4.7 Article

Investigations on hydrogen storage performances and mechanisms of as-cast TiFe0.8-mNi0.2Com (m=0, 0.03, 0.05 and 0.1) alloys

Related references

Note: Only part of the references are listed.
Review Chemistry, Physical

Review on effective parameters in electrochemical hydrogen storage

Tahereh Gholami et al.

Summary: This article discusses the issue of energy in developing countries, with a focus on hydrogen as a clean fuel. The electrochemical hydrogen storage method is superior to other methods in terms of cost, safety, and optimum conditions, with the use of the chronopotentiometry technique.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Chemistry, Physical

Electrochemical hydrogen-storage performance of copper sulfide micro-hexagons

Karthik S. Bhat et al.

Summary: Copper sulfide with unique micro-hexagon morphology was synthesized hydrothermally and showed promising electrochemical hydrogen storage performance. The hydrogen discharge capacity reached approximately 59.32 mAh g(-1) at a current density of 1 A g(-1) with contributions from redox processes, indicating stable cyclic retention for 2500 cycles. Various electrochemical techniques, such as cyclic voltammetry, galvanostatic charge-discharge, and impedance spectroscopy, were used for performance evaluation.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Chemistry, Physical

Studies on 10kg alloy mass metal hydride based reactor for hydrogen storage

Avik Karmakar et al.

Summary: A 10 kg alloy mass metal hydride reactor was designed with LaNi5 alloy, featuring heat transfer enhancement through embedded cooling tubes and an external water jacket. Parametric studies were conducted to optimize the system's performance, with experiments demonstrating storage capacity and desorption kinetics under various conditions.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2021)

Article Materials Science, Multidisciplinary

Effects of adding Nd on the microstructure and dehydrogenation performance of Mg90Al10 alloy

Yaqin Li et al.

Summary: The introduction of Nd into Mg90Al10 alloy was studied to enhance the dehydrogenation kinetics of Mg hydride. Increasing Nd content resulted in more hydrogenation phases of Mg and Nd, smaller grain size, and improved activation performance and dehydrogenation kinetics. Different thermodynamic stability of Mg hydride was observed in the alloys based on the phase composition and microstructure changes.

MATERIALS CHARACTERIZATION (2021)

Review Chemistry, Physical

Hydrogen storage in light-metal based systems: A review

Liuzhang Ouyang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Green & Sustainable Science & Technology

Wind energy utilization for hydrogen production in an underdeveloped country: An economic investigation

Mostafa Rezaei et al.

RENEWABLE ENERGY (2020)

Article Chemistry, Physical

Hydrogen storage properties of Nb-based solid solution alloys with a BCC structure

Kouji Sakaki et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2020)

Article Materials Science, Ceramics

Photocatalytic antibacterial properties of copper doped TiO2 prepared by high-energy ball milling

Mei Wang et al.

CERAMICS INTERNATIONAL (2020)

Review Chemistry, Physical

A review on recent advances in hollow spheres for hydrogen storage

Majid Zarezadeh Mehrizi et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2020)

Article Chemistry, Physical

Metal hydride hydrogen storage tank for light fuel cell vehicle

M. W. Davids et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Chemistry, Physical

A BCC-C14 alloy suitable for EV application of Ni/MH battery

Lingkun Kong et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Chemistry, Physical

Hydrogen storage properties of TiFe-based ternary mechanical alloys with cobalt and niobium. A thermochemical approach

E. A. Berdonosova et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Materials Science, Multidisciplinary

Outstanding shortening of the activation process stage for a TiFe-based hydrogen storage alloy

Ali Zeaiter et al.

MATERIALS RESEARCH BULLETIN (2019)

Article Chemistry, Physical

Construction and operation of hydrogen energy utilization system for a zero emission building

Naruki Endo et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Article Chemistry, Physical

Mechanochemical synthesis and hydrogenation behavior of (TiFe)100-xNix alloys

V Zadorozhnyy et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2019)

Article Chemistry, Physical

Ni/NiO@rGO as an efficient bifunctional electrocatalyst for enhanced overall water splitting reactions

Shankar S. Narwade et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2019)

Review Metallurgy & Metallurgical Engineering

Kinetics in Mg-based hydrogen storage materials: Enhancement and mechanism

Qun Luo et al.

JOURNAL OF MAGNESIUM AND ALLOYS (2019)

Article Chemistry, Physical

Catalytic roles of Sm2O3 dopants on ethylene oxide sensing mechanisms of flame-made SnO2 nanoparticles

Suparat Singkammo et al.

APPLIED SURFACE SCIENCE (2018)

Article Chemistry, Physical

Structure and hydrogenation performances of as-cast Ti1.1-xRExFe0.8Mn0.2 (RE = Pr, Sm and Nd; x=0, 0.01) alloys

Hongwei Shang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

Article Chemistry, Physical

Mechanical activation of air exposed TiFe+4 wt% Zr alloy for hydrogenation by cold rolling and ball milling

Joydev Manna et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)

Article Chemistry, Physical

Effects of Ce on the hydrogen storage properties of TiFe0.9Mn0.1 alloy

Haiyan Leng et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Chemistry, Physical

Operation of a bench-scale TiFe-based alloy tank under mild conditions for low-cost stationary hydrogen storage

Naruki Endo et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Article Chemistry, Physical

Hydrogenation properties of Ti-Fe-Mn alloy with Cu and Y as additives

Wajid Ali et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Review Chemistry, Physical

Stress/strain effects on thermodynamic properties of magnesium hydride: A brief review

J. Zhang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2017)

Review Chemistry, Physical

Application of dielectric barrier discharge plasma-assisted milling in energy storage materials - A review

Liuzhang Ouyang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2017)

Review Materials Science, Multidisciplinary

Progress of hydrogen storage alloys for Ni-MH rechargeable power batteries in electric vehicles: A review

Liuzhang Ouyang et al.

MATERIALS CHEMISTRY AND PHYSICS (2017)

Review Green & Sustainable Science & Technology

A review on the characterization of hydrogen in hydrogen storage materials

T. Y. Wei et al.

RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2017)

Article Chemistry, Physical

Development of Zr-Fe-V alloys for hybrid hydrogen storage system

Zhijie Cao et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2016)

Article Materials Science, Multidisciplinary

Co-doping TiO2 with boron and/or yttrium elements: Effects on antimicrobial activity

Yuzheng Wang et al.

MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS (2016)

Article Materials Science, Multidisciplinary

Co-doping TiO2 with boron and/or yttrium elements: Effects on antimicrobial activity

Yuzheng Wang et al.

MATERIALS SCIENCE AND ENGINEERING B-ADVANCED FUNCTIONAL SOLID-STATE MATERIALS (2016)

Article Materials Science, Multidisciplinary

Hydrogen storage performance of TiFe after processing by ball milling

Hoda Emami et al.

ACTA MATERIALIA (2015)

Article Chemistry, Physical

Advanced high-pressure metal hydride fabricated via Ti-Cr-Mn alloys for hybrid tank

Zhijie Cao et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2015)

Article Chemistry, Physical

Combustion synthesis of TiFe by utilizing magnesiothermic reduction

Masaya Deguchi et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2015)

Article Chemistry, Physical

Effect of LiH on hydrogen storage property of MgH2

Haiyan Leng et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2014)

Article Chemistry, Physical

Initial oxidation of TiFe1-xMnx (x=0-0.3) by low dose exposures to H2O and O2

A. Shwartz et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

Article Chemistry, Physical

Mechanical alloying of nanocrystalline intermetallic compound TiFe doped with sulfur and magnesium

V. Yu. Zadorozhnyy et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2014)

Article Chemistry, Physical

Excellent hydrolysis performances of Mg3RE hydrides

L. Z. Ouyang et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)

Article Chemistry, Physical

Combustion synthesis of TiFe-based hydrogen storage alloy from titanium oxide and iron

Tohru Tsuchiya et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2013)

Article Chemistry, Physical

Hydrogen storage nanocrystalline TiFe intermetallic compound: Synthesis by mechanical alloying and compacting

V. Zadorozhnyy et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2012)

Article Chemistry, Physical

Surface modification of TiFe hydrogen storage alloy by metal-organic chemical vapour deposition of palladium

Moegamat Wafeeq Davids et al.

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2011)

Article Chemistry, Physical

Hydriding combustion synthesis of TiFe

I. Saita et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2007)

Article Chemistry, Physical

Hydrogen storage properties of TixFe+y wt.% La and its use in metal hydride hydrogen compressor

Xinhua Wang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2006)

Article Nanoscience & Nanotechnology

The decomposition behavior of as-received and oxidized TiH2 foaming-agent powder

AR Kennedy et al.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2003)

Article Chemistry, Physical

Hydrogenation of TiFe by high-energy ball milling

CH Chiang et al.

JOURNAL OF ALLOYS AND COMPOUNDS (2000)