Supported carbon membranes using poly(ether sulfone) precursor

This research focused on developing membranes using poly(ether sulfone) as polymeric precursor and DMSO as a solvent. The dip-coating technique was used to form a polymeric layer on the alumina ceramic tube, and the pyrolysis was conducted at 700 degrees C under N-2 atmosphere. The structural analyses showed that the supported carbon membranes (SCM) are basically composed of amorphous and turbostratic carbon with graphitic domain, confirming the heterogeneity of the matrix. It was observed from the FTIR and XRD results that the precursor polymer was fully pyrolyzed. The carbon structure obtained presented a microporous character (pore radius equal to 6.2 A) and a high BET surface area (approximately 400 m(2) g(-1)). The SCM presented a well-defined selective layer with little or no intrusion in the pores of the support. A higher polymeric concentration promoted an increase in the thickness of the carbon membranes (from 20 mu m to 36 mu m). The carbon membranes produced showed high thermal stability, allowing their application in gas separation processes at higher temperatures, up to approximately 400 degrees C.

Automated summary

This research focused on developing carbon membranes using poly(ether sulfone) as a polymeric precursor and DMSO as a solvent, formed through dip-coating technique on alumina ceramic tubes with pyrolysis conducted at 700 degrees C. The obtained carbon membranes showed high thermal stability and microporous characteristics, suitable for gas separation processes.