Ultra-fine grain TixVNbMoTa refractory high-entropy alloys with superior mechanical properties fabricated by powder metallurgy

TixVNbMoTa refractory high-entropy alloys (RHEAs) were fabricated by mechanical alloying (MA) and spark plasma sintering (SPS) based on classic VNbMoTaW RHEA. The effect of Ti content on the microstructures and mechanical properties of the TixVNbMoTa RHEAs were systematically investigated. The results showed that the milling powders with more Ti content were agglomerated severely in the early stage of the MA process, leading to the extension of mechanical alloying time. The mechanically alloyed powders in all groups exhibited single body-centered-cubic (BCC) phase after the MA process. The sintered alloys were consisted of ultra-fine matrix and precipitation phase. The grain sizes of the matrix and precipitation phases, as well as the volume fraction of the precipitation phases were increased with the increase of Ti content. The MA and SPS processes and the replacement of Ti not only greatly reduce the densities, but also significantly improved the ductility, strength and specific strength of the alloys. The yield strengths were decreased first and then increased with the increase of Ti content in the TixVNbMoTa RHEAs, which is mainly attributed to the weakened effect of grain boundary strengthening, and the enhanced effect of the substitution solid solution strengthening and the interstitial solid solution strengthening. The rapidly increased sizes and volume fractions of the precipitated phases in Ti1.5 and Ti2 destroyed the continuity of matrix and the coordination of deformation, resulting in the decrease of ductility. (C) 2021 Elsevier B.V. All rights reserved.

Automated summary

TixVNbMoTa refractory high-entropy alloys were prepared through MA and SPS, and the effect of Ti content on their microstructures and mechanical properties was investigated. Increasing Ti content resulted in larger grain sizes and volume fractions of the matrix and precipitation phases, while also decreasing the density of the alloys.