Related references
Note: Only part of the references are listed.Energy, exergy, environmental, and economic modeling of combined cooling, heating and power system with Stirling engine and absorption chiller
Mohammad Sheykhi et al.
ENERGY CONVERSION AND MANAGEMENT (2019)
Analyzing and validating the economic efficiency of managing a cluster of energy hubs in multi-carrier energy systems
Yue Chen et al.
APPLIED ENERGY (2018)
Influence analysis of building energy demands on the optimal design and performance of CCHP system by using statistical analysis
G. Yang et al.
ENERGY AND BUILDINGS (2017)
GA/AHP-based optimal design of a hybrid CCHP system considering economy, energy and emission
Hossein Yousefi et al.
ENERGY AND BUILDINGS (2017)
Markov Chain Monte Carlo Simulation Methods for Structural Reliability Analysis
Carsten Proppe
X INTERNATIONAL CONFERENCE ON STRUCTURAL DYNAMICS (EURODYN 2017) (2017)
A general model for energy hub economic dispatch
Soheil Derafshi Beigvand et al.
APPLIED ENERGY (2017)
Combined energy hub optimisation and demand side management for buildings
Marko Batic et al.
ENERGY AND BUILDINGS (2016)
Evaluation and sizing of a CCHP system for a commercial and office buildings
Pedram Hanafizadeh et al.
JOURNAL OF BUILDING ENGINEERING (2016)
Modeling the reliability of multi-carrier energy systems considering dynamic behavior of thermal loads
Mohammad-Hossein Shariatkhah et al.
ENERGY AND BUILDINGS (2015)
A probability constrained multi-objective optimization model for CCHP system operation decision support
Mengqi Hu et al.
APPLIED ENERGY (2014)
Multi-objective optimization of a novel solar-based multigeneration energy system
Pouria Ahmadi et al.
SOLAR ENERGY (2014)
Reliability and availability analysis of redundant BCHP (building cooling, heating and power) system
Jiang-Jiang Wang et al.
ENERGY (2013)
Application of the multi-objective optimization and risk analysis for the sizing of a residential small-scale CCHP system
Hoseyn Sayyaadi Gholamhossein Abdollahi
ENERGY AND BUILDINGS (2013)
Multi-objective approach in thermoenvironomic optimization of a small-scale distributed CCHP system with risk analysis
Gh Abdollahi et al.
ENERGY AND BUILDINGS (2011)
Reliability and availability modelling of combined heat and power (CHP) systems
Mahmood Reza Haghifam et al.
INTERNATIONAL JOURNAL OF ELECTRICAL POWER & ENERGY SYSTEMS (2011)
Analysis of combined cooling, heating, and power systems based on source primary energy consumption
Nelson Fumo et al.
APPLIED ENERGY (2010)
Economic and environmental evaluation of micro CHP systems with different operating modes for residential buildings in Japan
Hongbo Ren et al.
ENERGY AND BUILDINGS (2010)
Markov-chain based reliability analysis for distributed systems
JL Wang
COMPUTERS & ELECTRICAL ENGINEERING (2004)
Share Paper
