Related references
Note: Only part of the references are listed.Comparative study on substitute triggering approaches for internal short circuit in lithium-ion batteries
Lishuo Liu et al.
APPLIED ENERGY (2020)
Computational identification of the safety regime of Li-ion battery thermal runaway
Liwen Zhang et al.
APPLIED ENERGY (2020)
A comprehensive study on thermal conductivity of the lithium-ion battery
Lichuan Wei et al.
INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2020)
Self-adapting J-type air-based battery thermal management system via model predictive control
Yuanzhi Liu et al.
APPLIED ENERGY (2020)
Thermal analysis of a 6s4p Lithium-ion battery pack cooled by cold plates based on a multi-domain modeling framework
Hongya Zhang et al.
APPLIED THERMAL ENGINEERING (2020)
Investigation on thermal performance of water-cooled Li-ion pouch cell and pack at high discharge rate with U-turn type microchannel cold plate
Mahesh Suresh Patil et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Thermal Management of Li-Ion Batteries With Single-Phase Liquid Immersion Cooling
David W. Sundin et al.
IEEE OPEN JOURNAL OF VEHICULAR TECHNOLOGY (2020)
Heat and mass transfer modeling and investigation of multiple LiFePO4/graphite batteries in a pack at low C-rates with water-cooling
S. Panchal et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Experimental and numerical study on a novel hybrid battery thermal management system integrated forced-air convection and phase change material
Peng Qin et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
Experiment and simulation for pouch battery with silica cooling plates and copper mesh based air cooling thermal management system
Xinxi Li et al.
APPLIED THERMAL ENGINEERING (2019)
Three-dimensional thermal modeling of Li-ion battery cell and 50 V Li-ion battery pack cooled by mini-channel cold plate
Yubai Li et al.
APPLIED THERMAL ENGINEERING (2019)
Effects of different coolants and cooling strategies on the cooling performance of the power lithium ion battery system: A review
Yuanwang Deng et al.
APPLIED THERMAL ENGINEERING (2018)
Heat Generation Characteristics of LiFePO4 Pouch Cells with Passive Thermal Management
Soham Neupane et al.
ENERGIES (2018)
Cooling Performance Characteristics of 20 Ah Lithium-Ion Pouch Cell with Cold Plates along Both Surfaces
Mahesh Suresh Patil et al.
ENERGIES (2018)
A comprehensive review on a passive (phase change materials) and an active (thermoelectric cooler) battery thermal management system and their limitations
Abu Raihan Mohammad Siddique et al.
JOURNAL OF POWER SOURCES (2018)
Modeling the Effects of Thermal Gradients Induced by Tab and Surface Cooling on Lithium Ion Cell Performance
Yan Zhao et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2018)
Thermal runaway mechanism of lithium ion battery for electric vehicles: A review
Xuning Feng et al.
ENERGY STORAGE MATERIALS (2018)
Experimental investigation on the thermal performance of heat pipe-assisted phase change material based battery thermal management system
Weixiong Wu et al.
ENERGY CONVERSION AND MANAGEMENT (2017)
Thermal issues about Li-ion batteries and recent progress in battery thermal management systems: A review
Huaqiang Liu et al.
ENERGY CONVERSION AND MANAGEMENT (2017)
Transient electrochemical heat transfer modeling and experimental validation of a large sized LiFePO4/graphite battery
S. Panchal et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2017)
Thermal management performances of PCM/water cooling-plate using for lithium-ion battery module based on non-uniform internal heat source
Fanfei Bai et al.
APPLIED THERMAL ENGINEERING (2017)
An investigation of irreversible heat generation in lithium ion batteries based on a thermo-electrochemical coupling method
Shuanglong Du et al.
APPLIED THERMAL ENGINEERING (2017)
Computational fluid dynamic and thermal analysis of Lithium-ion battery pack with air cooling
Lip Huat Saw et al.
APPLIED ENERGY (2016)
Comparison of different cooling methods for lithium ion battery cells
Dafen Chen et al.
APPLIED THERMAL ENGINEERING (2016)
Measuring and assessing the effective in-plane thermal conductivity of lithium iron phosphate pouch cells
Sj. Bazinski et al.
ENERGY (2016)
Surface Cooling Causes Accelerated Degradation Compared to Tab Cooling for Lithium-Ion Pouch Cells
Ian A. Hunt et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2016)
Thermal analysis of large-capacity LiFePO4 power batteries for electric vehicles
Chunjing Lin et al.
JOURNAL OF POWER SOURCES (2015)
Thermal Design for the Pouch-Type Large-Format Lithium-Ion Batteries I. Thermo-Electrical Modeling and Origins of Temperature Non-Uniformity
Bin Wu et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2015)
Thermal analysis of high-power lithium-ion battery packs using flow network approach
G. Karimi et al.
INTERNATIONAL JOURNAL OF ENERGY RESEARCH (2014)
An experimental study of lithium ion battery thermal management using flexible hydrogel films
Rui Zhao et al.
JOURNAL OF POWER SOURCES (2014)
Battery cell arrangement and heat transfer fluid effects on the parasitic power consumption and the cell temperature distribution in a hybrid electric vehicle
Sungjin Park et al.
JOURNAL OF POWER SOURCES (2013)
A parametric study on thermal management of an air-cooled lithium-ion battery module for plug-in hybrid electric vehicles
Liwu Fan et al.
JOURNAL OF POWER SOURCES (2013)
Modeling the temperature dependence of the discharge behavior of a lithium-ion battery in low environmental temperature
Jaeshin Yi et al.
JOURNAL OF POWER SOURCES (2013)
Three-Dimensional Thermal Modeling of a Lithium-Ion Battery Considering the Combined Effects of the Electrical and Thermal Contact Resistances between Current Collecting Tab and Lead Wire
Jaeshin Yi et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2013)
Multi-Domain Modeling of Lithium-Ion Batteries Encompassing Multi-Physics in Varied Length Scales
Gi-Heon Kim et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2011)
Modeling for the scale-up of a lithium-ion polymer battery
Ui Seong Kim et al.
JOURNAL OF POWER SOURCES (2009)
Effect of electrode configuration on the thermal behavior of a lithium-polymer battery
Ui Seong Kim et al.
JOURNAL OF POWER SOURCES (2008)
A two-dimensional modeling of a lithium-polymer battery
Ki Hyun Kwon et al.
JOURNAL OF POWER SOURCES (2006)
Thermal model of cylindrical and prismatic lithium-ion cells
TD Hatchard et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2001)
Share Paper
