Related references
Note: Only part of the references are listed.Characterization of Microstructure in Additively Manufactured 316L using Automated Serial Sectioning
David J. Rowenhorst et al.
CURRENT OPINION IN SOLID STATE & MATERIALS SCIENCE (2020)
Porosity segmentation in X-ray computed tomography scans of metal additively manufactured specimens with machine learning
Christian Gobert et al.
ADDITIVE MANUFACTURING (2020)
Scientific, technological and economic issues in metal printing and their solutions
T. DebRoy et al.
NATURE MATERIALS (2019)
The Influence of X-Ray Computed Tomography Acquisition Parameters on Image Quality and Probability of Detection of Additive Manufacturing Defects
Felix H. Kim et al.
JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME (2019)
Interrupted fatigue testing with periodic tomography to monitor porosity defects in wire plus arc additive manufactured Ti-6Al-4V
Romali Biswal et al.
ADDITIVE MANUFACTURING (2019)
Laboratory X-ray tomography for metal additive manufacturing: Round robin test
Anton du Plessis et al.
ADDITIVE MANUFACTURING (2019)
Influence of defects, surface roughness and HIP on the fatigue strength of Ti-6Al-4V manufactured by additive manufacturing
Hiroshige Masuo et al.
INTERNATIONAL JOURNAL OF FATIGUE (2018)
Volume Imaging NDE and Serial Sectioning of Carbon Fiber Composites
Issa Hakim et al.
44TH ANNUAL REVIEW OF PROGRESS IN QUANTITATIVE NONDESTRUCTIVE EVALUATION, VOL 37 (2018)
Additive manufacturing process monitoring and control by non-destructive testing techniques: challenges and in-process monitoring
Q. Y. Lu et al.
VIRTUAL AND PHYSICAL PROTOTYPING (2018)
Application of supervised machine learning for defect detection during metallic powder bed fusion additive manufacturing using high resolution imaging
Christian Gobert et al.
ADDITIVE MANUFACTURING (2018)
Additive manufacturing applications in medical cases: A literature based review
Mohd Javaid et al.
ALEXANDRIA JOURNAL OF MEDICINE (2018)
The Influence of Porosity on Fatigue Crack Initiation in Additively Manufactured Titanium Components
S. Tammas-Williams et al.
SCIENTIFIC REPORTS (2017)
Application of characterization, modelling, and analytics towards understanding process-structure linkages in metallic 3D printing
M. A. Groeber et al.
38TH RISO INTERNATIONAL SYMPOSIUM ON MATERIALS SCIENCE (2017)
The Use of Laser Ultrasound to Detect Defects in Laser Melted Parts
Sarah Everton et al.
TMS 2017 146TH ANNUAL MEETING & EXHIBITION SUPPLEMENTAL PROCEEDINGS (2017)
X-ray computed tomography for additive manufacturing: a review
A. Thompson et al.
MEASUREMENT SCIENCE AND TECHNOLOGY (2016)
Electron Beam Additive Manufacturing of Titanium Components: Properties and Performance
P. Edwards et al.
JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME (2013)
Characterization of microshrinkage casting defects of Al-Si alloys by X-ray computed tomography and metallography
Gianni Nicoletto et al.
INTERNATIONAL JOURNAL OF FATIGUE (2012)
Formation of gas induced shrinkage porosity in Mg-alloy high-pressure die-castings
Soon Gi Lee et al.
SCRIPTA MATERIALIA (2006)