Related references
Note: Only part of the references are listed.Carburization resistance of cu-coated stainless steel in supercritical carbon dioxide environments
Andrew Meyer Brittan et al.
CORROSION SCIENCE (2020)
Effects of CO and O2 Impurities on Supercritical CO2 Corrosion of Alloy 625
Jacob Mahaffey et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2018)
Corrosion of 9-12Cr ferritic-martensitic steels in high-temperature CO2
F. Rouillard et al.
CORROSION SCIENCE (2016)
Effect of Mn on oxide formation by Fe-Cr and Fe-Cr-Ni alloys in dry and wet CO2 gases at 650 °C
Thuan Dinh Nguyen et al.
CORROSION SCIENCE (2016)
Comparison of elevated temperature design codes of ASME Subsection NH and RCC-MRx
Hyeong-Yeon Lee
NUCLEAR ENGINEERING AND DESIGN (2016)
Corrosion of Alloy Haynes 230 in High Temperature Supercritical Carbon Dioxide with Oxygen Impurity Additions
Jacob Mahaffey et al.
OXIDATION OF METALS (2016)
Corrosion of engineering materials in a supercritical water cooled reactor: Characterization of oxide scales on Alloy 800H and stainless steel 316
Kashif I. Choudhry et al.
CORROSION SCIENCE (2015)
Corrosion of 316 stainless steel in high temperature molten Li2BeF4 (FLiBe) salt
Guiqiu Zheng et al.
JOURNAL OF NUCLEAR MATERIALS (2015)
Non-steady state carburisation of martensitic 9-12%Cr steels in CO2 rich gases at 550°C
D. Young et al.
CORROSION SCIENCE (2014)
Surface hardness improvement of plasma-sprayed AISI 316L stainless steel coating by low-temperature plasma carburizing
Shinichiro Adachi et al.
ADVANCED POWDER TECHNOLOGY (2013)
Corrosion of austenitic alloys in high temperature supercritical carbon dioxide
G. Cao et al.
CORROSION SCIENCE (2012)
Effect of laser shot peening without coating on the surface properties and corrosion behavior of 316L steel
S. Kalainathan et al.
OPTICS AND LASERS IN ENGINEERING (2012)
Corrosion of 9Cr Steel in CO2 at Intermediate Temperature I: Mechanism of Void-Induced Duplex Oxide Formation
F. Rouillard et al.
OXIDATION OF METALS (2012)
Corrosion of 9Cr Steel in CO2 at Intermediate Temperature II: Mechanism of Carburization
F. Rouillard et al.
OXIDATION OF METALS (2012)
Oxidation of 316 stainless steel in supercritical water
Mingcheng Sun et al.
CORROSION SCIENCE (2009)
Measurement of mechanical properties in a 316L stainless steel welded joint
Rafal M. Molak et al.
INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING (2009)
Austenite-preferential corrosion attack in 316 austenitic stainless steel weld metals
Y. Cui et al.
MATERIALS & DESIGN (2007)
Comparative study on sigma phase precipitation of three types of stainless steels: austenitic, superferritic and duplex
D. M. E. Villanueva et al.
MATERIALS SCIENCE AND TECHNOLOGY (2006)
Influence of carbide precipitation and rolling direction on intergranular stress corrosion cracking of austenitic stainless steels in hydrogenated high-temperature water
K. Arioka et al.
CORROSION (2006)
Sensitization evaluation of the austenitic stainless steel AISI 304L, 316L, 321 and 347
AS Lima et al.
JOURNAL OF MATERIALS SCIENCE (2005)
Medium temperature carbon dioxide gas turbine reactor
Y Kato et al.
NUCLEAR ENGINEERING AND DESIGN (2004)
Share Paper
