Related references
Note: Only part of the references are listed.Development of a filtered interphase heat transfer model based on fine-grid simulations of gas-solid flows
Zheqing Huang et al.
AICHE JOURNAL (2020)
Modelling of the pyrolysis of low-rank-coal briquettes in an industrial-scale gas heat carrier pyrolyzer
Yuting Zhuo et al.
POWDER TECHNOLOGY (2020)
Coarse-grained DEM study of solids sedimentation in water
Zhouzun Xie et al.
POWDER TECHNOLOGY (2020)
Flow and heat mass performances of wet particle drying process based on liquid volume-varying bridge force
Tianqi Tang et al.
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER (2020)
Thermal radiation characteristics in dilute phase region of the oxy-fuel combustion pressurized fluidized bed
Xin Zeng et al.
APPLIED THERMAL ENGINEERING (2020)
CFD-DEM study of biomass gasification in a fluidized bed reactor: Effects of key operating parameters
Shuai Wang et al.
RENEWABLE ENERGY (2020)
CFD-DEM simulation of heat transfer in fluidized beds: Model verification, validation, and application
Shuai Wang et al.
CHEMICAL ENGINEERING SCIENCE (2019)
CFD Simulation and Optimization of Mixing Behaviors in a Spouted Bed with a Longitudinal Vortex
Feng Wu et al.
ACS OMEGA (2019)
Particle-scale study of spout deflection in a flat-bottomed spout fluidized bed
Yuanhe Yue et al.
CHEMICAL ENGINEERING SCIENCE (2019)
Particle-Scale Study of the Effect of Operating Conditions on Spout Deflection Behavior in a Flat-Bottomed Spout-Fluidized Bed
Yuanhe Yue et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2019)
A new fountain confinement device for fluidizing fine and ultrafine sands in conical spouted beds
Aitor Pablos et al.
POWDER TECHNOLOGY (2018)
Experimental investigation on gas-solid hydrodynamics of coarse particles in a two-dimensional spouted bed
He Zhang et al.
POWDER TECHNOLOGY (2017)
CFD-DEM study of the effect of cyclone arrangements on the gas-solid flow dynamics in the full-loop circulating fluidized bed
Shuai Wang et al.
CHEMICAL ENGINEERING SCIENCE (2017)
DEM numerical investigation of wet particle flow behaviors in multiple-spout fluidized beds
Tianqi Tang et al.
CHEMICAL ENGINEERING SCIENCE (2017)
Parallel LES-DEM simulation of dense flows in fluidized beds
Shuai Wang et al.
APPLIED THERMAL ENGINEERING (2017)
Numerical investigation on the effect of draft plates on spouting stability and gas-solid characteristics in a spout-fluid bed
Shiliang Yang et al.
CHEMICAL ENGINEERING SCIENCE (2016)
Investigations on the spouting stability in a prismatic spouted bed and apparatus optimization
Vitalij Salikov et al.
ADVANCED POWDER TECHNOLOGY (2015)
A study of heat transfer in fluidized beds using an integrated DIA/PIV/IR technique
Amit V. Patil et al.
CHEMICAL ENGINEERING JOURNAL (2015)
Characterization and CFD-DEM modelling of a prismatic spouted bed
Vitalij Salikov et al.
POWDER TECHNOLOGY (2015)
Styrene recovery from polystyrene by flash pyrolysis in a conical spouted bed reactor
Maite Artetxe et al.
WASTE MANAGEMENT (2015)
Pyrolysis of Heavy Oil in the Presence of Supercritical Water: The Reaction Kinetics in Different Phases
Xue-Cai Tan et al.
AICHE JOURNAL (2015)
Particle-Scale Investigation of the Solid Dispersion and Residence Properties in a 3-D Spout-Fluid Bed
Shiliang Yang et al.
AICHE JOURNAL (2014)
Spout fluidized beds: Recent advances in experimental and numerical studies
Vinayak S. Sutkar et al.
CHEMICAL ENGINEERING SCIENCE (2013)
Computational Study of the Effects of Material Properties on Heat Transfer in Gas Fluidization
Qin-Fu Hou et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2012)
Open-source MFIX-DEM software for gas-solids flows: Part II - Validation studies
Tingwen Li et al.
POWDER TECHNOLOGY (2012)
DEM simulation of particle mixing in flat-bottom spout-fluid bed
Yong Zhang et al.
CHEMICAL ENGINEERING RESEARCH & DESIGN (2010)
PEPT and discrete particle simulation study of spout-fluid bed regimes
J. M. Link et al.
AICHE JOURNAL (2008)
DEM simulation of the particle dynamics in two-dimensional spouted beds
X-L. Zhao et al.
POWDER TECHNOLOGY (2008)
Discrete particle simulation of particulate systems: Theoretical developments
H. P. Zhu et al.
CHEMICAL ENGINEERING SCIENCE (2007)
Flow pattern and transition of rectangular spout-fluid bed
Wenqi Zhong et al.
CHEMICAL ENGINEERING AND PROCESSING-PROCESS INTENSIFICATION (2006)
Effects of operating conditions on the quality of mango pulp dried in a spout fluidized bed
RL da Cunha et al.
DRYING TECHNOLOGY (2006)
Flow regimes in a spout-fluid bed: A combined experimental and simulation study
JM Link et al.
CHEMICAL ENGINEERING SCIENCE (2005)
A comparative study of spouted and spout-fluid beds for tablet coating
CR Kfuri et al.
DRYING TECHNOLOGY (2005)
Study of mixing in gas-fluidized beds using a DEM model
MJ Rhodes et al.
CHEMICAL ENGINEERING SCIENCE (2001)
A computational investigation of transient heat transfer in pneumatic transport of granular particles
J Li et al.
POWDER TECHNOLOGY (2000)
Hydrodynamics and stability of slot-rectangular spouted beds. Part I: Thin bed
OM Dogan et al.
CHEMICAL ENGINEERING COMMUNICATIONS (2000)
Share Paper
