Related references
Note: Only part of the references are listed.Cemented carbide microstructures: a review
Jose Garcia et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2019)
Repetitive impact test near uncoated and coated cutting edges for assessing their fatigue behavior
K. -D. Bouzakis et al.
CIRP JOURNAL OF MANUFACTURING SCIENCE AND TECHNOLOGY (2015)
The history of the technological progress of hardmetals
Hugo M. Ortner et al.
INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS (2014)
Effect of cutting edge preparation of coated tools on their performance in milling various materials
K. D. Bouzakis et al.
CIRP JOURNAL OF MANUFACTURING SCIENCE AND TECHNOLOGY (2014)
Coated tools' performance in up and down milling stainless steel, explained by film mechanical and fatigue properties
K. D. Bouzakis et al.
WEAR (2013)
Strain rate effect on the fatigue failure of thin PVD coatings: An investigation by a novel impact tester with adjustable repetitive force
K. -D. Bouzakis et al.
INTERNATIONAL JOURNAL OF FATIGUE (2012)
The dynamic tensile behavior of tough, ultrahigh-strength steels at strain-rates from 0.0002 s-1 to 200 s-1
B. L. Boyce et al.
INTERNATIONAL JOURNAL OF IMPACT ENGINEERING (2009)
Deviations in determining coatings′ and other materials′ mechanical properties, when considering different indenter tip geometries and calibration procedures
K. -D. Bouzakis et al.
SURFACE & COATINGS TECHNOLOGY (2007)
The effect of specimen roughness and indenter tip geometry on the determination accuracy of thin hard coatings stress-strain laws by nanoindentation
KD Bouzakis et al.
MATERIALS CHARACTERIZATION (2002)