Related references
Note: Only part of the references are listed.Modeling and Characterization of a Pull-in Free MEMS Microphone
Mehmet Ozdogan et al.
IEEE SENSORS JOURNAL (2020)
Lateral pull-in instability of electrostatic MEMS transducers employing repulsive force
Meysam Daeichin et al.
NONLINEAR DYNAMICS (2020)
Experimental Characterization of the Electrostatic Levitation Force in MEMS Transducers
Meysam Daeichin et al.
JOURNAL OF VIBRATION AND ACOUSTICS-TRANSACTIONS OF THE ASME (2020)
Dynamic response of a tunable MEMS accelerometer based on repulsive force
Meysam Daeichin et al.
SENSORS AND ACTUATORS A-PHYSICAL (2019)
A low noise capacitive MEMS accelerometer with anti-spring structure
Hongcai Zhang et al.
SENSORS AND ACTUATORS A-PHYSICAL (2019)
A reliable MEMS switch using electrostatic levitation
Mark Pallay et al.
APPLIED PHYSICS LETTERS (2018)
Dynamic behavior of an electrostatic MEMS resonator with repulsive actuation
Mark Pallay et al.
NONLINEAR DYNAMICS (2017)
Parametric resonance of a repulsive force MEMS electrostatic mirror
Mehmet Ozdogan et al.
SENSORS AND ACTUATORS A-PHYSICAL (2017)
A Bulk-Micromachined Three-Axis Capacitive MEMS Accelerometer on a Single Die
Serdar Tez et al.
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS (2015)
Design and fabrication of a MEMS capacitive accelerometer with fully symmetrical double-sided H-shaped beam structure
Xiaofeng Zhou et al.
MICROELECTRONIC ENGINEERING (2015)
Electrostatic pull-in instability in MEMS/NEMS: A review
Wen-Ming Zhang et al.
SENSORS AND ACTUATORS A-PHYSICAL (2014)
Design of nonlinear springs for attaining a linear response in gap-closing electrostatic actuators
Ben Rivlin et al.
INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES (2012)
Implementation of a gap-closing differential capacitive sensing Z-axis accelerometer on an SOI wafer
Chia-Pao Hsu et al.
JOURNAL OF MICROMECHANICS AND MICROENGINEERING (2009)
Development and analysis of the vertical capacitive accelerometer
I Lee et al.
SENSORS AND ACTUATORS A-PHYSICAL (2005)
Tilt-angle stabilization of electrostatically actuated micromechanical mirrors beyond the pull-in point
JH Chen et al.
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS (2004)
Effects of electrical leakage currents on MEMS reliability and performance
HR Shea et al.
IEEE TRANSACTIONS ON DEVICE AND MATERIALS RELIABILITY (2004)
Charge control of parallel-plate, electrostatic actuators and the tip-in instability
JI Seeger et al.
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS (2003)
Current drive methods to extend the range of travel of electrostatic microactuators beyond the voltage pull-in point
R Nadal-Guardia et al.
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS (2002)
Share Paper
