Related references
Note: Only part of the references are listed.Influence of mainstream flow oscillations on spatio-temporal variation of adiabatic film cooling effectiveness
Wenwu Zhou et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2019)
Unsteady analysis of adiabatic film cooling effectiveness behind circular, shaped, and sand-dune-inspired film cooling holes: Measurement using fast-response pressure-sensitive paint
Wenwu Zhou et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2018)
High resolution measurements of film cooling performance of simple and compound angle cylindrical holes with varying hole length-to-diameter ratio-Part I: Adiabatic film effectiveness
Weihong Li et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2018)
Turbine Blade Platform Film Cooling With Simulated Swirl Purge Flow and Slashface Leakage Conditions
Andrew F. Chen et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2017)
Experimental and numerical studies on film cooling with, reverse/backward coolant injection
Kuldeep Singh et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2017)
Development of a numerical correlation for the discharge coefficient of round inclined holes with low crossflow
Lorenzo Mazzei et al.
COMPUTERS & FLUIDS (2017)
Experimental and numerical studies on film cooling of a corrugated surface
Kuldeep Singh et al.
APPLIED THERMAL ENGINEERING (2016)
Fast PSP measurements of wall-pressure fluctuation in low-speed flows: improvements using proper orthogonal decomposition
Di Peng et al.
EXPERIMENTS IN FLUIDS (2016)
Film cooling effectiveness with injection through circular holes embedded in a transverse trench
M. A. Pakhomov et al.
THERMOPHYSICS AND AEROMECHANICS (2015)
The Interaction of Jets with Crossflow
Krishnan Mahesh
ANNUAL REVIEW OF FLUID MECHANICS, VOL 45 (2013)
Multi-parameter influence on combined-hole film cooling system
Han Chang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2012)
Experimental Investigation Into Unsteady Effects on Film Cooling
Richard J. Fawcett et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2012)
Influence of Flow Structure on Compound Angled Film Cooling Effectiveness and Heat Transfer
Vipluv Aga et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2011)
Film cooling performance of converging slot-hole rows on a gas turbine blade
Cun-liang Liu et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2010)
Film-Cooling Flowfields With Trenched Holes on an Endwall
N. Sundaram et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2009)
High-resolution film cooling effectiveness comparison of axial and compound angle holes on the suction side of a turbine vane
Scot K. Waye et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2007)
Influence of shaped injection holes on turbine blade leading edge film cooling
YJ Kim et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2004)
Effects of orientation angles on film cooling over a flat plate: Boundary layer temperature distributions and adiabatic film cooling effectiveness
IS Jung et al.
JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME (2000)