Related references
Note: Only part of the references are listed.What fuel properties enable higher thermal efficiency in spark-ignited engines?
James P. Szybist et al.
PROGRESS IN ENERGY AND COMBUSTION SCIENCE (2021)
Effect of Exhaust Gas Recirculation and NO on Ignition Delay Times of Iso-octane in a Rapid Compression Machine
Yu Song et al.
ENERGY & FUELS (2020)
Impact of engine pressure-temperature trajectory on autoignition for varying fuel properties
James P. Szybist et al.
APPLICATIONS IN ENERGY AND COMBUSTION SCIENCE (2020)
Effects of pre-spark heat release on engine knock limit
Derek A. Splitter et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)
Insights into engine autoignition: Combining engine thermodynamic trajectory and fuel ignition delay iso-contour
Mingyuan Tao et al.
COMBUSTION AND FLAME (2019)
Knock Intensity Distribution and a Stochastic Control Framework for Knock Control
Mateos Kassa et al.
JOURNAL OF DYNAMIC SYSTEMS MEASUREMENT AND CONTROL-TRANSACTIONS OF THE ASME (2019)
Autoignition behavior of a full boiling-range gasoline: Observations in RCM and GCI engine environments
Toby Rockstroh et al.
COMBUSTION AND FLAME (2019)
Detection of low Temperature heat release (LTHR) in the standard Cooperative Fuel Research (CFR) engine in both SI and HCCI combustion modes
Muhammad Umer Waqas et al.
FUEL (2019)
The impact of nitric oxide on knock in the octane rating engine
Zhongyuan Chen et al.
FUEL (2019)
Kinetic modeling study of surrogate components for gasoline, jet and diesel fuels: C7-C11 methylated aromatics
Goutham Kukkadapu et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2019)
Characterization of Low Temperature Reactions in the Standard Cooperative Fuel Research (CFR) Engine
Muhammad Umer Waqas et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2019)
Knock onset, knock intensity, superknock and preignition in spark ignition engines
Gautam Kalghatgi
INTERNATIONAL JOURNAL OF ENGINE RESEARCH (2018)
Probing the low-temperature chemistry of ethanol via the addition of dimethyl ether
Yingjia Zhang et al.
COMBUSTION AND FLAME (2018)
Experimental and modeling studies of a biofuel surrogate compound: laminar burning velocities and jet-stirred reactor measurements of anisole
Scott W. Wagnon et al.
COMBUSTION AND FLAME (2018)
Understanding chemistry-specific fuel differences at a constant RON in a boosted SI engine
James P. Szybist et al.
FUEL (2018)
Insights into Engine Knock: Comparison of Knock Metrics across Ranges of Intake Temperature and Pressure in the CFR Engine
Toby Rockstroh et al.
SAE INTERNATIONAL JOURNAL OF FUELS AND LUBRICANTS (2018)
A dual-threshold knock controller
James C. Peyton Jones et al.
INTERNATIONAL JOURNAL OF ENGINE RESEARCH (2017)
Impact of Fuel Composition and Intake Pressure on Lean Autoignition of Surrogate Gasoline Fuels in a CFR Engine
Vickey Kalaskar et al.
ENERGY & FUELS (2017)
The oxidation of 2-butene: A high pressure ignition delay, kinetic modeling study and reactivity comparison with isobutene and 1-butene
Yang Li et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)
Elucidating reactivity regimes in cyclopentane oxidation: Jet stirred reactor experiments, computational chemistry, and kinetic modeling
Mariam J. Al Rashidi et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)
Probing the antagonistic effect of toluene as a component in surrogate fuel models at low temperatures and high pressures. A case study of toluene/dimethyl ether mixtures
Yingjia Zhang et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)
Autoignition of pentane isomers in a spark-ignition engine
Song Cheng et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2017)
Impact of nitric oxide (NO) on n-heptane autoignition in a rapid compression machine
Zhongyuan Chen et al.
COMBUSTION AND FLAME (2017)
Cyclopentane combustion chemistry. Part I: Mechanism development and computational kinetics
Mariam J. Al Rashidi et al.
COMBUSTION AND FLAME (2017)
Cyclopentane combustion. Part II. Ignition delay measurements and mechanism validation
Mariam J. Al Rashidi et al.
COMBUSTION AND FLAME (2017)
Pressure and temperature effects on fuels with varying octane sensitivity at high load in SI engines
James P. Szybist et al.
COMBUSTION AND FLAME (2017)
A comprehensive iso-octane combustion model with improved thermochemistry and chemical kinetics
Nour Atef et al.
COMBUSTION AND FLAME (2017)
An ignition delay time and chemical kinetic modeling study of the pentane isomers
John Bugler et al.
COMBUSTION AND FLAME (2016)
An updated experimental and kinetic modeling study of n-heptane oxidation
Kuiwen Zhang et al.
COMBUSTION AND FLAME (2016)
Optimisation of synthetic gasoline blend recipes for use in modern charge boosted GDI engines
Toby Rockstroh et al.
FUEL (2016)
Understanding the Octane Appetite of Modern Vehicles
Arjun Prakash et al.
SAE INTERNATIONAL JOURNAL OF FUELS AND LUBRICANTS (2016)
Second Generation GDCI Multi-Cylinder Engine for High Fuel Efficiency and US Tier 3 Emissions
Mark Sellnau et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2016)
Combined Effects of Fuel and Dilution Type on Efficiency Gains of Lean Well-Mixed DISI Engine Operation with Enhanced Ignition and Intake Heating for Enabling Mixed-Mode Combustion
Magnus Sjoberg et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2016)
An experimental and kinetic modeling study of n-hexane oxidation
Kuiwen Zhang et al.
COMBUSTION AND FLAME (2015)
Faster solvers for large kinetic mechanisms using adaptive preconditioners
Matthew J. McNenly et al.
PROCEEDINGS OF THE COMBUSTION INSTITUTE (2015)
GDCI Multi-Cylinder Engine for High Fuel Efficiency and Low Emissions
Mark Sellnau et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2015)
Characterization of knock intensity distributions: Part 1: statistical independence and scalar measures
Jill M. Spelina et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2014)
Pressure Sensitivity of HCCI Auto-Ignition Temperature for Oxygenated Reference Fuels
Ida Truedsson et al.
JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME (2013)
Characterization of knock intensity distributions: Part 2: parametric models
Jill M. Spelina et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING (2013)
Steady-State Combustion Development of a Downsized Multi-Cylinder Engine with Range Extended HCCI/SACI Capability
Dusan Polovina et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2013)
Fuel Effects on Knock in a Highly Boosted Direct Injection Spark Ignition Engine
Amer Amer et al.
SAE INTERNATIONAL JOURNAL OF FUELS AND LUBRICANTS (2012)
Pressure Sensitivity of HCCI Auto-Ignition Temperature for Primary Reference Fuels
Ida Truedsson et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2012)
An Evaluation of Different Combustion Strategies for SI Engines in a Multi-Mode Combustion Engine
Daniel Dahl et al.
SAE INTERNATIONAL JOURNAL OF ENGINES (2009)
Share Paper
