Related references
Note: Only part of the references are listed.The effects of heat treatment on the response of WE43 Mg alloy: crystal plasticity finite element simulation and SEM-DIC experiment
Sriram Ganesan et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2021)
Characterizing microscale deformation mechanisms and macroscopic tensile properties of a high strength magnesium rare-earth alloy: A combined experimental and crystal plasticity approach
A. Githens et al.
ACTA MATERIALIA (2020)
Polycrystalline Microstructure Reconstruction Using Markov Random Fields and Histogram Matching
Iman Javaheri et al.
COMPUTER-AIDED DESIGN (2020)
Reconstruction methods and analysis of subsurface uncertainty for anisotropic microstructures
Andrea Nicolas et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
PRISMS-Plasticity: An open-source crystal plasticity finite element software
Mohammadreza Yaghoobi et al.
COMPUTATIONAL MATERIALS SCIENCE (2019)
Deformation behavior of β′ and β′ precipitates in Mg-RE alloys
Ellen L. S. Solomon et al.
MATERIALS LETTERS (2018)
Generation of 3D representative volume elements for heterogeneous materials: A review
Swantje Bargmann et al.
PROGRESS IN MATERIALS SCIENCE (2018)
Uncertainty quantification of microstructural properties due to variability in measured pole figures
Pinar Acar et al.
ACTA MATERIALIA (2017)
Characterization and reconstruction of 3D stochastic microstructures via supervised learning
R. Bostanabad et al.
JOURNAL OF MICROSCOPY (2016)
Three-dimensional morphological modelling of concrete using multiscale Poisson polyhedra
J. Escoda et al.
JOURNAL OF MICROSCOPY (2015)
Three dimensional modeling of complex heterogeneous materials via statistical microstructural descriptors
Yang Jiao et al.
INTEGRATING MATERIALS AND MANUFACTURING INNOVATION (2014)
DREAM. 3D: A Digital Representation Environment for the Analysis of Microstructure in 3D
Michael A. Groeber et al.
INTEGRATING MATERIALS AND MANUFACTURING INNOVATION (2014)
Digital Image Correlation under Scanning Electron Microscopy: Methodology and Validation
A. D. Kammers et al.
EXPERIMENTAL MECHANICS (2013)
Large-scale 3D random polycrystals for the finite element method: Generation, meshing and remeshing
R. Quey et al.
COMPUTER METHODS IN APPLIED MECHANICS AND ENGINEERING (2011)
Orientation image-based micromechanical modelling of subgrain texture evolution in polycrystalline copper
Ricardo A. Lebensohn et al.
ACTA MATERIALIA (2008)
Scanning electron microscopy for quantitative small and large deformation measurements part i: SEM imaging at magnifications from 200 to 10,000
M. A. Sutton et al.
EXPERIMENTAL MECHANICS (2007)
Ensemble averaging stress-strain fields in polycrystalline aggregates with a constrained surface microstructure - Part 2: crystal plasticity
A. Zeghad et al.
PHILOSOPHICAL MAGAZINE (2007)
Grain size and grain shape analysis of fault rocks
Renee Heilbronner et al.
TECTONOPHYSICS (2006)
3D reconstruction of microstructure in a commercial purity aluminum
A. Brahme et al.
SCRIPTA MATERIALIA (2006)
Inverting dirichlet tessellations
FP Schoenberg et al.
COMPUTER JOURNAL (2003)
Evolution of grain-scale microstructure during large strain simple compression of polycrystalline aluminum with quasi-columnar grains: OIM measurements and numerical simulations
A Bhattacharyya et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2001)
Share Paper
