Related references
Note: Only part of the references are listed.Linear complementarity solution of 2D boundary slip EHL contact
Y. Zhao et al.
TRIBOLOGY INTERNATIONAL (2020)
Variation of zero entraining velocity dimple in grease-lubricated reciprocating motion
Shanshan Wang et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2019)
Numerical simulation of lubricated DLC-coated point contacts under infinite sliding conditions
Jonathan Raisin et al.
TRIBOLOGY INTERNATIONAL (2019)
Solving coupled boundary slip and heat transfer EHL problem under large slide-roll ratio conditions
Y. Zhao et al.
TRIBOLOGY INTERNATIONAL (2019)
EHL film formation under zero entrainment velocity condition
Y. Zhao et al.
TRIBOLOGY INTERNATIONAL (2018)
Facilitating effective hydrodynamic lubrication for zero-entrainment-velocity contacts based on boundary slip mechanism
P. L. Wong et al.
TRIBOLOGY INTERNATIONAL (2018)
Effect of Sliding Direction on EHL Film Shape Under High Sliding Conditions
M. Omasta et al.
TRIBOLOGY TRANSACTIONS (2017)
Effects of viscosity and sliding speed on boundary slippage in thin film hydrodynamic lubrication
L. Guo et al.
TRIBOLOGY INTERNATIONAL (2017)
Experimental and Numerical Investigation of Inlet Dimple in Point and Elliptical Contact Elastohydrodynamic Lubrication Films
Xuefeng Wang et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2016)
Bridging high pressure rheology and film-forming capacity of polymer-base oil solutions in EHL
C. Mary et al.
TRIBOLOGY INTERNATIONAL (2016)
Fully coupled EHL model for simulation of finite length line cam-roller follower contacts
M. Shirzadegan et al.
TRIBOLOGY INTERNATIONAL (2016)
Boundary Yield Stress and Interfacial Potential Energy Barrier in Thin Film Hydrodynamic Lubrication
L. Guo et al.
TRIBOLOGY LETTERS (2016)
Effect of fluid rheology on the thermal EHL under ZEV in line contact
Binbin Zhang et al.
TRIBOLOGY INTERNATIONAL (2015)
Evidence of lubricant slip on steel surface in EHL contact
P. L. Wong et al.
TRIBOLOGY INTERNATIONAL (2013)
Effect of Interfacial Properties on EHL Under Pure Sliding Conditions
Z. Fu et al.
TRIBOLOGY LETTERS (2013)
New Insight into the Relationship Between Molecular Effects and the Rheological Behavior of Polymer-Thickened Lubricants Under High Pressure
C. Mary et al.
TRIBOLOGY LETTERS (2013)
The Effect of Wetting and Surface Energy on the Friction and Slip in Oil-Lubricated Contacts
M. Kalin et al.
TRIBOLOGY LETTERS (2013)
A Model for Line-Contact EHL Problems-Consideration of Effects of Navier-Slip and Lubricant Rheology
Li-Ming Chu et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2012)
The Influence of DLC Coating on EHL Friction Coefficient
M. Bjorling et al.
TRIBOLOGY LETTERS (2012)
Wall slip and hydrodynamics of two-dimensional journal bearing
G. J. Ma et al.
TRIBOLOGY INTERNATIONAL (2007)
A low friction bearing based on liquid slip at the wall
J. H. Choo et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2007)
Film pressure distributions in point contacts predicted by thermal EHL analyses
Motohiro Kaneta et al.
TRIBOLOGY INTERNATIONAL (2006)
Equation for slip of simple liquids at smooth solid surfaces
H Spikes et al.
LANGMUIR (2003)
The half-wetted bearing. Part 1: extended Reynolds equation
HA Spikes
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2003)
Film formation in EHL point contacts under zero entraining velocity conditions
F Guo et al.
TRIBOLOGY TRANSACTIONS (2002)
Limits of the hydrodynamic no-slip boundary condition
YX Zhu et al.
PHYSICAL REVIEW LETTERS (2002)
Rate-dependent slip of Newtonian liquid at smooth surfaces
YX Zhu et al.
PHYSICAL REVIEW LETTERS (2001)
On the thermal elastohydrodynamic lubrication in opposite sliding circular contacts
F Guo et al.
TRIBOLOGY INTERNATIONAL (2001)
Formation of steady dimples in point TEHL contacts
P Yang et al.
JOURNAL OF TRIBOLOGY-TRANSACTIONS OF THE ASME (2001)
Observation of Kaneta's dimples in elastohydrodynamic lubrication contacts
P Ehret et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY (2001)
Share Paper
