Related references
Note: Only part of the references are listed.Application of Taguchi method for optimizing the process parameters for the removal of copper and nickel by growing Aspergillus sp.
Reena Pundir et al.
WATER RESOURCES AND INDUSTRY (2018)
ANN surface roughness prediction of AZ91D magnesium alloys in the turning process
Berat Baris Buldum et al.
MATERIALS TESTING (2017)
Controlling the ignition and flammability of magnesium for aerospace applications
Frank Czerwinski
CORROSION SCIENCE (2014)
Experimental investigation on finish intermittent turning of UNS M11917 magnesium alloy under dry machining
D. Carou et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2014)
Influence of β phase fraction on deformation of grains in and around shear bands in machining of titanium alloys
Shashikant Joshi et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Optimization of surface roughness, cutting force and tool wear of nitrogen alloyed duplex stainless steel in a dry turning process using Taguchi method
D. Philip Selvaraj et al.
MEASUREMENT (2014)
Application of response surface methodology for determining cutting force model in turning of LM6/SiCP metal matrix composite
H. Joardar et al.
MEASUREMENT (2014)
Application of fuzzy logic and regression analysis for modeling surface roughness in face milliing
P. Kovac et al.
JOURNAL OF INTELLIGENT MANUFACTURING (2013)
Some studies on hard turning of AISI 4340 steel using multilayer coated carbide tool
R. Suresh et al.
MEASUREMENT (2012)
Optimization of cutting parameters on delamination based on Taguchi method during drilling of GFRP composite
E. Kilickap
EXPERT SYSTEMS WITH APPLICATIONS (2010)
A fundamental study on the impact of surface integrity by hard turning on rolling contact fatigue
Dale W. Schwach et al.
INTERNATIONAL JOURNAL OF FATIGUE (2006)
Tool-life modelling of carbide and ceramic cutting tools using multi-linear regression analysis
S. M. Amaitik et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2006)
Modeling flank wear of carbide tool insert in metal cutting
X Luo et al.
WEAR (2005)
Predictive modeling of surface roughness and tool wear in hard turning using regression and neural networks
T Özel et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2005)
Optimization of cutting conditions during cutting by using neural networks
U Zuperl et al.
ROBOTICS AND COMPUTER-INTEGRATED MANUFACTURING (2003)
Optimization of cutting process by GA approach
F Cus et al.
ROBOTICS AND COMPUTER-INTEGRATED MANUFACTURING (2003)
Modeling the surface roughness and cutting force for turning
WS Lin et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2001)
Share Paper
