Related references
Note: Only part of the references are listed.A review of indirect evaporative cooling technology
Bogdan Porumb et al.
EENVIRO-YRC 2015 - BUCHAREST (2016)
Roof ponds as passive heating and cooling systems: A systematic review
Ayyoob Sharifi et al.
APPLIED ENERGY (2015)
Analysis on the passive evaporative cooling wall constructed of porous ceramic pipes with water sucking ability
Wei Chen et al.
ENERGY AND BUILDINGS (2015)
Novel modeling of an indirect evaporative cooling system with cross-flow configuration
Ghassem Heidarinejad et al.
ENERGY AND BUILDINGS (2015)
Porous geopolymeric spheres for removal of Cu(II) from aqueous solution: Synthesis and evaluation
Yuanyuan Ge et al.
JOURNAL OF HAZARDOUS MATERIALS (2015)
A review on desiccant based evaporative cooling systems
M. Mujahid Rafique et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2015)
Development of paving blocks from synergistic use of red mud and fly ash using geopolymerization
Anuj Kumar et al.
CONSTRUCTION AND BUILDING MATERIALS (2013)
Passive cooling dissipation techniques for buildings and other structures: The state of the art
Mattheos Santamouris et al.
ENERGY AND BUILDINGS (2013)
The development of commercial wind towers for natural ventilation: A review
Ben Richard Hughes et al.
APPLIED ENERGY (2012)
The strength and microstructure of two geopolymers derived from metakaolin and red mud-fly ash admixture: A comparative study
Jian He et al.
CONSTRUCTION AND BUILDING MATERIALS (2012)
The effect of microwave incinerated rice husk ash on the compressive and bond strength of fly ash based geopolymer concrete
Andri Kusbiantoro et al.
CONSTRUCTION AND BUILDING MATERIALS (2012)
Synthesis and mechanical properties of new fibre-reinforced composites of inorganic polymers with natural wool fibres
Mohammad Alzeer et al.
JOURNAL OF MATERIALS SCIENCE (2012)
Technical and commercial progress in the adoption of geopolymer cement
Jannie S. J. van Deventer et al.
MINERALS ENGINEERING (2012)
Designing water resistant lightweight geopolymers produced from waste materials
Ali Nazari et al.
MATERIALS & DESIGN (2012)
Indirect evaporative cooling: Past, present and future potentials
Zhiyin Duan et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2012)
Evaporative cooling as an efficient system in Mediterranean region
Samar Jaber et al.
APPLIED THERMAL ENGINEERING (2011)
A design supporting simulation system for predicting and evaluating the cool microclimate creating effect of passive evaporative cooling walls
Jiang He
BUILDING AND ENVIRONMENT (2011)
Comparative study of the performance of the M-cycle counter-flow and cross-flow heat exchangers for indirect evaporative cooling - Paving the path toward sustainable cooling of buildings
Changhong Zhan et al.
ENERGY (2011)
On-site experimental testing of a novel dew point evaporative cooler
Frank Bruno
ENERGY AND BUILDINGS (2011)
Effect of chemical admixtures on properties of high-calcium fly ash geopolymer
Ubolluk Rattanasak et al.
INTERNATIONAL JOURNAL OF MINERALS METALLURGY AND MATERIALS (2011)
Experimental study of cooling effects of a passive evaporative cooling wall constructed of porous ceramics with high water soaking-up ability
Jiang He et al.
BUILDING AND ENVIRONMENT (2010)
Investigation of a hybrid system of nocturnal radiative cooling and direct evaporative cooling
Ghassem Heidarinejad et al.
BUILDING AND ENVIRONMENT (2010)
Effects of high-temperature heat treatment on the mechanical properties of unidirectional carbon fiber reinforced geopolymer composites
Peigang He et al.
CERAMICS INTERNATIONAL (2010)
Numerical study of a novel, dew point evaporative cooling system
B. Riangvilaikul et al.
ENERGY AND BUILDINGS (2010)
Energy performance evaluation of a novel evaporative cooling technique
B. Naticchia et al.
ENERGY AND BUILDINGS (2010)
Energy saving potential of an indirect evaporative cooler as a pre-cooling unit for mechanical cooling systems in Iran
Shahram Delfani et al.
ENERGY AND BUILDINGS (2010)
The dark side of occupants' behaviour on building energy use
O. T. Masoso et al.
ENERGY AND BUILDINGS (2010)
An experimental study of a novel dew point evaporative cooling system
B. Riangvilaikul et al.
ENERGY AND BUILDINGS (2010)
Compressive Strength and Heat Evolution of Concretes Containing Palm Oil Fuel Ash
Vanchai Sata et al.
JOURNAL OF MATERIALS IN CIVIL ENGINEERING (2010)
Fabrication of Structural Leucite Glass-Ceramics from Potassium-Based Geopolymer Precursors
Ning Xie et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2010)
Review of passive solar heating and cooling technologies
Hoy-Yen Chan et al.
RENEWABLE & SUSTAINABLE ENERGY REVIEWS (2010)
Experimental investigation of two-stage indirect/direct evaporative cooling system in various climatic conditions
Ghassem Heidarinejad et al.
BUILDING AND ENVIRONMENT (2009)
Capillary rise properties of porous mullite ceramics prepared by an extrusion method using organic fibers as the pore former
Kiyoshi Okada et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)
UTILIZATION OF ALUMINA RED MUD FOR SYNTHESIS OF INORGANIC POLYMERIC MATERIALS
Dimitrios D. Dimas et al.
Mineral Processing and Extractive Metallurgy Review (2009)
A 3D CAD-based simulation tool for prediction and evaluation of the thermal improvement effect of passive cooling walls in the developed urban locations
Jiang He et al.
SOLAR ENERGY (2009)
Numerical study of a novel counter-flow heat and mass exchanger for dew point evaporative cooling
X. Zhao et al.
APPLIED THERMAL ENGINEERING (2008)
Comparative study of heat and mass exchanging materials for indirect evaporative cooling systems
X. Zhao et al.
BUILDING AND ENVIRONMENT (2008)
Effects of RHA on autogenous shrinkage of Portland cement pastes
Gemma Rodriguez de Sensale et al.
CEMENT & CONCRETE COMPOSITES (2008)
Water-retention properties of porous ceramics prepared from mixtures of allophane and vermiculite for materials to counteract heat island effects
Kiyoshi Okada et al.
CERAMICS INTERNATIONAL (2008)
Influence of rice husk-bark ash on mechanical properties of concrete containing high amount of recycled aggregates
Weerachart Tangchirapat et al.
CONSTRUCTION AND BUILDING MATERIALS (2008)
A numerical simulation method for analyzing the thermal improvement effect of super-hydrophilic photocatalyst-coated building surfaces with water film on the urban/built environment
Jiang He et al.
ENERGY AND BUILDINGS (2008)
Effects of fiber length on mechanical properties and fracture behavior of short carbon fiber reinforced geopolymer matrix composites
Tiesong Lin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Experimental study of effect of an inner thermal curtain in evaporative cooling system of a cascade greenhouse
Ashish Shukla et al.
SOLAR ENERGY (2008)
Geopolymerization reaction to consolidate incoherent pozzolanic soil
Letizia Verdolotti et al.
JOURNAL OF MATERIALS SCIENCE (2008)
The role of inorganic polymer technology in the development of 'green concrete'
Peter Duxson et al.
CEMENT AND CONCRETE RESEARCH (2007)
Thermal effectiveness characteristics of low approach indirect evaporative cooling systems in buildings
B. Costelloe et al.
ENERGY AND BUILDINGS (2007)
Corrosion performance of rice husk ash blended concrete
V. Saraswathy et al.
CONSTRUCTION AND BUILDING MATERIALS (2007)
Strength and water permeability of concrete containing palm oil fuel ash and rice husk-bark ash
P. Chindaprasirt et al.
CONSTRUCTION AND BUILDING MATERIALS (2007)
Geopolymer technology:: the current state of the art
P. Duxson et al.
JOURNAL OF MATERIALS SCIENCE (2007)
Gas permeability and mechanical properties of porous alumina ceramics with unidirectionally aligned pores
Toshihiro Isobe et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2007)
Preparation and properties of porous alumina ceramics with uni-directionally oriented pores by extrusion method using a plastic substance as a pore former
Toshihiro Isobe et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2007)
Novel design and modelling of an evaporative cooling system for buildings
G. Q. Qiu et al.
INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2006)
Modeling of solar passive techniques for roof cooling in arid regions
D Jain
BUILDING AND ENVIRONMENT (2006)
Extrusion method using nylon 66 fibers for the preparation of porous alumina ceramics with oriented pores
Toshihiro Isobe et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2006)
Description and experimental results of a semi-indirect ceramic evaporative cooler
EV Gómez et al.
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID (2005)
Do geopolymers actually contain nanocrystalline zeolites? A reexamination of existing results
JL Provis et al.
CHEMISTRY OF MATERIALS (2005)
Fracture toughness of geopolymeric concretes reinforced with basalt fibers
DP Dias et al.
CEMENT & CONCRETE COMPOSITES (2005)
Mathematical model of indirect evaporative cooler using porous ceramic and heat pipe
SB Riffat et al.
APPLIED THERMAL ENGINEERING (2004)
Passive cooling by evapo-reflective roof for hot dry climates
H Ben Cheikh et al.
RENEWABLE ENERGY (2004)
Preparation and properties of CaO-MgO-Al2O3-SiO2 glass-ceramics from kaolin clay refining waste (Kira) and dolomite
T Toya et al.
CERAMICS INTERNATIONAL (2004)
Passive down-draught evaporative cooling: Thermal modelling of an office building
D Robinson et al.
INDOOR AND BUILT ENVIRONMENT (2004)
Performance of porous ceramic evaporators for building cooling application
E Ibrahim et al.
ENERGY AND BUILDINGS (2003)
Modeling and experimental validation of a greenhouse with evaporative cooling by moving water film over external shade cloth
MK Ghosal et al.
ENERGY AND BUILDINGS (2003)
Thermoeconomic analysis of an evaporative desiccant air conditioning system
JR Camargo et al.
APPLIED THERMAL ENGINEERING (2003)
A new ideal evaporative freezing cycle
Y Cerci
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2003)
Modeling and optimal design of evaporative cooling system in controlled environment greenhouse
DL Jain et al.
ENERGY CONVERSION AND MANAGEMENT (2002)
Rate of pozzolanic reaction of metakaolin in high-performance cement pastes
CS Poon et al.
CEMENT AND CONCRETE RESEARCH (2001)
Energy-saving potential of an indirect evaporative cooler
GP Maheshwari et al.
APPLIED ENERGY (2001)
Porous mullite ceramics from national clay produced by gelcasting
YF Liu et al.
CERAMICS INTERNATIONAL (2001)