Related references
Note: Only part of the references are listed.Temperature and strain rate dependences on hardening and softening behaviours in semi-crystalline polymers: Application to PEEK
D. Barba et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2020)
Evaluation of microstructure, mechanical and tribological properties of a Babbitt alloy deposited by arc and flame spray processes
Paulo Roberto Campos Alcover Junior et al.
TRIBOLOGY INTERNATIONAL (2019)
Tribological performance of graphite-filled polyimide and PTFE composites in oil-lubricated three-body abrasive conditions
Reza Gheisari et al.
WEAR (2019)
Friction in lubricated soft-on-hard, hard-on-soft and soft-on-soft sliding contacts
Przemyslaw Sadowski et al.
TRIBOLOGY INTERNATIONAL (2019)
Surface Topography: Metrology and Properties
P. Behera et al.
SURFACE TOPOGRAPHY-METROLOGY AND PROPERTIES (2017)
Elastohydrodynamic film thickness of soft EHL contacts using optical interferometry
Nigel Marx et al.
TRIBOLOGY INTERNATIONAL (2016)
Tribological behavior of PEEK-based materials under mixed and boundary lubrication conditions
G. Zhang et al.
TRIBOLOGY INTERNATIONAL (2015)
The effect of transient motion on Isoviscous-EHL films in compliant, point, contacts
Connor Myant et al.
TRIBOLOGY INTERNATIONAL (2014)
Break-away friction of PTFE materials in lubricated conditions
Arash Golchin et al.
TRIBOLOGY INTERNATIONAL (2012)
Assessment of polymer composites for hydrodynamic journal-bearing applications
D. M. C. McCarthy et al.
LUBRICATION SCIENCE (2009)
Sliding wear, viscoelasticity, and brittleness of polymers
Witold Brostow et al.
JOURNAL OF MATERIALS RESEARCH (2006)
Calculation of a safety margin for hydrogenerator thrust bearings
CM Ettles et al.
TRIBOLOGY TRANSACTIONS (2005)
Experimental characterization of the influence of coating materials on the hydrodynamic behavior of thrust bearings: A comparison of Babbitt, PTFE, and PFA
CA Mahieux
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2005)
The properties of poly (tetrafluoroethylene) (PTFE) in compression
PJ Rae et al.
POLYMER (2004)
Test results for PTFE-faced thrust pads, with direct comparison against babbitt-faced pads and correlation with analysis
CM Ettles et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2003)
Some effects of start-up and shut-down on thrust bearing assemblies in hydro-generators
CM Ettles et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2003)
On the significance of the H/E ratio in wear control:: a nanocomposite coating approach to optimised tribological behaviour
A Leyland et al.
WEAR (2000)
Share Paper
