Related references
Note: Only part of the references are listed.Geldart classification for wet particles
Tal Yehuda et al.
POWDER TECHNOLOGY (2020)
Phenomenological study of particulate materials compression - From individual through bed compression to tableting
Haim Kalman
POWDER TECHNOLOGY (2020)
Comparison of mechanical properties of ground corn stover, switchgrass, and willow and their pellet qualities
Apoorva Karamchandani et al.
PARTICULATE SCIENCE AND TECHNOLOGY (2018)
Effect of moisture on flowability of pulverized coal
Haifeng Lu et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)
Effect of water addition on flow properties of lignite particles
Yong Jin et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2018)
Experimental investigation on the flowability properties of cohesive carbonaceous powders
Xu Guiling et al.
PARTICULATE SCIENCE AND TECHNOLOGY (2017)
Insight Into a Novel Strategy for the Design of Tablet Formulations Intended for Direct Compression
Maxx Capece et al.
JOURNAL OF PHARMACEUTICAL SCIENCES (2017)
Influence of moisture content on the flow properties of basundi mix
Hrishikesh Mitra et al.
POWDER TECHNOLOGY (2017)
Compression analysis for assessment of pellet plasticity: Identification of reactant pores and comparison between Heckel, Kawakita, and Adams equations
Ann-Sofie Persson et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2016)
Comparing particle breakage in an uniaxial confined compression test to single particle crush tests-model and experimental results
Roman Liburkin et al.
POWDER TECHNOLOGY (2015)
Fundamental mechanical properties of ground switchgrass for quality assessment of pellets
Apoorva Karamchandani et al.
POWDER TECHNOLOGY (2015)
Determination of elastic properties of particles using single particle compression test
D. Portnikov et al.
POWDER TECHNOLOGY (2014)
Moisture-dependent physical properties of Moringa oleifera seed relevant in bulk handling and mechanical processing
Ndubisi A. Aviara et al.
INDUSTRIAL CROPS AND PRODUCTS (2013)
Investigating the testing procedure limits for measuring particle strength distribution
D. Portnikov et al.
POWDER TECHNOLOGY (2013)
Physical and flow properties of pecan shells-Particle size and moisture effects
B. Littlefield et al.
POWDER TECHNOLOGY (2011)
Flowability of moist pharmaceutical powders
Erica Emery et al.
POWDER TECHNOLOGY (2009)
On the physical interpretation of the Kawakita and Adams parameters derived from confined compression of granular solids
Josefina Nordstrom et al.
POWDER TECHNOLOGY (2008)
Quantification of the mechanisms governing the packing of iron ore fines
J. Q. Xu et al.
POWDER TECHNOLOGY (2006)
Single and bulk compressions of soft granules: Experimental study and DEM evaluation
A Samimi et al.
CHEMICAL ENGINEERING SCIENCE (2005)
Distinct element analysis and experimental evaluation of the Heckel analysis of bulk powder compression
A Hassanpour et al.
POWDER TECHNOLOGY (2004)
On the relationship between porosity and interparticle forces
AB Yu et al.
POWDER TECHNOLOGY (2003)
Compaction equations: a comparison of the Heckel and Kawakita equations
PJ Denny
POWDER TECHNOLOGY (2002)
Quantification of the relationship between porosity and interparticle forces for the packing of wet uniform spheres
CL Feng et al.
JOURNAL OF COLLOID AND INTERFACE SCIENCE (2000)
Impact of particle density and initial volume on mathematical compression models
JM Sonnergaard
EUROPEAN JOURNAL OF PHARMACEUTICAL SCIENCES (2000)
Analysis of the compression mechanics of pharmaceutical agglomerates of different porosity and composition using the Adams and Kawakita equations
F Nicklasson et al.
PHARMACEUTICAL RESEARCH (2000)
Share Paper
