Related references
Note: Only part of the references are listed.Determination of parameters of free volume model for Zr-based BMG via nanoindentation
Jungmoo Han et al.
INTERMETALLICS (2021)
Nanoindentation of zirconium based bulk metallic glass and its nanomechanical properties
Karuppasamy Pandian Marimuthu et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)
Thin film metallic glasses: Properties, applications and future
Pakman Yiu et al.
JOURNAL OF APPLIED PHYSICS (2020)
Effect of free-volume holes on static mechanical properties of epoxy resins studied by positron annihilation and PVT experiments
H. J. Zhang et al.
POLYMER (2020)
Mechanical properties of low-temperature gaseous carburizated layer in 316L stainless steel based on nano-indentation and four-point bending tests
Yong Jiang et al.
SURFACE & COATINGS TECHNOLOGY (2020)
Structural and Micromechanical Properties of Nd:YAG Laser Marking Stainless Steel (AISI 304 and AISI 316)
Piotr Dywel et al.
MATERIALS (2020)
Metallic glass coating for improving diamond dicing performance
Jinn P. Chu et al.
SCIENTIFIC REPORTS (2020)
Thickness effects on microstructure, mechanical and soft magnetic properties of sputtered Fe-Zr thin film metallic glass
Abdur Rauf et al.
JOURNAL OF NON-CRYSTALLINE SOLIDS (2019)
Nanoscratch Behavior of Metallic Glass/Crystalline Nanolayered Composites
Mohammad Abboud et al.
JOM (2019)
Nanoindentation near the edge of a viscoelastic solid with a rough surface
Naoki Fujisawa et al.
MATERIALS & DESIGN (2019)
Promising Ta-Ti-Zr-Si metallic glass coating without cytotoxic elements for bio-implant applications
J. J. Lai et al.
APPLIED SURFACE SCIENCE (2018)
Thickness dependent structural evolution in Mg-Zn-Ca thin film metallic glasses
Jian Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2018)
Indentation size effects of mechanical behavior and shear transformation zone in thin film metallic glasses
C. Wang et al.
THIN SOLID FILMS (2018)
Scratch-tip-size effect and change of friction coefficient in nano/micro scratch tests using XFEM
Kwangmin Lee et al.
TRIBOLOGY INTERNATIONAL (2018)
Co-based amorphous thin films on silicon with soft magnetic properties
Ansar Masood et al.
AIP ADVANCES (2018)
Mechanisms for the free volume tuning the mechanical properties of metallic glass through ion irradiation
Y. H. Qiu et al.
INTERMETALLICS (2018)
Growth mode transition in Au-based thin film metallic glasses
P. Denis et al.
THIN SOLID FILMS (2018)
Free volume gradient effect on shear banding behavior in CuZr/CuZr multilayers
C. F. Ma et al.
THIN SOLID FILMS (2018)
ZrCuFeAlAg thin film metallic glass for potential dental applications
Chu-Ning Cai et al.
INTERMETALLICS (2017)
Serrated flow of CuZr-based bulk metallic glasses probed by nanoindentation: Role of the activation barrier, size and distribution of shear transformation zones
R. Limbach et al.
JOURNAL OF NON-CRYSTALLINE SOLIDS (2017)
Influence of thin-film metallic glass coating on fatigue behavior of bulk metallic glass: Experiments and finite element modeling
Chia-Chi Yu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
The effects of tip sharpness and coating thickness on nanoindentation measurements in hard coatings on softer substrates by FEM
Frantisek Lofaj et al.
THIN SOLID FILMS (2017)
Determination of critical cooling rates in metallic glass forming alloy libraries through laser spike annealing
Punnathat Bordeenithikasem et al.
SCIENTIFIC REPORTS (2017)
Modification of the Ti40Cu36Zr10Pd14 BMG Crystallization Mechanism with Heating Rates 10-140 K/min
T. Czeppe et al.
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2016)
Hertzian load-displacement relation holds for spherical indentation on soft elastic solids undergoing large deformations
Chen-En Wu et al.
TRIBOLOGY INTERNATIONAL (2016)
Non-stick syringe needles: Beneficial effects of thin film metallic glass coating
Jinn P. Chu et al.
SCIENTIFIC REPORTS (2016)
Examination of Berkovich indenter tip bluntness
Jaroslav Cech et al.
MATERIALS & DESIGN (2016)
Extrinsic mechanical size effects in thin ZrNi metallic glass films
M. Ghidelli et al.
ACTA MATERIALIA (2015)
Biocompatibility evaluation of sputtered zirconium-based thin film metallic glass-coated steels
Balasubramanian Subramanian et al.
International Journal of Nanomedicine (2015)
Enhancement of mechanical and thermal properties in Zr-Cu-Ni-Al-N thin film metallic glass by compositional control of nitrogen
Joseph Lee et al.
MATERIALS LETTERS (2015)
Annealing-induced indentation recovery in thin film metallic glasses: Effects of indenter tip geometry, film thickness and film composition
Alemu Tesfaye Negussie et al.
SURFACE & COATINGS TECHNOLOGY (2015)
Exploring the mechanical size effects in Zr65Ni35 thin film metallic glasses
Matteo Ghidelli et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2014)
Serrated flow behaviors of a Zr-based bulk metallic glass by nanoindentation
L. Cheng et al.
JOURNAL OF APPLIED PHYSICS (2014)
On the mechanism of deformation and failure in bulk metallic glasses
J. C. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Thin-film metallic glasses for substrate fatigue-property improvements
Haoling Jia et al.
THIN SOLID FILMS (2014)
Bulk metallic glass composite with good tensile ductility, high strength and large elastic strain limit
Fu-Fa Wu et al.
SCIENTIFIC REPORTS (2014)
Tribological studies of a Zr-based bulk metallic glass
Hong Wu et al.
INTERMETALLICS (2013)
Mechanical properties study of a magnetron-sputtered Zr-based thin film metallic glass
Ching-Yen Chuang et al.
SURFACE & COATINGS TECHNOLOGY (2013)
Determination of the mechanical properties of amorphous materials through instrumented nanoindentation
M. Rodriguez et al.
ACTA MATERIALIA (2012)
Hardness, yield strength, and plastic flow in thin film metallic-glass
J. C. Ye et al.
JOURNAL OF APPLIED PHYSICS (2012)
Enhanced ductility in a Zr65Cu15Al10Ni10 bulk metallic glass by nanocrystallization during compression
Feng Qiu et al.
MATERIALS & DESIGN (2012)
Interface Constraints on Shear Band Patterns in Bonded Metallic Glass Films Under Microindentation
Z. N. An et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2012)
Effect of cooling rate on plastic deformation of Zr-based bulk metallic glasses
Chunyan Li et al.
PROGRESS IN NATURAL SCIENCE-MATERIALS INTERNATIONAL (2012)
Effects of Ni addition on the glass-forming ability, mechanical properties and corrosion resistance of Zr-Cu-Al bulk metallic glasses
Y. H. Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
The equivalent axisymmetric model for Berkovich indenters in power-law hardening materials
Z. Shi et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2010)
Geometry and bluntness tip effects on elastic-plastic behaviour during nanoindentation of fused silica: experimental and FE simulation
D. Torres-Torres et al.
MODELLING AND SIMULATION IN MATERIALS SCIENCE AND ENGINEERING (2010)
Structural relaxation and nanoindentation response in Zr-Cu-Ti amorphous thin films
H. S. Chou et al.
APPLIED PHYSICS LETTERS (2008)
Indentation and scratching mechanisms of a ZrCuAlNi bulk metallic glass
V. Keryvin et al.
JOURNAL OF PHYSICS D-APPLIED PHYSICS (2008)
Nanoindentation studies of Zr-based bulk metallic glasses
D. Drozdz et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2007)
Finite element analysis on nanoindentation with friction contact at the film/substrate interface
Xiaoqin Huang et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2007)
The h-p-r-refinement finite element analysis of a planar high-speed four-bar mechanism
YL Kuo et al.
MECHANISM AND MACHINE THEORY (2006)
Mechanical behavior of Zr65Al10Ni10Cu15 and Zr52.5Al10Ni10Cu15Be12.5 bulk metallic glasses
WH Li et al.
MATERIALS TRANSACTIONS (2005)
Investigation of the mechanical properties of thin films by nanoindentation, considering the effects of thickness and different coating-substrate combinations
SH Chen et al.
SURFACE & COATINGS TECHNOLOGY (2005)
Effect of penetration depth on indentation response of soft coatings on hard substrates: a finite element analysis
N Panich et al.
SURFACE & COATINGS TECHNOLOGY (2004)
Scaling, dimensional analysis, and indentation measurements
YT Cheng et al.
MATERIALS SCIENCE & ENGINEERING R-REPORTS (2004)
Effects of the substrate on the determination of thin film mechanical properties by nanoindentation
R Saha et al.
ACTA MATERIALIA (2002)
Share Paper
