Related references
Note: Only part of the references are listed.Comparative study of microstructure evaluation and mechanical properties of 4043 aluminum alloy fabricated by wire-based additive manufacturing
Qiuyu Miao et al.
MATERIALS & DESIGN (2020)
Printability of multiwalled SS 316L by wire arc additive manufacturing route with tunable texture
V Chakkravarthy et al.
MATERIALS LETTERS (2020)
Effect of titanium powder on microstructure and mechanical properties of wire plus arc additively manufactured Al-Mg alloy
Liwei Wang et al.
MATERIALS LETTERS (2019)
Influence of contact area on the sliding friction and wear behaviour of an electrochemical jet textured Al-Si alloy
J. C. Walker et al.
WEAR (2019)
Wear anisotropy of selective laser melted 316L stainless steel
Y. Yang et al.
WEAR (2019)
Cold metal transfer (CMT) technology - An overview
S. Selvi et al.
DEFENCE TECHNOLOGY (2018)
Microstructure and strength analysis of eutectic Al-Si alloy in-situ manufactured using selective laser melting from elemental powder mixture
Nan Kang et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2017)
Wear behavior and microstructure of hypereutectic Al-Si alloys prepared by selective laser melting
Nan Kang et al.
APPLIED SURFACE SCIENCE (2016)
Forming appearance control of arc striking and extinguishing area in multi-layer single-pass GMAW-based additive manufacturing
Jun Xiong et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2016)
Share Paper
