Related references
Note: Only part of the references are listed.Effect of Ni addition on the mechanical and degradation properties of hollow glass microsphere/Mg alloy composites
Lin Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2021)
Tribological effects of carbon nanotubes on magnesium alloy AZ31 and analyzing aging effects on CNTs/AZ31 composites fabricated by stir casting process
Aqeel Abbas et al.
TRIBOLOGY INTERNATIONAL (2020)
TiO2-Induced In Situ Reaction in Graphene Oxide-Reinforced AZ61 Biocomposites to Enhance the Interfacial Bonding
Cijun Shuai et al.
ACS APPLIED MATERIALS & INTERFACES (2020)
Enhanced mechanical properties and degradation rate of Mg-Ni-Y alloy by introducing LPSO phase for degradable fracturing ball applications
Jingfeng Wang et al.
JOURNAL OF MAGNESIUM AND ALLOYS (2020)
Microstructures and electrochemical behaviors of as-cast magnesium alloys with enhanced compressive strengths and corrosion decomposition
Xuewu Li et al.
MATERIALS AND CORROSION-WERKSTOFFE UND KORROSION (2020)
Preparation and properties of hollow glass microspheres reinforced Mg alloy degradable composites
Lin Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
Effect of CNT on microstructure, dry sliding wear and compressive mechanical properties of AZ61 magnesium alloy
Song Jeng Huang et al.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T (2019)
Al-water reactivity of Al-Mg-Ga-In-Sn alloys used for hydraulic fracturing tools
B. D. Du et al.
INTERNATIONAL JOURNAL OF HYDROGEN ENERGY (2018)
A new openhole multistage hydraulic fracturing system and the ball plug motion in a horizontal pipe
Benchun Yao et al.
JOURNAL OF NATURAL GAS SCIENCE AND ENGINEERING (2018)
Experience curve for natural gas production by hydraulic fracturing
Rokuhei Fukui et al.
ENERGY POLICY (2017)
Analysis of interface between components in AZ91 magnesium alloy foam composite with Ni-P coated fly ash cenospheres
K. N. Braszczynska-Malik et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Synthesis and characterization of hollow glass microspheres reinforced magnesium alloy matrix syntactic foam
G. Anbuchezhiyan et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Dissolvable fracturing tool based on a controlled electrolytic method
Chao Zheng et al.
JOURNAL OF PETROLEUM SCIENCE AND ENGINEERING (2017)
Enhanced mechanical properties and degradation rate of Mg-3Zn-1Y based alloy by Cu addition for degradable fracturing ball applications
Yuezhong Zhang et al.
MATERIALS LETTERS (2017)
Microstructure, mechanical properties, and corrosion behavior of degradable Mg-Al-Cu-Zn-Gd alloys
Zhenwei Geng et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
Finite element analysis and experimental study on the deformation characteristics of an aluminum alloy fracturing ball
Chao Zheng et al.
JOURNAL OF NATURAL GAS SCIENCE AND ENGINEERING (2016)
Effects of Alloying Elements on Microstructure and Properties of Magnesium Alloys for Tripling Ball
D. H. Xiao et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2015)
The effect of fluoride ions on the corrosion behavior of pure titanium in 0.05 M sulfuric acid
Z. B. Wang et al.
ELECTROCHIMICA ACTA (2014)
Disintegrating fracturing ball used in ball injection sliding sleeve for staged fracturing
Pei Xiaohan et al.
PETROLEUM EXPLORATION AND DEVELOPMENT (2014)
Fabrication, microstructure and compressive behavior of ZC63 Mg-microballoon foam composites
A. Daoud et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2007)
Electrochemical characteristics of intermetallic phases in aluminum alloys - An experimental survey and discussion
N Birbilis et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2005)
Evaluation of exfoliation susceptibility by means of the electrochemical impedance spectroscopy
A Conde et al.
CORROSION SCIENCE (2000)