Related references
Note: Only part of the references are listed.Fracture Strength Behaviors of Ultra-High-Temperature Materials
Tianbao Cheng et al.
JOURNAL OF APPLIED MECHANICS-TRANSACTIONS OF THE ASME (2020)
Tensile properties of two-dimensional carbon fiber reinforced silicon carbide composites at temperatures up to 2300 °C
Tianbao Cheng et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2020)
Understanding the ultra-high-temperature mechanical behaviors of advanced two-dimensional carbon-carbon composites
Tianbao Cheng
CERAMICS INTERNATIONAL (2020)
Flexural properties of carbon-carbon composites at temperatures up to 2600 °C
Tianbao Cheng et al.
MATERIALS RESEARCH EXPRESS (2019)
Tensile properties of two-dimensional carbon fiber reinforced silicon carbide composites at temperatures up to 1800 °C in air
Tianbao Cheng et al.
EXTREME MECHANICS LETTERS (2019)
Compressive strength and damage mechanisms of 2D-C/SiC composites at high temperatures
Lihua Li et al.
CERAMICS INTERNATIONAL (2018)
Carbon fiber reinforced silicon carbide composite-based sharp leading edges in high enthalpy plasma flows
Lei Luo et al.
COMPOSITES PART B-ENGINEERING (2018)
Fracture behavior of C/SiC composites at elevated temperature
Dong Hyun Yoon et al.
JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY (2017)
The temperature-dependent surface energy of ceramic single crystals
Tianbao Cheng et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2017)
Microstructure and high-temperature strength of silicon carbide with 2000 ppm yttria
Young-Wook Kim et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)
Tensile behavior of 2D-C/SiC composites at elevated temperatures: Experiment and modeling
C. -P. Yang et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)
An investigation of dynamic failure progress and properties of 2D C/SiC composite from 173 K to 1273 K by SHTB
Xuan Chen et al.
COMPOSITES PART B-ENGINEERING (2017)
Ablation behavior of C/SiC composites in plasma wind tunnel
Lei Luo et al.
CARBON (2016)
The dynamic tensile properties of 2D-C/SiC composites at elevated temperatures
Xuan Chen et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2015)
The direct uniaxial tensile strength of chemical vapor deposited zinc sulfide from room temperature to 600 °C
Tianbao Cheng et al.
MATERIALS LETTERS (2015)
High-temperature flexural properties of SiBC modified C/SiC composites
Xiaoyu Cao et al.
CERAMICS INTERNATIONAL (2014)
Compressive behavior of C/SiC composites over a wide range of strain rates and temperatures
Tao Suo et al.
CARBON (2013)
Increasing the strength and toughness of a carbon fiber/silicon carbide composite by heat treatment
Hui Mei et al.
CARBON (2013)
Temperature dependency of interlaminar shear strength of 2D-C/SiC composite
H. L. Wang et al.
MATERIALS & DESIGN (2012)
Failure and strength of 2D-C/SiC composite under in-plane shear loading at elevated temperatures
K. F. Yan et al.
MATERIALS & DESIGN (2011)
Comparison of the mechanical hysteresis of carbon/ceramic-matrix composites with different fiber preforms
Hui Mei et al.
CARBON (2009)
Transverse and longitudinal coefficient of thermal expansion of carbon fibers at high temperatures (300-2500 K)
C. Pradere et al.
CARBON (2008)
Measurement and calculation of thermal residual stress in fiber reinforced ceramic matrix composites
Hui Mei
COMPOSITES SCIENCE AND TECHNOLOGY (2008)
Handbook of SiC properties for fuel performance modeling
Lance L. Snead et al.
JOURNAL OF NUCLEAR MATERIALS (2007)
Effects of frequency on fatigue behavior of CVIC/SiC at elevated temperature
S Mall et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2006)
The tensile behavior of carbon fibers at high temperatures up to 2400 degrees C
C Sauder et al.
CARBON (2004)
Weibull strength scaling for standardized rectangular flexure specimens
GD Quinn
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2003)
Thermomechanical properties of carbon fibres at high temperatures (up to 2000 degrees C)
C Sauder et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2002)
Share Paper
