouts
C. S. Lopes et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2010)
Buckling of tension-loaded thin-walled composite plates with cut-outs
T. Kremer et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2008)
Postbuckling analysis with progressive damage modeling in tailored laminated plates and shells with a cutout
D Xie et al.
COMPOSITE STRUCTURES (2003)
Optimising the four-arc approximation to ellipses
WH Qian et al.
COMPUTER AIDED GEOMETRIC DESIGN (2001)
A general solution for stresses around holes in symmetric laminates under inplane loading
VG Ukadgaonker et al.
COMPOSITE STRUCTURES (2000)
On the design, manufacture and testing of trajectorial fibre steering for carbon fibre composite laminates
MW Tosh et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2000)
Share Paper
