Related references
Note: Only part of the references are listed.Residential retrofits at scale: opportunity identification, saving estimation, and personalized messaging based on communicating thermostat data
Michael Zeifman et al.
ENERGY EFFICIENCY (2020)
Influence of Initial and Boundary Conditions on the Accuracy of the QUB Method to Determine the Overall Heat Loss Coefficient of a Building
Naveed Ahmad et al.
ENERGIES (2020)
Assessment of data analysis methods to identify the heat loss coefficient from on-board monitoring data
Marieline Senave et al.
ENERGY AND BUILDINGS (2020)
An inverse modeling approach for the thermal response modeling of green facades
Tomaz Suklje et al.
APPLIED ENERGY (2019)
Thermal properties of building walls: Indirect estimation using the inverse method with a harmonic approach
Roberto Ricciu et al.
ENERGY AND BUILDINGS (2019)
Towards the characterization of the heat loss coefficient via on-board monitoring: Physical interpretation of ARX model coefficients
Marieline Senave et al.
ENERGY AND BUILDINGS (2019)
Sensitivity of Characterizing the Heat Loss Coefficient through On-Board Monitoring: A Case Study Analysis
Marieline Senave et al.
ENERGIES (2019)
In-situ rapid determination of walls' thermal conductivity, volumetric heat capacity, and thermal resistance, using response factors
Arash Rasooli et al.
APPLIED ENERGY (2019)
The reliability of inverse modelling for the wide scale characterization of the thermal properties of buildings
Alfonso P. Ramallo-Gonzalez et al.
JOURNAL OF BUILDING PERFORMANCE SIMULATION (2018)
Estimation of thermophysical properties from in-situ measurements in all seasons: Quantifying and reducing errors using dynamic grey-box methods
Virginia Gori et al.
ENERGY AND BUILDINGS (2018)
A comparative assessment of the standardized methods for the in-situ measurement of the thermal resistance of building walls
Ioannis A. Atsonios et al.
ENERGY AND BUILDINGS (2017)
On site characterisation of the overall heat loss coefficient: Comparison of different assessment methods by a blind validation exercise on a round robin test box
Staf Roels et al.
ENERGY AND BUILDINGS (2017)
Assessment of equivalent thermal properties of multilayer building walls coupling simulations and experimental measurements
Luca Evangelisti et al.
BUILDING AND ENVIRONMENT (2017)
The as-built thermal quality of building components: characterising non-stationary phenomena through inverse modelling
An-Heleen Deconinck et al.
11TH NORDIC SYMPOSIUM ON BUILDING PHYSICS (NSB2017) (2017)
A comparison of standardized calculation methods for in situ measurements of facades U-value
Katia Gaspar et al.
ENERGY AND BUILDINGS (2016)
Comparison of characterisation methods determining the thermal resistance of building components from onsite measurements
An-Heleen Deconinck et al.
ENERGY AND BUILDINGS (2016)
Obtaining the heat loss coefficient of a dwelling using its heating system (integrated coheating)
David Farmer et al.
ENERGY AND BUILDINGS (2016)
The influence of Genetic Algorithm parameters over the efficiency of the energy consumption estimation in a low-energy building
Mihail-Bogdan Carutasiu et al.
EENVIRO-YRC 2015 - BUCHAREST (2016)
Comparisons of inverse modeling approaches for predicting building energy performance
Yuna Zhang et al.
BUILDING AND ENVIRONMENT (2015)
A procedure for modeling buildings and their thermal zones using co-simulation and system identification
Sullivan Royer et al.
ENERGY AND BUILDINGS (2014)
Thermal characterization of homogeneous walls using inverse method
Khaled Chaffar et al.
ENERGY AND BUILDINGS (2014)
Development and validation of a gray box model to predict thermal behavior of occupied office buildings
Thomas Berthou et al.
ENERGY AND BUILDINGS (2014)
Applying science and mathematics to big data for smarter buildings
Young M. Lee et al.
IMPLICATIONS OF A DATA DRIVEN-BUILT ENVIRONMENT (2013)
Inverse modeling of simplified hygrothermal building models to predict and characterize indoor climates
Rick Kramer et al.
BUILDING AND ENVIRONMENT (2013)
Modeling of a Building System and its Parameter Identification
Herie Park et al.
JOURNAL OF ELECTRICAL ENGINEERING & TECHNOLOGY (2013)
Optimal temperature control of intermittently heated buildings using Model Predictive Control: Part I - Building modeling
Ion Hazyuk et al.
BUILDING AND ENVIRONMENT (2012)
Simplified thermal and hygric building models: A literature review
Rick Kramer et al.
FRONTIERS OF ARCHITECTURAL RESEARCH (2012)
Identifying suitable models for the heat dynamics of buildings
Peder Bacher et al.
ENERGY AND BUILDINGS (2011)
Overview of HVAC system simulation
Marija Trcka et al.
AUTOMATION IN CONSTRUCTION (2010)
Parameter estimation of internal thermal mass of building dynamic models using genetic algorithm
SW Wang et al.
ENERGY CONVERSION AND MANAGEMENT (2006)
Modeling and predicting building's energy use with artificial neural networks: Methods and results
S. Karatasou et al.
ENERGY AND BUILDINGS (2006)
Experimental estimation of building energy performance by robust regression
C Ghiaus
ENERGY AND BUILDINGS (2006)
Applying support vector machines to predict building energy consumption in tropical region
B Dong et al.
ENERGY AND BUILDINGS (2005)
Share Paper
