Related references
Note: Only part of the references are listed.3D-Printed lightweight ceramics using capillary suspensions with incorporated nanoparticles
Moritz Weiss et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2020)
Effect of surrounding polydimethylsiloxane frame and substrate on drying behavior of aqueous alumina suspensions
Lanqing Jiao et al.
INTERNATIONAL JOURNAL OF APPLIED CERAMIC TECHNOLOGY (2018)
Fractal approaches to characterize the structure of capillary suspensions using rheology and confocal microscopy
Frank Bossler et al.
JOURNAL OF RHEOLOGY (2018)
Negative normal stress differences N1-N2 in a low concentration capillary suspension
Irene Natalia et al.
SOFT MATTER (2018)
In situ characterization of immiscible three-phase flow at the pore scale for a water-wet carbonate rock
Alessio Scanziani et al.
ADVANCES IN WATER RESOURCES (2018)
Suppressing Crack Formation in Particulate Systems by Utilizing Capillary Forces
Monica Schneider et al.
ACS APPLIED MATERIALS & INTERFACES (2017)
Highly Porous Materials with Unique Mechanical Properties from Smart Capillary Suspensions
Jens Dittmann et al.
ADVANCED MATERIALS (2016)
Two-phase flow with capillary valve effect in porous media
Rui Wu et al.
CHEMICAL ENGINEERING SCIENCE (2016)
Investigation of film solidification and binder migration during drying of Li-Ion battery anodes
Stefan Jaiser et al.
JOURNAL OF POWER SOURCES (2016)
Structure of Particle Networks in Capillary Suspensions with Wetting and Nonwetting Fluids
Frank Bossler et al.
LANGMUIR (2016)
Highly conductive, printable pastes from capillary suspensions
Monica Schneider et al.
SCIENTIFIC REPORTS (2016)
In situ study of mass loss, shrinkage and stress development during drying of cast colloidal films
Zongwen Fu et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2015)
Fabrication of highly porous glass filters using capillary suspension processing
Johannes Maurath et al.
SEPARATION AND PURIFICATION TECHNOLOGY (2015)
Shrinkage of Tape Cast Products During Binder Burnout
Zongwen Fu et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2015)
Capillary suspensions: Particle networks formed through the capillary force
Erin Koos
CURRENT OPINION IN COLLOID & INTERFACE SCIENCE (2014)
Slot die coating of lithium-ion battery electrodes: investigations on edge effect issues for stripe and pattern coatings
Marcel Schmitt et al.
JOURNAL OF COATINGS TECHNOLOGY AND RESEARCH (2014)
A novel slurry concept for the fabrication of lithium-ion battery electrodes with beneficial properties
Boris Bitsch et al.
JOURNAL OF POWER SOURCES (2014)
Restructuring and aging in a capillary suspension
Erin Koos et al.
RHEOLOGICA ACTA (2014)
Conductive Nanomaterials for Printed Electronics
Alexander Kamyshny et al.
SMALL (2014)
Micro-scale fluid model for drying of highly porous particle aggregates
Abdolreza Kharaghani et al.
COMPUTERS & CHEMICAL ENGINEERING (2013)
Eliminating cracking during drying
Qiu Jin et al.
EUROPEAN PHYSICAL JOURNAL E (2013)
Drying of thin colloidal films
Alexander F. Routh
REPORTS ON PROGRESS IN PHYSICS (2013)
CryoSEM Investigation of Latex Coatings Dried in Walled Substrates
Kyle K. Price et al.
LANGMUIR (2012)
NIH Image to ImageJ: 25 years of image analysis
Caroline A. Schneider et al.
NATURE METHODS (2012)
Drying in porous media with gravity-stabilized fronts: Experimental results
A. G. Yiotis et al.
PHYSICAL REVIEW E (2012)
Tuning suspension rheology using capillary forces
Erin Koos et al.
SOFT MATTER (2012)
Pore Network Models of Drying, Contact Angle, and Film Flows
Marc Prat
CHEMICAL ENGINEERING & TECHNOLOGY (2011)
Capillary Forces in Suspension Rheology
Erin Koos et al.
SCIENCE (2011)
Thin, Flexible Secondary Li-Ion Paper Batteries
Liangbing Hu et al.
ACS NANO (2010)
Drying Regime Maps for Particulate Coatings
Christine M. Cardinal et al.
AICHE JOURNAL (2010)
Low-Cost Inorganic Solar Cells: From Ink To Printed Device
Susan E. Habas et al.
CHEMICAL REVIEWS (2010)
Evolution of mud-crack patterns during repeated drying cycles
Lucas Goehring et al.
SOFT MATTER (2010)
Stress Development During Drying of Aqueous Zirconia Based Tape Casting Slurries Measured by Transparent Substrate Deflection Method
Christiane Bauer et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2009)
Drying of the Silica/PVA Suspension: Effect of Suspension Microstructure
Sunhyung Kim et al.
LANGMUIR (2009)
Printable electronics: flexibility for the future
Mark A. M. Leenen et al.
PHYSICA STATUS SOLIDI A-APPLICATIONS AND MATERIALS SCIENCE (2009)
Stresses and strains in colloidal films during lateral drying
D. M. Holmes et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2008)
On the influence of pore shape, contact angle and film flows on drying of capillary porous media
M. Prat
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2007)
Influence of wettability conditions on slow evaporation in two-dimensional porous media
O. Chapuis et al.
PHYSICAL REVIEW E (2007)
Modern approaches to marine antifouling coatings
L. D. Chambers et al.
SURFACE & COATINGS TECHNOLOGY (2006)
Cracking during lateral drying of alumina suspensions
Derek M. Holmes et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2006)
Microstructure development in drying latex coatings
Y Ma et al.
PROGRESS IN ORGANIC COATINGS (2005)
Stress development during drying of calcium carbonate suspensions containing carboxymethylcellulose and latex particles
P Wedin et al.
JOURNAL OF COLLOID AND INTERFACE SCIENCE (2004)
Role of capillary stresses in film formation
MS Tirumkudulu et al.
LANGMUIR (2004)
Shape evolution and stress development during latex-silica film formation
CJ Martinez et al.
LANGMUIR (2002)
Stress development in drying coatings after solidification
H Lei et al.
AICHE JOURNAL (2002)
Consolidation during drying of aggregated suspensions
LA Brown et al.
AICHE JOURNAL (2002)
Stress development in drying coatings
H Lei et al.
JOURNAL OF APPLIED POLYMER SCIENCE (2001)
Three-phase capillary pressure and relative permeability relationships in mixed-wet systems
MIJ van Dijke et al.
TRANSPORT IN POROUS MEDIA (2001)
Flow in porous media - pore-network models and multiphase flow
MJ Blunt
CURRENT OPINION IN COLLOID & INTERFACE SCIENCE (2001)