Related references
Note: Only part of the references are listed.Environmental and economic perspective of waste-derived activators on alkali-activated mortars
Mariam Abdulkareem et al.
JOURNAL OF CLEANER PRODUCTION (2021)
Technological performance of acai natural fibre reinforced cement-based mortars
Afonso R. G. de Azevedo et al.
JOURNAL OF BUILDING ENGINEERING (2021)
Slag uses in making an ecofriendly and sustainable concrete: A review
Mugahed Amran et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Diphasic investigation of the visco-elastoplastic characteristics of highly flowable fine mortars
Masoud Hosseinpoor et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Rubberized alkali-activated slag mortar reinforced with polypropylene fibres for application in lightweight thermal insulating materials
Shahin Rajaei et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Optimization of mix proportion of alkali-activated slag mortars prepared with seawater and coral sand
Bai Zhang et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Rheology, Hydration, and Microstructure of Portland Cement Pastes Produced with Ground Acai Fibers
Afonso Azevedo et al.
APPLIED SCIENCES-BASEL (2021)
Durability and service life analysis of metakaolin-based geopolymer concretes with respect to chloride penetration using chloride migration test and corrosion potential
Nilson S. Amorim Junior et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Performance of geopolymer tiles in high temperature and saturation conditions
Markssuel T. Marvila et al.
CONSTRUCTION AND BUILDING MATERIALS (2021)
Study of Pathologies in Alkali-Activated Materials Based on Slag
M. T. Marvila et al.
CHARACTERIZATION OF MINERALS, METALS, AND MATERIALS 2021 (2021)
Alkali-Activated Adsorbents from Slags: Column Adsorption and Regeneration Study for Nickel(II) Removal
Elavarasi Sundhararasu et al.
CHEMENGINEERING (2021)
Eco-friendly mortars with addition of ornamental stone waste - A mathematical model approach for granulometric optimization
Lucas Fonseca Amaral et al.
JOURNAL OF CLEANER PRODUCTION (2020)
Technological and environmental comparative of the processing of primary sludge waste from paper industry for mortar
Afonso Rangel Garcez de Azevedo et al.
JOURNAL OF CLEANER PRODUCTION (2020)
Metakaolin-based geopolymers: Relation between formulation, physicochemical properties and efflorescence formation
Marlon A. Longhi et al.
COMPOSITES PART B-ENGINEERING (2020)
Development of mortar for laying and coating with pineapple fibers
Afonso R. Azevedo et al.
REVISTA BRASILEIRA DE ENGENHARIA AGRICOLA E AMBIENTAL (2020)
Resistance of fly ash based geopolymer mortar to both chemicals and high thermal cycles simultaneously
Sukanta Kumer Shill et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Minimization of the Influence of Shear-Induced Particle Migration in Determining the Rheological Characteristics of Self-Compacting Mortars and Concretes
Christian Baumert et al.
MATERIALS (2020)
Fracture Properties Evaluation of Cellulose Nanocrystals Cement Paste
SeyedAli Ghahari et al.
MATERIALS (2020)
Potential use of ceramic waste as precursor in the geopolymerization reaction for the production of ceramic roof tiles
A. R. G. Azevedo et al.
JOURNAL OF BUILDING ENGINEERING (2020)
Gypsum plaster using rock waste: A proposal to repair the renderings of historical buildings in Brazil
Markssuel T. Marvila et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Hydration kinetics and products of MgO-activated blast furnace slag
Solmoi Park et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
The influence of nano-additives in strengthening mechanical performance of 3D printed multi-binder geopolymer composites
Mehdi Chougan et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Use of glass polishing waste in the development of ecological ceramic roof tiles by the geopolymerization process
Afonso R. G. de Azevedo et al.
INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY (2020)
Experimental study on full-volume fly ash geopolymer mortars: Sintered fly ash versus sand as fine aggregates
Lan-Ping Qian et al.
JOURNAL OF CLEANER PRODUCTION (2020)
3D extrusion free forming of geopolymer composites: Materials modification and processing optimization
Chenchen Sun et al.
JOURNAL OF CLEANER PRODUCTION (2020)
Effect of porcelain tile polishing residue on eco-efficient geopolymer: Rheological performance of pastes and mortars
Giovanny A. Ramos et al.
JOURNAL OF BUILDING ENGINEERING (2020)
One-part blast furnace slag mortars activated with almond-shell biomass ash: A new 100% waste-based material
Lourdes Soriano et al.
MATERIALS LETTERS (2020)
Rheology behavior of one-part alkali activated slag/glass powder (AASG) pastes
Long Li et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Effect of Partial Replacement of Ground Granulated Blast Furnace Slag with Sugarcane Bagasse Ash as Source Material in the Production of Geopolymer Concrete
Parthiban Kathirvel et al.
MATERIALS SCIENCE-MEDZIAGOTYRA (2020)
Influence of different admixtures on the mechanical and durability properties of one-part alkali-activated mortars
Muhammad Riaz Ahmad et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Durability of coating mortars containing acai fibers
Markssuel T. Marvila et al.
CASE STUDIES IN CONSTRUCTION MATERIALS (2020)
ASR expansion of alkali-activated cement glass aggregate mortars
Pingping He et al.
CONSTRUCTION AND BUILDING MATERIALS (2020)
Study of the Compressive Strength of Mortars as a Function of Material Composition, Workability, and Specimen Geometry
M. T. Marvila et al.
MODELLING AND SIMULATION IN ENGINEERING (2020)
Influence of the alkaline solution and temperature on the rheology and reactivity of alkali-activated fly ash pastes
M. Palacios et al.
CEMENT & CONCRETE COMPOSITES (2019)
A porous gradient geopolymer-based tube membrane with high PM removal rate for air pollution
Jie-ting Wang et al.
JOURNAL OF CLEANER PRODUCTION (2019)
Evaluation of the use of marble waste in hydrated lime cement mortar based
Markssuel Teixeira Marvila et al.
JOURNAL OF MATERIAL CYCLES AND WASTE MANAGEMENT (2019)
Evaluation of roughcast on the adhesion mechanisms of mortars on ceramic substrates
Euzebio Bernabe Zanelato et al.
MATERIALS AND STRUCTURES (2019)
Effect of Granite Residue Incorporation on the Behavior of Mortars
Afonso Rangel Garcez de Azevedo et al.
MATERIALS (2019)
Comparative study of geopolymer and alkali activated slag concrete comprising waste foundry sand
Bavita Bhardwaj et al.
CONSTRUCTION AND BUILDING MATERIALS (2019)
Optimum mix design of geopolymer pastes and concretes cured in ambient condition based on compressive strength, setting time and workability
Muhammad N. S. Hadi et al.
JOURNAL OF BUILDING ENGINEERING (2019)
Correlation between the properties of structural clay blocks obtained by destructive tests and Ultrasonic Pulse Tests
M. T. Marvila et al.
JOURNAL OF BUILDING ENGINEERING (2019)
Study on the replacement of the hydrated lime by kaolinitic clay in mortars
M. T. Marvila et al.
ADVANCES IN APPLIED CERAMICS (2019)
Squeeze flow coupled with dynamic pressure mapping for the rheological evaluation of cement-based mortars
Franco A. Grandes et al.
CEMENT & CONCRETE COMPOSITES (2018)
Efflorescence and subflorescence induced microstructural and mechanical evolution in fly ash-based geopolymers
Zuhua Zhang et al.
CEMENT & CONCRETE COMPOSITES (2018)
Influence of the viscosity of the alkaline activator solution on the workability of geopolymer mortars
Alexandre Magno Alves de Oliveira et al.
MATERIA-RIO DE JANEIRO (2018)
Influence of sintering temperature of a ceramic substrate in mortar adhesion for civil construction
A. R. G. Azevedo et al.
JOURNAL OF BUILDING ENGINEERING (2018)
Effect of sodium hydroxide and sodium silicate solutions on strengths of alkali activated high calcium fly ash containing Portland cement
Tanakorn Phoo-ngernkham et al.
KSCE JOURNAL OF CIVIL ENGINEERING (2017)
Influence of production on the strength, density and water absorption of aerated geopolymer paste and mortar using Class F fly ash
E. Muthu Kumar et al.
CONSTRUCTION AND BUILDING MATERIALS (2017)
Preparation and tests for workability, compressive and bond strength of ultra-fine slag based geopolymer as concrete repairing agent
Sulaem Musaddiq Laskar et al.
CONSTRUCTION AND BUILDING MATERIALS (2017)
Alkali-activated mortars: Workability and rheological behaviour
M. M. Alonso et al.
CONSTRUCTION AND BUILDING MATERIALS (2017)
Influence of incorporation of glass waste on the rheological properties of adhesive mortar
Afonso Rangel Garcez de Azevedo et al.
CONSTRUCTION AND BUILDING MATERIALS (2017)
Phillipsite and Al-tobermorite mineral cements produced through low-temperature water-rock reactions in Roman marine concrete
Marie D. Jackson et al.
AMERICAN MINERALOGIST (2017)
Effect of superplasticiser on workability enhancement of Class F and Class C fly ash-based geopolymers
Jiting Xie et al.
CONSTRUCTION AND BUILDING MATERIALS (2016)
Study on engineering properties of alkali-activated ladle furnace slag geopolymer
Wei-Chien Wang et al.
CONSTRUCTION AND BUILDING MATERIALS (2016)
Parallel-plate rotational rheometry of cement paste: Influence of the squeeze velocity during gap positioning
Fbio A. Cardoso et al.
CEMENT AND CONCRETE RESEARCH (2015)
Geopolymers and Related Alkali-Activated Materials
John L. Provis et al.
ANNUAL REVIEW OF MATERIALS RESEARCH, VOL 44 (2014)
Gel nanostructure in alkali-activated binders based on slag and fly ash, and effects of accelerated carbonation
Susan A. Bernal et al.
CEMENT AND CONCRETE RESEARCH (2013)
Mix design and fresh properties for high-performance printing concrete
T. T. Le et al.
MATERIALS AND STRUCTURES (2012)
Mechanical properties, drying and autogenous shrinkage of blast furnace slag activated with hydrated lime and gypsum
Antonio A. Melo Neto et al.
CEMENT & CONCRETE COMPOSITES (2010)
Rheological behavior of mortars under different squeezing rates
Fabio A. Cardoso et al.
CEMENT AND CONCRETE RESEARCH (2009)
Water retention properties of porous geopolymers for use in cooling applications
Kiyoshi Okada et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)
Drying and autogenous shrinkage of pastes and mortars with activated slag cement
Antonio A. Melo Neto et al.
CEMENT AND CONCRETE RESEARCH (2008)
Share Paper
