4.7 Article

In situ formation of Si3N4-SiC nanocomposites through polymer-derived SiAlCN ceramics and spark plasma sintering

Journal

CERAMICS INTERNATIONAL
Volume 47, Issue 15, Pages 22049-22054

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.ceramint.2021.04.225

Keywords

Polymer-derived SiAlCN ceramics; Si3N4; SiC nano-composites; Spark plasma sintering; Fast densification behavior; Oxidation; corrosion resistance

Funding

  1. National Natural Science Foundation of China [52072344, U1904180, 21130019]

Ask authors/readers for more resources

This study successfully fabricated fully dense Si3N4/SiC nano-composites through the combination of polymer-derived ceramics method and spark plasma sintering technique. By incorporating aluminum into the precursor, the densification rate was improved, the degradation of Si3N4 phase was prevented, and excellent oxidation/corrosion resistance was achieved.
In this paper, fully dense Si3N4/SiC nano-composites were fabricated through polymer-derived ceramics (PDCs) method and spark plasma sintering technique. Polymer-derived SiAlCN ceramic was synthesized by using polysilazane as preceramic precursor, aluminum tri-sec-butoxide as Al source. Then Si3N4/SiC composites with nanometer sized Si3N4 and SiC phases were formed spontaneously during spark plasma sintering through in-situ phase separation of amorphous SiAlCN ceramics. It's found that with the increasement of Al contents, the densification rate was accelerated significantly and serious degradation of Si3N4 phase was avoided by restricting carbothermal reaction. At the same time, Al contained composites show excellent oxidation/corrosion resistance at 1350 degrees C and 50% H2O - 50% O2 water vapor environment than that of Al free samples. The Si3N4/SiC composites derived from Al contained PDCs overcomes the trade-off between abnormal grain growth and serious degradation of Si3N4 phase, which is a very tough problem for traditional PDC route (without Al) to fabricate Si3N4/SiC composites. For traditional PDC route, (I) if with traditional sintering additives, abnormal grain growth occurs, nano grains cannot be achieved; (II) if without traditional sintering additives, serious degradation of Si3N4 occurs, Si3N4 and SiC composite cannot be formed. Therefore, Al contained polymer-derived ceramics route opens a promising avenue to fabricate Si3N4/SiC nano-composites with fine grain size, uniform microstructure and excellent oxidation/corrosion resistance.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available