Converting waste molasses liquor into biohydrogen via dark fermentation using a continuous bioreactor

This study investigated the effects of substrate concentration, HRT (hydraulic retention time), and pre-treatment of the substrate molasses on biohydrogen production from waste molasses (condensed molasses fermentation solubles, CMS) with a CSTR (continuously-stirred tank reactor). First, the hydrogen production was performed with various CMS concentrations (40-90 g COD/L, total sugar 8.7-22.6 g/L) with 6 h HRT. The results show that the maximal hydrogen production rate (HPR) occurred at 80 g COD/L substrate (19.8 g ToSu/L, ToSu: Total Sugar), obtaining an HPR of 0.417 mol/L/d. However, maximum hydrogen yield (HY) of 1.44 mol H-2/mol hexose and overall hydrogen production efficiency (HPE) of 25.6% were achieved with a CMS concentration of 70 g COD/L (17.3 g ToSu/L). The substrate inhibition occurred when CMS concentration was increased to 90 g COD/L (22.6 g ToSu/L). Furthermore, it was observed that the optimal HPR, HY, and HPE all occurred at HRT 6 h. Operating at a lower HRT of 4 h decreased the hydrogen production performance because of lower substrate utilization efficiency. The employment of pre-heating treatment (60 degrees C for 1 h) of the substrate could markedly enhance the fermentation performance. With 6 h HRT and substrate pre-heating treatment, the HPE raised to 29.9%, which is 18% higher than that obtained without thermal pretreatment. (C) 2021 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Automated summary

The study found that the optimal biohydrogen production efficiency was achieved at a substrate concentration of 70 g COD/L. The best hydrogen production rate, hydrogen yield, and overall hydrogen production efficiency were observed with a hydraulic retention time of 6 hours. Pre-treatment of the substrate with heating significantly enhanced fermentation performance.