4.8 Article

Cracking criterion for high strength Al-Cu alloys fabricated by selective laser melting

Journal

ADDITIVE MANUFACTURING
Volume 37, Issue -, Pages -

Publisher

ELSEVIER
DOI: 10.1016/j.addma.2020.101709

Keywords

Additive manufacturing; Selective laser melting; Aluminum alloys; Solidification cracking; Cracking criterion

Funding

  1. National Natural Science Foundation of China [51805184]

Ask authors/readers for more resources

This study developed a model based on modified Rosenthal's equation and Feurer's criterion to predict the critical scanning velocity for crack initiation during SLM of Al-Cu alloys. The model suggests that the molten pool center is most susceptible to crack initiation, and a small hatch spacing is beneficial for manufacturing crack-free components. Factors such as mushy zone length and cooling rate mainly affect cracking in the process.
Cracking is one of the most serious problems for the development of selective laser melting (SLM) of high strength aluminum alloys. The process parameters applied in the SLM process determine the cracking severity in these alloys. The purpose of this study is to understand the correlation between the process and the solidification cracking during SLM of Al-Cu alloys. A model based on the modified Rosenthal's equation and Feurer's criterion was developed to predict the critical scanning velocity for the crack initiation during SLM. The calculated result shows that the molten pool center is the most susceptible to the crack initiation in the conductive molten pool, and the susceptibility increases as the distance from the observed point to the molten pool center increases. The overlapping of the molten pool can remelt the previous track, and thus the crack initiating during the previous scanning may be eliminated after the remelting. Therefore, a small hatch spacing is beneficial for manufacturing the crack-fre components. The cracking is mainly affected by the mushy zone length and the cooling rate during the process. Hence, the composition strongly affects the cracking. Not only the solidification temperature range but also other thermo-physical properties affect cracking. The model was verified by two different Al-Cu alloys. The cracking initiation and the crack length were observed and measured to evaluate the applicability of the model. The experimental data and the calculation results agree well. The model can be used for the process control as well as the alloy development for SLM of Al-Cu alloys.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available