Related references
Note: Only part of the references are listed.Recrystallization behaviour of high-flux hydrogen plasma exposed tungsten
V. Shah et al.
JOURNAL OF NUCLEAR MATERIALS (2021)
Performance of tungsten fibers for Wf/W composites under cyclic tensile load
D. Terentyev et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2020)
Response of yttria dispersion strengthened tungsten simultaneously exposed to steady-state and transient hydrogen plasma
Z. Chen et al.
NUCLEAR FUSION (2020)
Fracture behavior of tungsten-based composites exposed to steady-state/transient hydrogen plasma
Y. Li et al.
NUCLEAR FUSION (2020)
Recrystallization at high temperature of two tungsten materials complying with the ITER specifications
M. Richou et al.
JOURNAL OF NUCLEAR MATERIALS (2020)
Three mechanisms of hydrogen-induced dislocation pinning in tungsten
Y. Li et al.
NUCLEAR FUSION (2020)
The heterogeneity of persistent slip band nucleation and evolution in metals at the micrometer scale
Steven Lavenstein et al.
SCIENCE (2020)
Brittle-ductile transition temperature of recrystallized tungsten following exposure to fusion relevant cyclic high heat load
V Shah et al.
JOURNAL OF NUCLEAR MATERIALS (2020)
Experimental investigation of the microstructural changes of tungsten monoblocks exposed to pulsed high heat loads
V Shah et al.
NUCLEAR MATERIALS AND ENERGY (2020)
ITER monoblock performance under lifetime loading conditions in Magnum-PSI
T. W. Morgan et al.
PHYSICA SCRIPTA (2020)
High-fluence and high-flux performance characteristics of the superconducting Magnum-PSI linear plasma facility
H. J. N. van Eck et al.
FUSION ENGINEERING AND DESIGN (2019)
Evaluation of Fracture Toughness Measurements Using Chevron-Notched Silicon and Tungsten Microcantilevers
B. -S. Li et al.
JOM (2019)
Temperature dependence of retarded recrystallisation in helium plasma-exposed tungsten
K. Song et al.
NUCLEAR FUSION (2019)
An investigation of the microstructure and ductility of annealed cold-rolled tungsten
Chai Ren et al.
ACTA MATERIALIA (2019)
Impact of tungsten recrystallization on ITER-like components for lifetime estimation
A. Durif et al.
FUSION ENGINEERING AND DESIGN (2019)
Emissivity measurement of tungsten plasma facing components of the WEST tokamak
J. Gaspar et al.
FUSION ENGINEERING AND DESIGN (2019)
High pulse number thermal shock testing of tungsten alloys produced by powder injection molding
Th. Loewenhoff et al.
NUCLEAR MATERIALS AND ENERGY (2019)
Physics basis for the first ITER tungsten divertor
R. A. Pitts et al.
NUCLEAR MATERIALS AND ENERGY (2019)
Ferrite slip system activation investigated by uniaxial micro-tensile tests and simulations
C. Du et al.
ACTA MATERIALIA (2018)
Modelling recrystallization and grain growth of tungsten induced by neutron displacement defects
A. Mannheim et al.
MECHANICS OF MATERIALS (2018)
Retarded recrystallization of helium-exposed tungsten
Wangguo Guo et al.
NUCLEAR FUSION (2018)
The influence of plasma-surface interaction on the performance of tungsten at the ITER divertor vertical targets
G. De Temmerman et al.
PLASMA PHYSICS AND CONTROLLED FUSION (2018)
The effect of helium implantation on the deformation behaviour of tungsten: X-ray micro-diffraction and nanoindentation
S. Das et al.
SCRIPTA MATERIALIA (2018)
The brittle-ductile transition of tungsten single crystals at the micro-scale
J. Ast et al.
MATERIALS & DESIGN (2018)
Fracture modes of ITER tungsten divertor monoblock under stationary thermal loads
S. Panayotis et al.
FUSION ENGINEERING AND DESIGN (2017)
Laser energy absorption coefficient and in-situ temperature measurement of laser-melted tungsten
T. Maeji et al.
FUSION ENGINEERING AND DESIGN (2017)
Thermal conductivity measurement of the He-ion implanted layer of W using transient thermoreflectance technique
Shilian Qu et al.
JOURNAL OF NUCLEAR MATERIALS (2017)
Liquid metals surface temperature fields measurements with a two-colour pyrometer
Romain Monier et al.
MEASUREMENT (2017)
High pulse number thermal shock tests on tungsten with steady state particle background
M. Wirtz et al.
PHYSICA SCRIPTA (2017)
High dislocation density-induced large ductility in deformed and partitioned steels
B. B. He et al.
SCIENCE (2017)
Transient heat load challenges for plasma-facing materials during long-term operation
M. Wirtz et al.
NUCLEAR MATERIALS AND ENERGY (2017)
The interplay of controlling the power exhaust and the tungsten content in ITER
R. Dux et al.
NUCLEAR MATERIALS AND ENERGY (2017)
ELM divertor peak energy fluence scaling to ITER with data from JET, MAST and ASDEX upgrade
T. Eich et al.
NUCLEAR MATERIALS AND ENERGY (2017)
Failure of metals II: Fatigue
Andre Pineau et al.
ACTA MATERIALIA (2016)
Failure of metals I: Brittle and ductile fracture
A. Pineau et al.
ACTA MATERIALIA (2016)
Collective Thomson scattering system for determination of ion properties in a high flux plasma beam
H. J. van der Meiden et al.
APPLIED PHYSICS LETTERS (2016)
Measurement of heat diffusion across fuzzy tungsten layer
Shin Kajita et al.
RESULTS IN PHYSICS (2016)
Thermal stability of a highly-deformed warm-rolled tungsten plate in the temperature range 1100-1250 °C
A. Alfonso et al.
FUSION ENGINEERING AND DESIGN (2015)
Interpretation of the deep cracking phenomenon of tungsten monoblock targets observed in high-heat-flux fatigue tests at 20 MW/m2
Muyuan Li et al.
FUSION ENGINEERING AND DESIGN (2015)
Status of technology R&D for the ITER tungsten divertor monoblock
T. Hirai et al.
JOURNAL OF NUCLEAR MATERIALS (2015)
Impact of combined transient plasma/heat loads on tungsten performance below and above recrystallization temperature
Th Loewenhoff et al.
NUCLEAR FUSION (2015)
Impact of combined hydrogen plasma and transient heat loads on the performance of tungsten as plasma facing material
M. Wirtz et al.
NUCLEAR FUSION (2015)
Non-Contact Measurement of Thermal Diffusivity in Ion-Implanted Nuclear Materials
F. Hofmann et al.
SCIENTIFIC REPORTS (2015)
Recrystallization kinetics of warm-rolled tungsten in the temperature range 1150-1350 °C
A. Alfonso et al.
JOURNAL OF NUCLEAR MATERIALS (2014)
Edge-localized-modes in tokamaks
A. W. Leonard
PHYSICS OF PLASMAS (2014)
Plastic strain localization in metals: origins and consequences
Stephen D. Antolovich et al.
PROGRESS IN MATERIALS SCIENCE (2014)
Thermal shock response of deformed and recrystallised tungsten
M. Wirtz et al.
FUSION ENGINEERING AND DESIGN (2013)
Abnormal Grain Growth Induced by Cyclic Heat Treatment
Toshihiro Omori et al.
SCIENCE (2013)
Tungsten and CFC degradation under combined high cycle transient and steady state heat loads
Th. Loewenhoff et al.
FUSION ENGINEERING AND DESIGN (2012)
Advanced Thomson scattering system for high-flux linear plasma generator
H. J. van der Meiden et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2012)
The role of grain boundaries on fatigue crack initiation - An energy approach
Michael D. Sangid et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2011)
A two-site mean field model of discontinuous dynamic recrystallization
P. Bernard et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Determination of elastic strain fields and geometrically necessary dislocation distributions near nanoindents using electron back scatter diffraction
Angus J. Wilkinson et al.
PHILOSOPHICAL MAGAZINE (2010)
Dynamic abnormal grain growth: A new method to produce single crystals
J. Ciulik et al.
SCRIPTA MATERIALIA (2009)
Roles of grain boundary microstructure in high-cycle fatigue of electrodeposited nanocrystalline Ni-P alloy
Shigeaki Kobayashi et al.
SCRIPTA MATERIALIA (2009)
Thermo-mechanical calculations on operation temperature limits of tungsten as plasma facing material
T. Hirai et al.
FUSION ENGINEERING AND DESIGN (2007)
Grain boundary planes: New dimensions in the grain boundary character distribution
CS Kim et al.
SCRIPTA MATERIALIA (2006)
The distribution of internal interfaces in polycrystals
GS Rohrer et al.
ZEITSCHRIFT FUR METALLKUNDE (2004)
Quantifying recrystallization by electron backscatter diffraction
H Jazaeri et al.
JOURNAL OF MICROSCOPY (2004)
Sample dimensions influence strength and crystal plasticity
MD Uchic et al.
SCIENCE (2004)
Comparison of fatigue cracking possibility along large- and low-angle grain boundaries
ZF Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2000)
Share Paper
