Related references
Note: Only part of the references are listed.Optimizing the mechanical properties of friction stir welded dissimilar joint of AM60 and AZ31 alloys by controlling deformation behavior
Junlei Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Improving performance of friction stir welded AZ31/AM60 dissimilar joint by adjusting texture distribution and microstructure
Junlei Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2020)
Extra strengthening in a coarse/ultrafine grained laminate: Role of gradient interfaces
Y. F. Wang et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2019)
Microstructure evolution and mechanical properties of friction stir welded dissimilar joints of as-extruded AM60 and AZ31 alloys
Junlei Zhang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2019)
Microstructure evolution in the conventional single side and bobbin tool friction stir welding of thick rolled 7085-T7452 aluminum alloy
W. F. Xu et al.
MATERIALS CHARACTERIZATION (2018)
Influence of stress state on microstructure evolution of AZ31 Mg alloy rolled sheet during deformation at room temperature
Dabiao Xia et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Improvement in the strength of friction-stir-welded ZK60 alloys via post weld compression and aging treatment
Zhe Liu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Effect of heat input on microstructure and mechanical properties of butt-welded dissimilar magnesium alloys joint
Yang Fang-zhou et al.
JOURNAL OF CENTRAL SOUTH UNIVERSITY (2018)
Investigation of microstructure and mechanical properties of friction stir welded AZ61 magnesium alloy joint
Kulwant Singh et al.
JOURNAL OF MAGNESIUM AND ALLOYS (2018)
Influence of tool pin profile and rotational speed on the formation of friction stir welding zone in AZ31 magnesium alloy
S. Ugender
JOURNAL OF MAGNESIUM AND ALLOYS (2018)
Microstructure-based modeling of tensile deformation of a friction stir welded AZ31 Mg alloy
Weijun He et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Annealing behavior of a cast Mg-Gd-Y-Zr alloy with necklace fine grains developed under hot deformation
Yi Yang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Improving joint performance of friction stir welded wrought Mg alloy by controlling non-uniform deformation behavior
Q. Shang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Tensile behavior of friction-stir welded AZ31 magnesium alloy
S. Mironov et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Influence of welding parameter on texture distribution and plastic deformation behavior of as-rolled AZ31 Mg alloys
Renlong Xin et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2016)
In-situ investigation on the microstructure evolution and plasticity of two magnesium alloys during three-point bending
Li Jin et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2015)
Effects of nano-particles strengthening activating flux on the microstructures and mechanical properties of TIG welded AZ31 magnesium alloy joints
Xiong Xie et al.
MATERIALS & DESIGN (2015)
The activation of twinning and texture evolution during bending of friction stir welded magnesium alloys
Dejia Liu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Influence of high frequency vibration on microstructure and mechanical properties of TIG welding joints of AZ31 magnesium alloy
Tong Wen et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2015)
Non-uniform deformation in a friction stir welded Mg-Al-Zn joint during stress fatigue
J. Yang et al.
INTERNATIONAL JOURNAL OF FATIGUE (2014)
Friction stir welding of as-extruded Mg-Al-Zn alloy with higher Al content. Part II: Influence of precipitates
J. Yang et al.
MATERIALS CHARACTERIZATION (2014)
Effect of subsequent tension and annealing on microstructure evolution and strength enhancement of friction stir welded Mg alloys
Renlong Xin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Mechanisms of fracture and inhomogeneous deformation on transverse tensile test of friction-stir-processed AZ31 Mg alloy
Renlong Xin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Changes in texture and microstructure of friction stir welded Mg alloy during post-rolling and their effects on mechanical properties
Renlong Xin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Effects of Rotation Rates on Microstructure, Mechanical Properties, and Fracture Behavior of Friction Stir-Welded (FSW) AZ31 Magnesium Alloy
J. Yang et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2013)
Experimental study on temperature distributions within the workpiece during friction stir welding of aluminum alloys
Yeong-Maw Hwang et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2008)
Improvement of yield stress of friction-stirred Mg-Al-Zn alloys by subsequent compression
C. J. Lee et al.
SCRIPTA MATERIALIA (2007)
Effect of micro-texture on fracture location in friction stir weld of Mg alloy AZ61 during tensile test
SHC Park et al.
SCRIPTA MATERIALIA (2003)
Grain size control of commercial wrought Mg-Al-Zn alloys utilizing dynamic recrystallization
H Watanabe et al.
MATERIALS TRANSACTIONS (2001)
Share Paper
