Induction melt thermoforming of advanced multi-axial thermoplastic composite laminates

The viability of using induction heating to facilitate the wrinkle-free forming of multi-axial pre-consolidated advanced thermoplastic composites over complex geometries is explored. The research focuses on the use of tin as a medium to both heat and lubricate the forming laminate. Initial tests demonstrate the viability of the fundamental ideas of the process; induction heating is used to melt the tin sheet, which is then shown to melt the matrix phase of carbon-nylon composite laminates when stacked in a hybrid composite/tin layup. A novel low-cost reconfigurable multi-step forming tool is used to demonstrate how most of the tin can be squeezed out of the layup prior to consolidation. The multi-step tool can be augmented with segmented tooling to rapidly manufacture composite parts of high geometric complexity. In this investigation, a 'ripple' geometry containing three 'cavities' is used to demonstrate the technique. Tests demonstrated that at least three sheets of inter-laminar tin can be simultaneously melted using the induction heating system. Initial results indicate complex geometries can be formed with minimal wrinkling while removing interlaminar tin.