Related references
Note: Only part of the references are listed.Evaluation of PMSG-based drivetrain technologies for 10-MW floating offshore wind turbines: Pros and cons in a life cycle perspective
Farid K. Moghadam et al.
WIND ENERGY (2020)
A methodology for reliability assessment and prognosis of bearing axial cracking in wind turbine gearboxes
Yi Guo et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2020)
Investigating parallel multi-step vibration processing pipelines for planetary stage fault detection in wind turbine drivetrains
Sofia Koukoura et al.
SCIENCE OF MAKING TORQUE FROM WIND (TORQUE 2020), PTS 1-5 (2020)
A review of wind turbine main bearings: design, operation, modelling, damage mechanisms and fault detection
Edward Hart et al.
WIND ENERGY SCIENCE (2020)
A joint particle filter and expectation maximization approach to machine condition prognosis
Jinjiang Wang et al.
JOURNAL OF INTELLIGENT MANUFACTURING (2019)
A discrepancy analysis methodology for rolling element bearing diagnostics under variable speed conditions
Stephan Schmidt et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2019)
Electrical & mechanical diagnostic indicators of wind turbine induction generator rotor faults
D. Zappala et al.
RENEWABLE ENERGY (2019)
Machine learning methods for wind turbine condition monitoring: A review
Adrian Stetco et al.
RENEWABLE ENERGY (2019)
Fleetwide data-enabled reliability improvement of wind turbines
Timothy Verstraeten et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2019)
Review and comparison of tacholess instantaneous speed estimation methods on experimental vibration data
Cedric Peeters et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2019)
Wind turbine reliability data review and impacts on levelised cost of energy
Cuong Dao et al.
WIND ENERGY (2019)
Uses and mis-uses of energy operators for machine diagnostics
R. B. Randall et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2019)
Wind turbine gearbox failure and remaining useful life prediction using machine learning techniques
James Carroll et al.
WIND ENERGY (2019)
Current Signature and Vibration Analyses to Diagnose an In-Service Wind Turbine Drive Train
Estefania Artigao et al.
ENERGIES (2018)
A Levelized Cost of Energy (LCOE) model for wind farms that include Power Purchase Agreements (PPAs)
Maira Bruck et al.
RENEWABLE ENERGY (2018)
Vibration-based bearing fault detection for operations and maintenance cost reduction in wind energy
Cedric Peeters et al.
RENEWABLE ENERGY (2018)
Current signature analysis to monitor DFIG wind turbine generators: A case study
Estefania Artigao et al.
RENEWABLE ENERGY (2018)
Gearbox high-speed-stage bearing slip induced by electric excitation in a test facility
J. Helsen et al.
WIND ENERGY (2018)
Sensitivity analysis on the levelized cost of energy for floating offshore wind farms
Markus Lerch et al.
SUSTAINABLE ENERGY TECHNOLOGIES AND ASSESSMENTS (2018)
Availability, operation and maintenance costs of offshore wind turbines with different drive train configurations
James Carroll et al.
WIND ENERGY (2017)
A history of cepstrum analysis and its application to mechanical problems
Robert B. Randall
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2017)
Fast computation of the spectral correlation
Jerome Antoni et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2017)
A comparison of cepstral editing methods as signal pre-processing techniques for vibration-based bearing fault detection
Cedric Peeters et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2017)
Envelope analysis of rotating machine vibrations in variable speed conditions: A comprehensive treatment
D. Abboud et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2017)
Failure rate, repair time and unscheduled O&M cost analysis of offshore wind turbines
James Carroll et al.
WIND ENERGY (2016)
A multi-order probabilistic approach for Instantaneous Angular Speed tracking debriefing of the CMMNO'14 diagnosis contest
Quentin Leclere et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2016)
Investigating the Process of White Etching Crack Initiation in Bearing Steel
Benjamin Gould et al.
TRIBOLOGY LETTERS (2016)
Monitoring of Wind Turbine Gearbox Condition through Oil and Wear Debris Analysis: A Full-Scale Testing Perspective
Shuangwen Sheng
TRIBOLOGY TRANSACTIONS (2016)
Experimental investigation of bearing slip in a wind turbine gearbox during a transient grid loss event
J. Helsen et al.
WIND ENERGY (2016)
Long-term research challenges in wind energy - a research agenda by the European Academy of Wind Energy
G. A. M. van Kuik et al.
WIND ENERGY SCIENCE (2016)
Reliability Comparison of Wind Turbines With DFIG and PMG Drive Trains
James Carroll et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION (2015)
Automated on-line fault prognosis for wind turbine pitch systems using supervisory control and data acquisition
Bindi Chen et al.
IET RENEWABLE POWER GENERATION (2015)
A prognostic method for fault detection in wind turbine drivetrains
Amir Rasekhi Nejad et al.
ENGINEERING FAILURE ANALYSIS (2014)
On long-term fatigue damage and reliability analysis of gears under wind loads in offshore wind turbine drivetrains
Amir Rasekhi Nejad et al.
INTERNATIONAL JOURNAL OF FATIGUE (2014)
Instantaneous Angular Speed (IAS) processing and related angular applications
D. Remond et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2014)
Multidisciplinary design optimization of offshore wind turbines for minimum levelized cost of energy
T. Ashuri et al.
RENEWABLE ENERGY (2014)
The dynamic behavior induced by different wind turbine gearbox suspension methods assessed by means of the flexible multibody technique
Jan Helsen et al.
RENEWABLE ENERGY (2014)
Separation and enhancement of gear and bearing signals for the diagnosis of wind turbine transmission systems
Nader Sawalhi et al.
WIND ENERGY (2014)
Cepstral Removal of Periodic Spectral Components from Time Signals
Robert B. Randall et al.
ADVANCES IN CONDITION MONITORING OF MACHINERY IN NON-STATIONARY OPERATIONS (2014)
A new procedure for using envelope analysis for rolling element bearing diagnostics in variable operating conditions
P. Borghesani et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2013)
Application of cepstrum pre-whitening for the diagnosis of bearing faults under variable speed conditions
P. Borghesani et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2013)
Effect of hydrogen on butterfly and white etching crack (WEC) formation under rolling contact fatigue (RCF)
M. -H. Evans et al.
WEAR (2013)
A Kalman Filter-Based Ensemble Approach With Application to Turbine Creep Prognostics
Piero Baraldi et al.
IEEE TRANSACTIONS ON RELIABILITY (2012)
Upscaling wind turbines: theoretical and practical aspects and their impact on the cost of energy
G. Sieros et al.
WIND ENERGY (2012)
Overview of Multi-MW Wind Turbines and Wind Parks
Marco Liserre et al.
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS (2011)
COMPARISON OF AMPLITUDE-BASED AND PHASE-BASED METHODS FOR SPEED TRACKING IN APPLICATION TO WIND TURBINES
Jacek Urbanek et al.
METROLOGY AND MEASUREMENT SYSTEMS (2011)
Reliability of wind turbine subassemblies
F. Spinato et al.
IET RENEWABLE POWER GENERATION (2009)
Application of spectral kurtosis for detection of a tooth crack in the planetary gear of a wind turbine
Tomasz Barszcz et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2009)
Cyclic spectral analysis of rolling-element bearing signals: Facts and fictions
J. Antoni
JOURNAL OF SOUND AND VIBRATION (2007)
Fast computation of the kurtogram for the detection of transient faults
Jerome Antoni
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2007)
A review on machinery diagnostics and prognostics implementing condition-based maintenance
Andrew K. S. Jardine et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2006)
Comparison of direct-drive and geared generator concepts for wind turbines
Henk Polinder et al.
IEEE TRANSACTIONS ON ENERGY CONVERSION (2006)
Use of the acceleration signal of a gearbox in order to perform angular resampling (with limited speed fluctuation)
F Bonnardot et al.
MECHANICAL SYSTEMS AND SIGNAL PROCESSING (2005)
Direct Torque Control of a Doubly-Fed Induction Generator for variable speed wind turbines
S Arnalte et al.
ELECTRIC POWER COMPONENTS AND SYSTEMS (2002)
Share Paper
