Related references
Note: Only part of the references are listed.Control strategy of twist springback for aluminium alloy hybrid thin-walled tube under mandrel-rotary draw bending
Xin Xue et al.
INTERNATIONAL JOURNAL OF MATERIAL FORMING (2018)
Simulation and experimental research of the free bending process of a spatial tube
Xunzhong Guo et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2018)
Springback behaviors of high strength stainless steel tube after numerical control rotary draw bending
Jun Fang et al.
4TH INTERNATIONAL CONFERENCE ON APPLIED MATERIALS AND MANUFACTURING TECHNOLOGY (2018)
Impact of springback on the cross-sectional deformation of H96 brass double-ridged rectangular tube in E-typed rotary draw bending
Xusheng Zheng et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2017)
Modelling of mandrel rotary draw bending for accurate twist springback prediction of an asymmetric thin-walled tube
X. Xue et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2015)
Development of three-dimensional hot bending and direct quench technology
Naoaki Shimada et al.
11TH INTERNATIONAL CONFERENCE ON TECHNOLOGY OF PLASTICITY, ICTP 2014 (2014)
Process model for the design of bent 3-dimensional free-form geometries for the three-roll-push-bending process
Peter H. Vatter et al.
FORTY SIXTH CIRP CONFERENCE ON MANUFACTURING SYSTEMS 2013 (2013)
Springback characterization and behaviors of high-strength Ti-3Al-2.5V tube in cold rotary draw bending
H. Li et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2012)
Springback law of thin-walled 6061-T4 Al-alloy tube upon bending
Li Heng et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2012)
The new TSS bending process: 3D bending of profiles with arbitrary cross-sections
S. Chatti et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2010)
Effect of the elasticity formulation in finite strain on springback prediction
S. Chatti
COMPUTERS & STRUCTURES (2010)
Coupling effects of material properties and the bending angle on the springback angle of a titanium alloy tube during numerically controlled bending
Z. Q. Jiang et al.
MATERIALS & DESIGN (2010)
Neural networks for modelling ultimate pure bending of steel circular tubes
Mohamed Shahin et al.
JOURNAL OF CONSTRUCTIONAL STEEL RESEARCH (2008)
Bending of tube and section made of strain-hardening materials
A. El Megharbel et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2008)
Springback analysis of numerical control bending of thin-walled tube using numerical-analytic method
Mei Zhan et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Free-Bending - A new bending technique in the hydroforming process chain
P Gantner et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
Inelastic effects on springback in metals
RM Cleveland et al.
INTERNATIONAL JOURNAL OF PLASTICITY (2002)
Share Paper
