Journal
DRYING TECHNOLOGY
Volume 40, Issue 10, Pages 2087-2104Publisher
TAYLOR & FRANCIS INC
DOI: 10.1080/07373937.2021.1918706
Keywords
Positron emission particle tracking (PEPT); tumble dryer; fabric motion; dryer sheet; dryer ball
Categories
Funding
- EPSRC iCASE award [EP/R511845/1, 1966258]
- Procter and Gamble
Ask authors/readers for more resources
Positron emission particle tracking (PEPT) was used to study the motion of radioactively labeled tracer particles attached to fabrics and solid fabric enhancer (SFE) delivery articles in domestic clothes dryers. Different movement behaviors of fabrics and SFE delivery articles were observed within the dryer drum, with fabrics primarily exhibiting cataracting motion while SFE delivery articles tended towards centrifuging and cascading flows.
Positron emission particle tracking (PEPT) has been used to investigate the motion of radioactively labeled tracer particles attached to fabrics and solid fabric enhancer (SFE) delivery articles, such as dryer sheets, in the domestic clothes dryer. This work examines the dynamics of motion within the dryer across a range of operating conditions. Six regions within the dryer drum are identified, demonstrating the range of movements experienced by items during tumbling. These show clear correlation with existing flow regimes describing behavior of granular media in rotating drums. Fabric motion is primarily cataracting to maximize the surface area of fabric available to interact with drying air in the falling region, with some conditions moving toward centrifuging or cascading flows. Movement in the axial direction was significantly slower than the primary radial flow. Dryer sheets were more prone to centrifuging than fabrics, with significant time spent in contact with the drum wall. Conversely, a wool dryer ball was more likely to cascade, spending time mixed into the top of a fabric bed which forms in the impact and lifting regions. Behavior in this bed is primarily determined by frictional interactions with the drum wall, which subsequently affects behavior in the 5 remaining regions. The most significant changes to this behavior were observed when changing fabric moisture content and volumetric fill ratio, with wet fabrics and smaller load sizes both exhibiting faster falling speeds and spending more time in the fabric bed. The changes were most significant in the lifting, falling and detachment regions, with varying acceleration and shearing likely to influence both fabric wear and SFE delivery.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available