Related references
Note: Only part of the references are listed.Effect of heat treatment on the grain size control, superplasticity, internal friction, and mechanical properties of zirconium-bearing aluminum-based alloy
A. G. Mochugovskiy et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2021)
Superplastic deformation mechanisms of an Al-Mg-Li alloy with banded microstructures
Xiaodong Liu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2021)
Understanding the formation of (Al,Si)3Sc and V-phase (AlSc2Si2) in Al-Si-Sc alloys via ex situ heat treatments and in situ transmission electron microscopy studies
Jayshri Dumbre et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2021)
Surface and internal structural markers for studying grain boundary sliding and grain rotation
Olga Yakovtseva et al.
MATERIALS LETTERS (2020)
The study of flow behavior and governing mechanisms of a titanium alloy during superplastic forming
Tabassam Yasmeen et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Experimental study of the superplastic deformation mechanisms of high-strength aluminum-based alloy
O. A. Yakovtseva et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Observation of low temperature superplasticity in an ultrafine grained AA6063 alloy
H. R. Jafarian et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
EBSD study of superplastically strained Al-Mg-Li alloy
M. Myshlyaev et al.
MATERIALS LETTERS (2020)
Comparison of precipitation kinetics and mechanical properties in Zr and Sc-bearing aluminum-based alloys
A. G. Mochugovskiy et al.
MATERIALS LETTERS (2020)
Precipitation behavior and high strain rate superplasticity in a novel fine-grained aluminum based alloy
A. V. Mikhaylovskaya et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
New in-situ Al matrix composites based on Al-Ni-La eutectic
T. K. Akopyan et al.
MATERIALS LETTERS (2019)
Microstructure, mechanical properties and superplasticity of the Al-Cu-Y-Zr alloy
A. Pozdniakov et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Ambient- and elevated-temperature strengthening by Al3Zr-Nanoprecipitates and Al3Ni-Microfibers in a cast Al-2.9Ni-0.11Zr-0.02Si-0.005Er (at.%) alloy
Richard A. Michi et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Micro-segregation and precipitates in as-solidified Al-Sc-Zr-(Mg)-(Si)-(Cu) alloys
T. Dorin et al.
MATERIALS CHARACTERIZATION (2019)
The effect of ultrafine-grained states on superplastic behavior of Al-Mg-Si alloy
Elena Bobruk et al.
MATERIALS LETTERS (2019)
The mechanism of L12 phase precipitation, microstructure and tensile properties of Al-Mg-Er-Zr alloy
Andrey G. Mochugovskiy et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Strengthening mechanisms in Al-Ni-Sc alloys containing Al3Ni microfibers and Al3Sc nanoprecipitates
C. Suwanpreecha et al.
ACTA MATERIALIA (2019)
Effect of Modes of Heterogenizing Annealing Before Cold Rolling on the Structure and Properties of Sheets from Alloy 1565ch
M. S. Kishchik et al.
METAL SCIENCE AND HEAT TREATMENT (2019)
Si poisoning and promotion on the microstructure and mechanical properties of Al-Si-Mg cast alloys
Xixi Dong et al.
JOURNAL OF MATERIALS SCIENCE (2018)
Precipitation behavior of L12 Al3Zr phase in Al-Mg-Zr alloy
A. V. Mikhaylovskaya et al.
MATERIALS CHARACTERIZATION (2018)
Intermetallic phase evolution and strengthening effect in Al-Mg2Si alloys with different Cu/Ni ratios
Yilin Sun et al.
MATERIALS LETTERS (2018)
Al-Mg-Fe-Ni based alloy for high strain rate superplastic forming
A. A. Kishchik et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
A Review on Superplastic Formation Behavior of Al Alloys
Xiao-guo Wang et al.
ADVANCES IN MATERIALS SCIENCE AND ENGINEERING (2018)
Excess solvent in precipitates
Emmanuel Clouet
NATURE MATERIALS (2018)
Superplasticity of clad aluminium alloy
A. V. Mikhaylovskaya et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2017)
High strain rate superplasticity in an Al-Mg-Sc-Zr alloy processed via simple rolling
Mengjia Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Effect of Sc and Zr additions on the microstructure/strength of Al-Cu binary alloys
Thomas Dorin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Effect of Low Additions of Y, Sm, Gd, Hf and Er on the Structure and Hardness of Alloy Al-0.2% Zr-0.1% Sc
A. V. Pozdnyakov et al.
METAL SCIENCE AND HEAT TREATMENT (2017)
Superplasticity of high-strength Al-based alloys produced by thermomechanical treatment
A. D. Kotov et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
Superplasticity behaviors of Al-Zn-Mg-Zr cold-rolled alloy sheet with minor Sc addition
H. Xiang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Superplastic behaviour of Al-Mg-Zn-Zr-Sc-based alloys at high strain rates
A. V. Mikhaylovskaya et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Effect of homogenisation treatment on precipitation, recrystallisation and properties of Al-3% Mg - TM alloys (TM = Mn, Cr, Zr)
A. V. Mikhaylovskaya et al.
MATERIALS & DESIGN (2016)
Effects of two-step homogenization on precipitation behavior of Al3Zr dispersoids and recrystallization resistance in 7150 aluminum alloy
Zhanying Guo et al.
MATERIALS CHARACTERIZATION (2015)
Precipitation behavior of strip cast Al-Mg-0.4Sc-0.15Zr alloy under single and multiple-stage aging processes
S. H. Mousavi Anijdan et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Development of Ultrafine-Grained Al-Mg-Si Alloy Through SPD Processing
Maruff Hussain et al.
METALLOGRAPHY MICROSTRUCTURE AND ANALYSIS (2015)
Improving aging and creep resistance in a dilute Al-Sc alloy by microalloying with Si, Zr and Er
N. Q. Vo et al.
ACTA MATERIALIA (2014)
A high-strength aluminium-based alloy with advanced superplasticity
A. V. Mikhaylovskaya et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2014)
Precipitation evolution in Al-Er-Zr alloys during aging at elevated temperature
S. P. Wen et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2013)
The influence of chromium on the structure and superplasticity of Al-Mg-Mn alloys
V. K. Portnoy et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2013)
Extraordinary high-strain rate superplasticity of severely deformed Al-Mg-Sc-Zr alloy
E. Avtokratova et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
Effect of eutectic particles on the grain size control and the superplasticity of aluminium alloys
A. V. Mikhaylovskaya et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Diffusion creep and superplasticity in aluminium alloys
K. Sotoudeh et al.
ACTA MATERIALIA (2010)
Superplastic behaviour of Al-Zn-Mg-Cu-Zr alloy AA7010 containing Sc
A. Kumar et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Introduction to Grains, Phases, and Interfaces-an Interpretation of Microstructure, Trans. AIME, 1948, vol. 175, pp. 15-51, by CS Smith
Gregory S. Rohrer
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2010)
The diffraction patterns from β precipitates in 12 orientations in Al-Mg-Si alloy
Wenchao Yang et al.
SCRIPTA MATERIALIA (2010)
Superplasticity in an Al-Mg-Zr-Sc alloy produced by equal-channel angular pressing
K. Turba et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
Contribution of microstructural parameters to strengthening in an ultrafine-grained Al-7% Si alloy processed by severe deformation
I. Gutierrez-Urrutia et al.
ACTA MATERIALIA (2007)
The crystal structure of the beta ' phase in Al-Mg-Si alloys
R. Vissers et al.
ACTA MATERIALIA (2007)
Optimization of hardening of Al-Zr-Sc cast alloys
N. A. Belov et al.
JOURNAL OF MATERIALS SCIENCE (2006)
High strain rate superplasticity in an Al-Mg-Sc-Zr alloy subjected to simple thermomechanical processing
R Kaibyshev et al.
SCRIPTA MATERIALIA (2006)
Study of artificial aging in AlMgSi (6061) and AlMgSiCu (6013) alloys by positron annihilation
TEM Staab et al.
JOURNAL OF MATERIALS SCIENCE (2006)
Temporal evolution of the nanostructure of AI(Sc,Zr) alloys:: Part I -: Chemical compositions of Al3(Sc1-xZrx) precipitatesy
CB Fuller et al.
ACTA MATERIALIA (2005)
Influence of grain size on deformation mechanisms: An extension to nanocrystalline materials
YT Zhu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2005)
Effects of Ti additions on the nanostructure and creep properties of precipitation-strengthened Al-Sc alloys
ME van Dalen et al.
ACTA MATERIALIA (2005)
Microstructure and texture evolution in the tension of superplastic Al-6Cu-0.4Zr
PS Bate et al.
ACTA MATERIALIA (2005)
Segregation in Al3(Sc,Zr) precipitates in Al-Sc-Zr alloys
A Tolley et al.
SCRIPTA MATERIALIA (2005)
Improving the properties of cold-rolled Al-6%Ni sheets by alloying and heat treatment
NA Belov et al.
SCRIPTA MATERIALIA (2004)
Phase relations and precipitation in Al-Mg-Si alloys with Cu additions
DJ Chakrabarti et al.
PROGRESS IN MATERIALS SCIENCE (2004)
Precipitation strengthening at ambient and elevated temperatures of heat-treatable Al(Sc) alloys
DN Seidman et al.
ACTA MATERIALIA (2002)
Influence of scandium and zirconium on grain stability and superplastic ductilities in ultrafine-grained Al-Mg alloys
S Lee et al.
ACTA MATERIALIA (2002)
Particle-stimulated nucleation of recrystallization for grain-size control and superplasticity in an Al-Mg-Si-Cu alloy
LP Troeger et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)
Recent development in aluminium alloys for the automotive industry
WS Miller et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)
Recent development in aluminium alloys for aerospace applications
A Heinz et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)
Effects of Cu content and preaging on precipitation characteristics in aluminum alloy 6022
WF Miao et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2000)
Microstructural and mechanical characterization of a superplastic 6xxx aluminum alloy
LP Troeger et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)
Share Paper
