Related references
Note: Only part of the references are listed.Dynamic thermal performance of conventional and alternative building wall envelopes
N. C. Balaji et al.
JOURNAL OF BUILDING ENGINEERING (2019)
Experimental and theoretical studies of various solar control window glasses for the reduction of cooling and heating loads in buildings across different climatic regions
Kiran G. Kumar et al.
ENERGY AND BUILDINGS (2018)
Optimizing the position of insulating materials in flat roofs exposed to sunshine to gain minimum heat into buildings under periodic heat transfer conditions
Saboor Shaik et al.
ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH (2016)
Influence of ambient air relative humidity and temperature on thermal properties and unsteady thermal response characteristics of laterite wall houses
Saboor Shaik et al.
BUILDING AND ENVIRONMENT (2016)
Economic optimization of PCM and insulation layer thickness in residential buildings
Amir Baniassadi et al.
SUSTAINABLE ENERGY TECHNOLOGIES AND ASSESSMENTS (2016)
Assessing and improving the thermal performance of reinforced concrete-based roofing systems in Iraq
Khalid B. Najim et al.
ENERGY AND BUILDINGS (2015)
Thermal lag and decrement factor of a coconut-ferrocement roofing system
R. Alavez-Ramirez et al.
CONSTRUCTION AND BUILDING MATERIALS (2014)
External load-bearing walls configuration of residential buildings in Iraq and their thermal performance and dynamic thermal behaviour
Khalid B. Najim
ENERGY AND BUILDINGS (2014)
The influence of concrete density and conductivity on walls' thermal inertia parameters under a variety of masonry and insulation placements
K. J. Kontoleon et al.
APPLIED ENERGY (2013)
A dynamic parameter to describe the thermal response of buildings to radiant heat gains
G. Evola et al.
ENERGY AND BUILDINGS (2013)
On the error of calculation of heat gains through walls by methods using constant decrement factor and time lag values
C. R. Ruivo et al.
ENERGY AND BUILDINGS (2013)
Numerical estimation of time lags and decrement factors for wall complexes including Multilayer Thermal Insulation, in two different climatic zones
Lazaros Elias Mavromatidis et al.
APPLIED ENERGY (2012)
Thermal performance of ventilated roofs during summer period
A. Gagliano et al.
ENERGY AND BUILDINGS (2012)
Thermal inertia of newspaper sandwiched aerated lightweight concrete wall panels: Experimental study
Soon-Ching Ng et al.
ENERGY AND BUILDINGS (2011)
A study on optimum insulation thicknesses of external walls in hot summer and cold winter zone of China
Jinghua Yu et al.
APPLIED ENERGY (2009)
Assessing the moisture-content-dependent parameters of stabilised earth materials using the cyclic-response admittance method
Matthew Hall et al.
ENERGY AND BUILDINGS (2008)
The influence of wall orientation and exterior surface solar absorptivity on time lag and decrement factor in the Greek region
K. J. Kontoleon et al.
RENEWABLE ENERGY (2008)
Optimum location and distribution of insulation layers on building walls with various orientations
M. Ozel et al.
BUILDING AND ENVIRONMENT (2007)
Experimental and theoretical investigation of effects of wall's thermophysical properties on time lag and decrement factor
K Ulgen
ENERGY AND BUILDINGS (2002)
Share Paper
