Nanoparticle-Assisted Water-Flooding in Berea Sandstones

The use of nanoparticles to improve reservoir characterization or to enhance oil recovery (EOR) has recently received intensive interest; however, there are still many unresolved questions. This work reports a systematic study of the effect of rutile TiO2 nanoparticle-assisted brine flooding. Rutile ellipsoid TiO2 nanoparticles were synthesized and stabilized by trisodium citrate dihydrate for brine flooding of water-wet Berea sandstone cores. Careful characterization of the rock samples and nanomaterials before and after the flooding was conducted, and the relative contributions to the modified flooding results from the stabilizer and the nanoparticles of different concentrations were examined. The oil recovery performance was evaluated both at the breakthrough (BT) point and at the end of flooding (similar to 3.2 pore volumes). Nanoparticle migration behavior was also investigated in order to understand the potential mechanisms for oil recovery. The results showed that both nanoparticle transport rate and EOR effect were strongly dependent on the particle concentration. The oil recovery efficiency at the BT point was found to increase at low nanoparticle concentrations but decrease at higher values. A maximum 33% increase of the recovery factor was observed at the BT point for a TiO2 concentration of 20 ppm, but higher nanoparticle concentrations usually had higher ultimate recovery factors. The presence of an oil phase was found to accelerate the particle migration though the core. The discussion of various mechanisms suggested that the improvement in the mobility ratio, possible wettability change, and log jamming effect were responsible for the observed phenomena.