Related references
Note: Only part of the references are listed.Bandgap extraction from quantum efficiency spectra of Cu(In,Ga)Se2 solar cells with varied grading profile and diffusion length
M. Richter et al.
THIN SOLID FILMS (2017)
Effect of Reaction Temperature and Time during Two-Step Selenization and Sulfurization of Se-Coated CuGa/In Precursors
Jaseok Koo et al.
ELECTRONIC MATERIALS LETTERS (2016)
Effect of substrate temperature and post-annealing on the properties of CIGS thin films deposited using e-beam evaporation
Jieyi Chen et al.
JOURNAL OF PHYSICS D-APPLIED PHYSICS (2016)
Surface modification of CIGS film by annealing and its effect on the band structure and photovoltaic properties of CIGS solar cells
Young Min Shin et al.
CURRENT APPLIED PHYSICS (2015)
Composition and bandgap control in Cu(In,Ga)Se2-based absorbers formed by reaction of metal precursors
Kihwan Kim et al.
PROGRESS IN PHOTOVOLTAICS (2015)
Quantum size effect on cubic PbTe nanocrystals embedded in amorphous InSe thin film matrix
M. Manonmani Parvathi et al.
SUPERLATTICES AND MICROSTRUCTURES (2014)
Electrical impact of MoSe2 on CIGS thin-film solar cells
Kuo-Jui Hsiao et al.
PHYSICAL CHEMISTRY CHEMICAL PHYSICS (2013)
Optimization of Se layer thickness in Mo/CuGa/In/Se precursor for the formation of Cu(InGa)Se2 by rapid thermal annealing
Jaseok Koo et al.
THIN SOLID FILMS (2013)
Characterization of Cu(In,Ga)Se-2 Solar Cells Grown on Na-Free Glass with an NaF Layer on a Mo Film
Young Min Shin et al.
ECS JOURNAL OF SOLID STATE SCIENCE AND TECHNOLOGY (2013)
Three-step H2Se/Ar/H2S reaction of Cu-In-Ga precursors for controlled composition and adhesion of Cu(In,Ga)(Se,S)2 thin films
Kihwan Kim et al.
JOURNAL OF APPLIED PHYSICS (2012)
Characteristics of Cu(In,Ga)Se2 Films Prepared by Atmospheric Pressure Selenization of Cu-In-Ga Precursors Using Ditert-Butylselenide as Se Source
Sheng-Yu Hsiao et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2012)
A promising sputtering route for one-step fabrication of chalcopyrite phase Cu(In,Ga)Se2 absorbers without extra Se supply
Chia-Hsiang Chen et al.
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2012)
High Efficiency CIGS Solar Modules
Franz Karg
INTERNATIONAL CONFERENCE ON MATERIALS FOR ADVANCED TECHNOLOGIES 2011, SYMPOSIUM O (2012)
Preparation and characterization of Cu(In,Ga)(Se,S)2 films without selenization by co-sputtering from Cu(In,Ga)Se2 quaternary and In2S3 targets
Y. C. Lin et al.
APPLIED SURFACE SCIENCE (2011)
Fabrication of Cu(In, Ga)Se2 thin films by sputtering from a single quaternary chalcogenide target
J. H. Shi et al.
PROGRESS IN PHOTOVOLTAICS (2011)
Grain Growth Enhancement and Ga Distribution of Cu(In0.7Ga0.3)Se-2 Film Using Cu2Se Layer on Cu-In-Ga Metal Precursor
Min Sik Kim et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2010)
Key near-term R&D issues for continuous improvement in CIS-based thin-film PV modules
Katsumi Kushiya
SOLAR ENERGY MATERIALS AND SOLAR CELLS (2009)
Interface control to enhance the fill factor over 0.70 in a large-area CIS-based thin-film PV technology
K. Kushiya et al.
THIN SOLID FILMS (2009)
Incongruent reaction of Cu-(InGa) intermetallic precursors in H2Se and H2S
G. M. Hanket et al.
JOURNAL OF APPLIED PHYSICS (2007)
Material and device properties of single-phase Cu(In,Ga)(Se,S)2 alloys prepared by selenization/sulfurization of metallic alloys
V Alberts et al.
THIN SOLID FILMS (2004)
Diffusion of indium and gallium in Cu(In,Ga)Se2 thin film solar cells
O Lundberg et al.
JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS (2003)
Share Paper
