4.7 Article

Using artificial neural networks to predict the rheological behavior of non-Newtonian graphene-ethylene glycol nanofluid

Related references

Note: Only part of the references are listed.
Article Thermodynamics

Efficacy of incorporating PCMs into the commercial wall on the energy-saving annual thermal analysis

Quyen Nguyen et al.

Summary: Incorporating phase change materials (PCM) into building walls can effectively reduce annual heat transfer, with better performance in warmer months and a more significant effect with lower thermal conductivity.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Article Thermodynamics

Numerical modeling of a hybrid PCM-based wall for energy usage reduction in the warmest and coldest months

Zhixiong Li et al.

Summary: The study concluded that using hybrid PCM inside the wall can effectively reduce heat transfer in three climate zones with different temperature characteristics. The reduction in heat transfer was 26.9%, 29.65%, and 30.5% in each climate zone, respectively, during both warm and cold months.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Article Thermodynamics

Improving the thermal conductivity of paraffin by incorporating MWCNTs nanoparticles

Shu-Rong Yan et al.

Summary: The study demonstrates that adding nanoparticles of MWCNTs to paraffin base fluid significantly improves thermal conductivity, especially at higher temperatures. The higher the mass fraction of nanotubes, the greater the sensitivity of thermal conductivity to temperature.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Review Thermodynamics

A review on the properties, preparation, models and stability of hybrid nanofluids to optimize energy consumption

Hamed Eshgarf et al.

Summary: Nanofluids and hybrid nanofluids are new heat transfer media with superior heat transfer characteristics that have gained significant attention. Hybrid nanofluids exhibit more suitable heat transfer performance and thermophysical properties compared to traditional heat transfer fluids and single nanofluids. Current research focuses on investigating the properties, preparation, and stability of hybrid nanofluids.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Article Thermodynamics

Improving the thermal conductivity of ethylene glycol by addition of hybrid nano-materials containing multi-walled carbon nanotubes and titanium dioxide: applicable for cooling and heating

Sara Rostam et al.

Summary: This research investigated the thermal conductivity of a hybrid nanofluid containing MWCNTs and TiO2, showing that loading nanoparticles can enhance the sensitivity of thermal conductivity to temperature, with the positive effects amplified as temperature rises. Statistical analysis and machine learning algorithms were used for prediction and comparison.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Article Thermodynamics

Sensitivity of AHU power consumption to PCM implementation in the wall-considering the solar radiation

Arya Nariman et al.

Summary: This study showed that incorporating phase change materials (PCM) into walls can effectively reduce heat transfer, especially in decreasing the cooling load of the air conditioning system in the interior space during summer months, leading to a significant reduction in the power consumption of the cooling coil.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Article Thermodynamics

Diminishing vortex intensity and improving heat transfer by applying magnetic field on an injectable slip microchannel containing FMWNT/water nanofluid

Aliakbar Karimipour et al.

Summary: The study revealed that utilizing injection technique in the presence of a magnetic field in a microchannel containing FMWNT/water nanofluids can enhance heat transfer efficiency and reduce entropy generation; higher nanoparticle volume fraction and Reynolds number contribute to the amplification of the magnetic field effect.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2021)

Article Thermodynamics

Introducing a novel heat sink comprising PCM and air - Adapted to electronic device thermal management

Rasool Kalbasi

Summary: The study introduced a novel hybrid heat sink filled with PCM and air to effectively reduce electronic device temperature. The hybrid heat sink outperformed both PCM-based and air-cooled heat sinks, especially as the convective coefficient increased.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2021)

Article Thermodynamics

Reducing AHU energy consumption by a new layout of using heat recovery units

Rasool Kalbasi et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2020)

Article Thermodynamics

Incorporating novel heat recovery units into an AHU for energy demand reduction-exergy analysis

Rasool Kalbasi et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2020)

Article Thermodynamics

Energetic analysis of an air handling unit combined with enthalpy air-to-air heat exchanger

Rasool Kalbasi et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2020)

Article Thermodynamics

Improving performance of AHU using exhaust air potential by applying exergy analysis

Rasool Kalbasi et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2020)

Article Physics, Multidisciplinary

Statistical and artificial based optimization on thermo-physical properties of an oil based hybrid nanofluid using NSGA-II and RSM

Mohammad Hemmat Esfe et al.

PHYSICA A-STATISTICAL MECHANICS AND ITS APPLICATIONS (2020)

Article Green & Sustainable Science & Technology

Solutions for enhancement of energy and exergy efficiencies in air handling units

Wanli Liu et al.

JOURNAL OF CLEANER PRODUCTION (2020)

Article Energy & Fuels

Estimation of Pressure Drop of Two-Phase Flow in Horizontal Long Pipes Using Artificial Neural Networks

Mostafa Safdari Shadloo et al.

JOURNAL OF ENERGY RESOURCES TECHNOLOGY-TRANSACTIONS OF THE ASME (2020)

Article Chemistry, Physical

Rheological behavior of hybrid MWCNTs-TiO2/EG nanofluid: A comprehensive modeling and experimental study

Shu-Rong Yan et al.

JOURNAL OF MOLECULAR LIQUIDS (2020)

Article Mathematics, Applied

Efficacy of injectable rib height on the heat transfer and entropy generation in the microchannel by affecting slip flow

Dariush Bahrami et al.

MATHEMATICAL METHODS IN THE APPLIED SCIENCES (2020)

Article Materials Science, Multidisciplinary

Effect of silica nano-materials on the viscosity of ethylene glycol: an experimental study by considering sonication duration effect

Sara Rostami et al.

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2020)

Article Construction & Building Technology

Energy usage reduction in an air handling unit by incorporating two heat recovery units

Aysan Shahsavar Goldanlou et al.

JOURNAL OF BUILDING ENGINEERING (2020)

Article Energy & Fuels

Statistical evaluation of using the new generation of wind turbines in South Africa

Ali Mostafaeipour et al.

ENERGY REPORTS (2020)

Article Environmental Studies

Feasibility analysis of a new tree-shaped wind turbine for urban application: A case study

Ali Mostafaeipour et al.

ENERGY & ENVIRONMENT (2020)

Article Green & Sustainable Science & Technology

An experimental study on stability and thermal conductivity of water/silica nanofluid: Eco-friendly production of nanoparticles

Ramin Ranjbarzadeh et al.

JOURNAL OF CLEANER PRODUCTION (2019)

Article Thermodynamics

Effect of radiation on laminar natural convection of nanofluid in a vertical channel with single- and two-phase approaches

Amir Mostafazadeh et al.

JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY (2019)

Article Physics, Multidisciplinary

A novel nonlinear regression model of SVR as a substitute for ANN to predict conductivity of MWCNT-CuO/water hybrid nanofluid based on empirical data

Arash Karimipour et al.

PHYSICA A-STATISTICAL MECHANICS AND ITS APPLICATIONS (2019)

Article Physics, Multidisciplinary

Assessment of thermal conductivity enhancement of nano-antifreeze containing single-walled carbon nanotubes: Optimal artificial neural network and curve-fitting

Alireza Moradikazerouni et al.

PHYSICA A-STATISTICAL MECHANICS AND ITS APPLICATIONS (2019)

Article Thermodynamics

Studies on optimum fins number in PCM-based heat sinks

Rasool Kalbasi et al.

ENERGY (2019)

Article Linguistics

Prioritization of critical individual factors influencing willingness to communicate: AHP method

Marzieh Rafiee et al.

JOURNAL OF MULTILINGUAL AND MULTICULTURAL DEVELOPMENT (2019)

Article Multidisciplinary Sciences

Forced convection heat transfer of water/FMWCNT nanofluid in a microchannel with triangular ribs

Afshin Shiriny et al.

SN APPLIED SCIENCES (2019)

Article Thermodynamics

Effect of nanomaterial addition on the thermophysical properties of Iraqi paraffin wax

Ahmed H. Ali et al.

CASE STUDIES IN THERMAL ENGINEERING (2019)

Article Engineering, Multidisciplinary

Energy efficiency for cooling buildings in hot and dry regions using sol-air temperature and ground temperature effects

Ali Mostafaeipour et al.

JOURNAL OF ENGINEERING DESIGN AND TECHNOLOGY (2019)

Article Physics, Multidisciplinary

Modeling and prediction of rheological behavior of Al2O3-MWCNT/5W50 hybrid nano-lubricant by artificial neural network using experimental data

Mohammad Hemmat Esfe et al.

PHYSICA A-STATISTICAL MECHANICS AND ITS APPLICATIONS (2018)

Article Nanoscience & Nanotechnology

Experimental and theoretical investigation of thermal conductivity of ethylene glycol containing functionalized single walled carbon nanotubes

Mohammad Hemmat Esfe et al.

PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES (2018)

Review Thermodynamics

A comprehensive review on rheological behavior of mono and hybrid nanofluids: Effective parameters and predictive correlations

Hossein Khodadadi et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)

Article Nanoscience & Nanotechnology

Experimental investigation, model development and sensitivity analysis of rheological behavior of ZnO/10W40 nano-lubricants for automotive applications

Mohammad Hemmat Esfe et al.

PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES (2017)

Article Nanoscience & Nanotechnology

Evaluation of thermal conductivity of MgO-MWCNTs/EG hybrid nanofluids based on experimental data by selecting optimal artificial neural networks

Masoud Vafaei et al.

PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES (2017)

Article Nanoscience & Nanotechnology

Evaluation of rheological behavior of 10W40 lubricant containing hybrid nano-material by measuring dynamic viscosity

Afshin Ahmadi Nadooshan et al.

PHYSICA E-LOW-DIMENSIONAL SYSTEMS & NANOSTRUCTURES (2017)

Article Biophysics

Modeling of cell adhesion and deformation mediated by receptor-ligand interactions

Amirreza F. Golestaneh et al.

BIOMECHANICS AND MODELING IN MECHANOBIOLOGY (2016)

Article Thermodynamics

Estimation of thermal conductivity of CNTs-water in low temperature by artificial neural network and correlation

Mohammad Hemmat Esfe et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2016)

Article Thermodynamics

Effects of temperature and concentration on rheological behavior of MWCNTs/SiO2(20-80)-SAE40 hybrid nano-lubricant

Mohammad Hemmat Esfe et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2016)

Article Thermodynamics

Estimation of thermal conductivity of Al2O3/water (40%)-ethylene glycol (60%) by artificial neural network and correlation using experimental data

Mohammad Hemmat Esfe et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2016)

Article Thermodynamics

Experimental investigation and development of new correlations for thermal conductivity of CuO/EG-water nanofluid

Mohammad Hemmat Este et al.

INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER (2015)

Article Thermodynamics

An experimental study on the pressure drop of nanofluids containing carbon nanotubes in a horizontal tube

Gwon Hyun Ko et al.

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2007)