Related references
Note: Only part of the references are listed.Microstructural characterization and comparison of Ti-6Al-4V manufactured with different additive manufacturing processes
M. Neikter et al.
MATERIALS CHARACTERIZATION (2018)
Fracture toughness and fatigue crack growth rate properties in wire plus arc additive manufactured Ti-6Al-4V
X. Zhang et al.
FATIGUE & FRACTURE OF ENGINEERING MATERIALS & STRUCTURES (2017)
Fatigue life of additively manufactured Ti-6Al-4V in the very high cycle fatigue regime
J. Guenther et al.
INTERNATIONAL JOURNAL OF FATIGUE (2017)
Fatigue crack growth behavior and microstructural mechanisms in Ti-6Al-4V manufactured by laser engineered net shaping
Yuwei Zhai et al.
INTERNATIONAL JOURNAL OF FATIGUE (2016)
Fatigue behavior and failure mechanisms of direct laser deposited Ti-6Al-4V
Amanda J. Sterling et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Influence of microstructure on mechanical properties of laser metal wire-deposited Ti-6Al-4V
Pia Akerfeldt et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2016)
Characterization of fatigue crack growth behavior in LENS fabricated Ti-6Al-4V using high-energy synchrotron x-ray microtomography
Hayley R. Sandgren et al.
ADDITIVE MANUFACTURING (2016)
Anisotropic tensile behavior of Ti-6Al-4V components fabricated with directed energy deposition additive manufacturing
Beth E. Carroll et al.
ACTA MATERIALIA (2015)
Grain morphology evolution behavior of titanium alloy components during laser melting deposition additive manufacturing
T. Wang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Effect of microstructure and defects on fatigue behaviour of directed energy deposited Ti-6Al-4V
A. W. Prabhu et al.
SCIENCE AND TECHNOLOGY OF WELDING AND JOINING (2015)
Metal Additive Manufacturing: A Review
William E. Frazier
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE (2014)
Morphology, microstructure, and hardness of titanium (Ti-6Al-4V) blocks deposited by wire-feed additive layer manufacturing (ALM)
Erhard Brandl et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2012)
Wire based additive layer manufacturing: Comparison of microstructure and mechanical properties of Ti-6Al-4V components fabricated by laser-beam deposition and shaped metal deposition
Bernd Baufeld et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2011)
Thermal process maps for predicting solidification microstructure in laser fabrication of thin-wall structures
Srikanth Bontha et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Microstructural evolution in laser-deposited multilayer Ti-M-4V builds: Part I. Microstructural characterization
SM Kelly et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2004)
Share Paper
