Related references
Note: Only part of the references are listed.Simultaneous enhancement of strength and ductility in a NiCoCrFe high-entropy alloy upon dynamic tension: Micromechanism and constitutive modeling
T. W. Zhang et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2020)
Deformation behaviors of various Fe-Mn-C twinning-induced plasticity steels: effect of stacking fault energy and chemical composition
Joong-Ki Hwang
JOURNAL OF MATERIALS SCIENCE (2020)
Effect of Si addition on microstructure and mechanical properties of Al-Mg-Si-Zn alloy
Fan-bo Meng et al.
CHINA FOUNDRY (2020)
Mechanical properties and deformation behavior of dual-phase Al0.6CoCrFeNi high-entropy alloys with heterogeneous structure at room and cryogenic temperatures
Q. Li et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
On the formation of hierarchical microstructure in a Mo-doped NiCoCr medium-entropy alloy with enhanced strength-ductility synergy
Junyang He et al.
SCRIPTA MATERIALIA (2020)
Yield strength increase of a CoCrNi medium entropy alloy by interstitial nitrogen doping at maintained ductility
Igor Moravcik et al.
SCRIPTA MATERIALIA (2020)
Short-range order strengthening in boron-doped high-entropy alloys for cryogenic applications
Jae Bok Seol et al.
ACTA MATERIALIA (2020)
Metastability driven hierarchical microstructural engineering: Overview of mechanical properties of metastable complex concentrated alloys
R. S. Mishra et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
Interstitial doping enhances the strength-ductility synergy in a CoCrNi medium entropy alloy
Igor Moravcik et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Effects of Hf on the microstructure and mechanical properties of CoCrFeNi high entropy alloy
Huan Ma et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2020)
Enhanced strength-ductility synergy in ultrafine-grained eutectic high-entropy alloys by inheriting microstructural lamellae
Peijian Shi et al.
NATURE COMMUNICATIONS (2019)
Effect of μ-precipitates on the microstructure and mechanical properties of non-equiatomic CoCrFeNiMo medium-entropy alloys
Jae Wung Bae et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2019)
A novel FeCoNiCr0.2Si0.2 high entropy alloy with an excellent balance of mechanical and soft magnetic properties
Hang Zhang et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2019)
Effect of carbon on cryogenic tensile behavior of CoCrFeMnNi-type high entropy alloys
M. Klimova et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2019)
Ultrastrong Medium-Entropy Single-Phase Alloys Designed via Severe Lattice Distortion
Seok Su Sohn et al.
ADVANCED MATERIALS (2019)
Novel Co-rich high entropy alloys with superior tensile properties
Daixiu Wei et al.
MATERIALS RESEARCH LETTERS (2019)
Boron doped ultrastrong and ductile high-entropy alloys
Jae Bok Seol et al.
ACTA MATERIALIA (2018)
Dynamic shear deformation of a CrCoNi medium-entropy alloy with heterogeneous grain structures
Yan Ma et al.
ACTA MATERIALIA (2018)
Tensile properties and deformation mode of Si-added Fe-18Mn-0.6C steels
Sang-Min Lee et al.
ACTA MATERIALIA (2018)
Twinning-induced plasticity (TWIP) steels
Bruno C. De Cooman et al.
ACTA MATERIALIA (2018)
Computational thermodynamic and first-principles calculation of stacking fault energy on ternary Co-based alloys
Tria Laksana Achmad et al.
COMPUTATIONAL MATERIALS SCIENCE (2018)
Effects of processing route on phase evolution and mechanical properties of CoCrCuFeNiSix high entropy alloys
Anil Kumar et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2018)
Effect of C content on microstructure and tensile properties of as-cast CoCrFeMnNi high entropy alloy
Jian Chen et al.
MATERIALS CHEMISTRY AND PHYSICS (2018)
The oxidation behavior of the quinary FeCoNiCrSix high-entropy alloys
W. Kai et al.
MATERIALS CHEMISTRY AND PHYSICS (2018)
Microstructure and properties of laser re-melting FeCoCrNiAl0.5Six. high-entropy alloy coatings
Bingqian Jin et al.
SURFACE & COATINGS TECHNOLOGY (2018)
Effect of Si addition and applied pressure on microstructure and tensile properties of as-cast Al-5.0Cu-0.6Mn-1.2Fe alloys
Wei-wen Zhang et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2018)
Cryogenic-deformation-induced phase transformation in an FeCoCrNi high-entropy alloy
Qingyun Lin et al.
MATERIALS RESEARCH LETTERS (2018)
A novel method to enhance CSL fraction, tensile properties and work hardening in complex concentrated alloys - Lattice distortion effect
Mageshwari Komarasamy et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Influence of Si addition on the carbon partitioning process in martensitic-austenitic stainless steels
Q. Huang et al.
20TH CHEMNITZ SEMINAR ON MATERIALS ENGINEERING (2018)
Interpretation of quasi-static and dynamic tensile behavior by digital image correlation technique in TWinning Induced Plasticity (TWIP) and low-carbon steel sheets
Minju Kang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Competitive effect of stacking fault energy and short-range clustering on the plastic deformation behavior of Cu-Ni alloys
Z. Y. Wang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Local Structure and Short-Range Order in a NiCoCr Solid Solution Alloy
F. X. Zhang et al.
PHYSICAL REVIEW LETTERS (2017)
High pressure synthesis of a hexagonal close-packed phase of the high-entropy alloy CrMnFeCoNi
Cameron L. Tracy et al.
NATURE COMMUNICATIONS (2017)
Effects of Trace Si Addition on the Microstructures and Tensile Properties of Ti-3Al-8V-6Cr-4Mo-4Zr Alloy
Hongbo Ba et al.
METALS (2017)
Shear and shuffling accomplishing polymorphic fcc γ → hcp ε → bct α martensitic phase transformation
Xu-Sheng Yang et al.
ACTA MATERIALIA (2017)
The evolution of the deformation substructure in a Ni-Co-Cr equiatomic solid solution alloy
J. Miao et al.
ACTA MATERIALIA (2017)
A TRIP-assisted dual-phase high-entropy alloy: Grain size and phase fraction effects on deformation behavior
Zhiming Li et al.
ACTA MATERIALIA (2017)
Unified factor controlling the dislocation evolution of fatigued face-centered cubic crystals
P. Li et al.
ACTA MATERIALIA (2017)
Reasons for the superior mechanical properties of medium-entropy CrCoNi compared to high-entropy CrMnFeCoNi
G. Laplanche et al.
ACTA MATERIALIA (2017)
Review: Overcoming the paradox of strength and ductility in ultrafine-grained materials at low temperatures
Praveen Kumar et al.
JOURNAL OF MATERIALS SCIENCE (2016)
Microstructure evolution and critical stress for twinning in the CrMnFeCoNi high-entropy alloy
G. Laplanche et al.
ACTA MATERIALIA (2016)
Metastable high-entropy dual-phase alloys overcome the strength-ductility trade-off
Zhiming Li et al.
NATURE (2016)
Effects of Si addition on microstructure, mechanical and thermal fatigue properties of Zn-38Al-2.5Cu alloys
Ting Liu et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2016)
Design of a twinning-induced plasticity high entropy alloy
Y. Deng et al.
ACTA MATERIALIA (2015)
Influences of silicon on the work hardening behavior and hot deformation behavior of Fe-25 wt%Mn-(Si, Al) TWIP steel
Dejun Li et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
On the microstructures, phase assemblages and properties of Al0.5CoCrCuFeNiSix high-entropy alloys
Xiaotao Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Analysis of the twin spacing and grain size effects on mechanical properties in hierarchically nanotwinned face-centered cubic metals based on a mechanism-based plasticity model
Linli Zhu et al.
JOURNAL OF THE MECHANICS AND PHYSICS OF SOLIDS (2015)
Lattice strain framework for plastic deformation in complex concentrated alloys including high entropy alloys
R. S. Mishra et al.
MATERIALS SCIENCE AND TECHNOLOGY (2015)
Effect of minor B addition on microstructure and properties of AlCoCrFeNi multi-compenent alloy
Qiu-shi Chen et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2015)
Effects of Al and Si addition on the structure and properties of CoFeNi equal atomic ratio alloy
T. T. Zuo et al.
JOURNAL OF MAGNETISM AND MAGNETIC MATERIALS (2014)
The effects of Si on the mechanical twinning and strain hardening of Fe-18Mn-0.6C twinning-induced plasticity steel
Kookhyun Jeong et al.
ACTA MATERIALIA (2013)
The influences of temperature and microstructure on the tensile properties of a CoCrFeMnNi high-entropy alloy
F. Otto et al.
ACTA MATERIALIA (2013)
Effects of Si addition on mechanical properties of Ti-5Al-5V-5Mo-3Cr alloy
Dongyang Qin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Effect of copper addition on the microstructure and shape recovery of Fe-Mn-Si-Cr-Ni shape memory alloys
Bikas C. Maji et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Effect of Si-addition as a grain refiner on microstructure and properties of Ti-6Al-4V Alloy
Khaled M. Ibrahim et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2013)
Ultrastrong Mg Alloy via Nano-spaced Stacking Faults
W. W. Jian et al.
MATERIALS RESEARCH LETTERS (2013)
Effect of Si and Fe on the Recrystallization Response of Al-Mn Alloys with Zr Addition
M. Karlik et al.
ACTA PHYSICA POLONICA A (2012)
On the role of hierarchical twins for achieving maximum yield strength in nanotwinned metals
Linli Zhu et al.
APPLIED PHYSICS LETTERS (2012)
Reducing Vehicle Weight and Improving U.S. Energy Efficiency Using Integrated Computational Materials Engineering
William J. Joost
JOM (2012)
Work hardening of polycrystalline Cu with nanoscale twins
L. Lu et al.
SCRIPTA MATERIALIA (2012)
Thermodynamic modeling of the stacking fault energy of austenitic steels
S. Curtze et al.
ACTA MATERIALIA (2011)
Synthesis and properties of multiprincipal component AlCoCrFeNiSix alloys
J. M. Zhu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2010)
Nucleation and growth during primary recrystallization of certain metals and alloys with a face-centered cubic structure: Formation of the cube texture
Richard Penelle
INTERNATIONAL JOURNAL OF MATERIALS RESEARCH (2009)
Solidification microstructures and mechanical properties of high-vanadium Fe-C-V and Fe-C-V-Si alloys
E. Fras et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2009)
Structural materials for fission & fusion energy
Steven J. Zinkle et al.
MATERIALS TODAY (2009)
Self-thickening, cross-slip deformation twinning model
J. Narayan et al.
APPLIED PHYSICS LETTERS (2008)
Simultaneously increasing the ductility and strength of nanostructured alloys
Yong-Hao Zhao et al.
ADVANCED MATERIALS (2006)
Effects of carbon on microstructures and properties of high vanadium high-speed steel
SZ Wei et al.
MATERIALS & DESIGN (2006)
Correlations between the calculated stacking fault energy and the plasticity mechanisms in Fe-Mn-C alloys
S Allain et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)
Effect of silicon on the interaction between recrystallization and precipitationin niobium microalloyed steels
L Jiang et al.
ISIJ INTERNATIONAL (2004)
Effect of Cu, Cr and Ni on mechanical properties of 0.15 wt.% C TRIP-aided cold rolled steels
SJ Kim et al.
SCRIPTA MATERIALIA (2003)
An investigation of the silicon role on austenite recrystallization
S Serajzadeh et al.
MATERIALS LETTERS (2002)
Nucleation and growth of deformation twins:: a perspective based on the double-cross-slip mechanism of deformation twinning
KPD Lagerlöf et al.
PHILOSOPHICAL MAGAZINE A-PHYSICS OF CONDENSED MATTER STRUCTURE DEFECTS AND MECHANICAL PROPERTIES (2002)
Effects of heat treatment and Si addition on the mechanical properties of 0.1 wt% C TRIP-aided cold-rolled steels
CG Lee et al.
ISIJ INTERNATIONAL (2002)
High strength Fe-Mn-(Al, Si) TRIP/TWIP steels development - properties - application
O Grassel et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2000)
Share Paper
