4.6 Article

Bioelectrochemical Greywater Treatment for Non-Potable Reuse and Energy Recovery

Journal

WATER
Volume 13, Issue 3, Pages -

Publisher

MDPI
DOI: 10.3390/w13030295

Keywords

greywater; non-potable reuse; microbial fuel cell; bioelectrochemical systems; bioenergy; conductivity

Ask authors/readers for more resources

Greywater treatment is a crucial part of wastewater management in buildings, and MFCs provide a sustainable solution for efficient organic matter removal and energy production. Different conductivity levels of greywater did not affect the removal of organic matter in MFCs, but low conductivity greywater hindered energy generation, highlighting the need for further research and improvements.
Greywater normally represents the largest fraction of wastewater generated in buildings and may be suitable for non-potable reuse after on-site treatment. Conventional technologies for greywater treatment include sequencing batch reactors, membrane filtration, and membrane biological reactors. Even though these can be very effective, they are highly energy consuming and may negatively impact the energy balance of the building where they are installed. Microbial fuel cells (MFCs) have emerged as a sustainable technology for contaminant removal and energy production from a variety of substrates. In this study, the application of MFCs for greywater treatment is reported, with a particular focus on the analysis of energy losses, in view of non-potable reuse. MFCs were fed with different types of greywater, characterized by either high or low conductivity, because greywater's conductivity may greatly differ based on its origin; in either case, organic matter (chemical oxygen demand; COD) removal was higher than 85% and not influenced by the influent conductivity, coupled with a maximum power production of 0.46 mW L-1 and 0.38 mW L-1. Electrolyte overpotentials were dramatically higher in the case of low conductivity greywater (20% vs. 10%, compared to high conductivity influent); these overpotentials are related to the conductivity of the influent, showing that low conductivity hindered energy generation, but not COD removal. Polarization and power curves showed higher internal resistance in the case of low conductivity, confirming the overpotentials' analysis. Results showed the feasibility of the use of MFCs in greywater treatment, with potential to reduce the energy demand connected to its reuse compared to conventional technologies; coupling with a disinfection stage would be necessary to fully comply with most non-potable reuse regulations.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available