Related references
Note: Only part of the references are listed.A model for rapid austenitization in steel with ferrite and pearlite microstructure under electropulsing
Chao Wu et al.
MATERIALIA (2019)
A comparative study on the microstructural evolution in AM60 alloy processed by ECAP and MDF
A. Heczel et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2018)
Tensile properties of AZ61 magnesium alloy produced by multi-pass friction stir processing: Effect of sample orientation
X. C. Luo et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Exceptional mechanical properties of ultra-fine grain AZ31 alloy by the combined processing of ECAP, rolling and EPT
Guangwei Zhao et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2018)
Comparisons of microstructures and texture and mechanical properties of magnesium alloy fabricated by compound extrusion and direct extrusion
H. -J. Hu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2017)
Grain size effects on dislocation and twinning mediated plasticity in magnesium
Haidong Fan et al.
SCRIPTA MATERIALIA (2016)
Recrystallization and microstructure evolution of the rolled Mg-3Al-1Zn alloy strips under electropulsing treatment
Yang Liu et al.
JOURNAL OF ALLOYS AND COMPOUNDS (2015)
Development of microstructure in submicron particles reinforced magnesium matrix composite processed by room temperature deformation
K. B. Nie et al.
MATERIALS CHEMISTRY AND PHYSICS (2015)
Microstructures and mechanical properties of AZ61 magnesium alloy after isothermal multidirectional forging with increasing strain rate
Juqiang Li et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Enhanced mechanical properties due to grain refinement and texture modification in an AZ61 Mg alloy processed by small strain impact forging
M. G. Jiang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2015)
Microstructure, texture and mechanical properties in an as-cast AZ61 Mg alloy during multi-directional impact forging and subsequent heat treatment
M. G. Jiang et al.
MATERIALS & DESIGN (2015)
Hot deformation behavior of hot-rolled AZ31 and AZ61 magnesium alloys
M. L. Olguin-Gonzalez et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Microstructure evolution and tensile mechanical properties of thixoformed AZ61 magnesium alloy prepared by squeeze casting
Tian Chen et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2014)
Influence of Route-R on wrought magnesium AZ61 alloy mechanical properties through equal channel angular pressing
Muralidhar Avvari et al.
JOURNAL OF MAGNESIUM AND ALLOYS (2014)
Microstructure and mechanical properties of AZ61 alloys with large cross-sectional size fabricated by multi-pass ECAP
Jufu Jiang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2013)
Influence of electropulsing treatment on microstructure and mechanical properties of cold-rolled Mg-9Al-1Zn alloy strip
Yanbin Jiang et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2011)
Improved plasticity of Mg-Al-Zn alloy by electropulsing tension
Qing Xu et al.
MATERIALS LETTERS (2010)
Effects of solution heat treatment on microstructure and mechanical properties of AZ61-0.7Si magnesium alloy
Ming-bo YANG et al.
TRANSACTIONS OF NONFERROUS METALS SOCIETY OF CHINA (2010)
Effect of cold plastic deformation on electrical conductivity of various materials
Cem S. Cetinarslan
MATERIALS & DESIGN (2009)
Texture evolution in equal-channel angular extrusion
Irene J. Beyerlein et al.
PROGRESS IN MATERIALS SCIENCE (2009)
Analysis of texture evolution in magnesium during equal channel angular extrusion
Benoit Beausir et al.
ACTA MATERIALIA (2008)
Influence of texture on dynamic recrystallization and deformation mechanisms in rolled or ECAPed AZ31 magnesium alloy
J. A. del Valle et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Stored energy, microstructure, and flow stress of deformed metals
A Godfrey et al.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE (2005)
Mechanical properties and microstructure of AZ31 Mg alloy processed by two-step equal channel angular extrusion
L Jin et al.
MATERIALS LETTERS (2005)
Grain refinement and formation of ultrafine-grained microstructure in a low-carbon steel under electropulsing
YZ Zhou et al.
JOURNAL OF MATERIALS RESEARCH (2002)
Recrystallization in fatigued copper single crystals under electropulsing
SH Xiao et al.
SCRIPTA MATERIALIA (2002)
Share Paper
