4.6 Review

The influence of land use/land cover variability and rainfall intensity in triggering landslides: a back-analysis study via physically based models

Journal

NATURAL HAZARDS
Volume 105, Issue 1, Pages 1139-1161

Publisher

SPRINGER
DOI: 10.1007/s11069-020-04324-x

Keywords

Landslides; Hillslope stability; Land use and land cover; TRIGRS

Ask authors/readers for more resources

The study used physically based models to analyze factors influencing slope instability and landslides in the Bengalar Stream basin in São Paulo, Brazil. The FS FIORI and TRIGRS models showed similar results, with TRIGRS identifying more unstable areas than FS FIORI in two scenarios.
The objective of this study was to use physically based models to carry out a back-analysis of the set of factors that may have influenced slope instability and the consequent development of 65 landslides in the Bengalar Stream basin, located in the Northern Region of Sao Jose dos Campos, Sao Paulo State, Brazil, associated with rainfall between March 7 and 8, 2016. Unlike other models, the FS FIORI model used in this study allowed extra variables to be added to the model that can influence hillslope stability and is associated with land use and land cover (LULC) variability. Analysis of intense short-term and accumulated long-term rainfall influence on slope instability was possible via a TRIGRS model. A comparative analysis was also carried out between a static model (FS FIORI) and a transient model (TRIGRS) which considered the factor of safety and pore pressure to be a function of precipitation and infiltration rates. Despite the differences in their hydrological components, both models were shown to present relatively similar and demonstrated stability rates coherence, according to the characteristics of each model. The FS FIORI model only classified 1.3% of the entire basin as unstable (FS <= 1), whereas the TRIGRS model classified 4.5% and 2.9% of the entire basin as unstable in scenarios 1 and 2, respectively. The validity and the accuracy of each model were tested via a receiver operating characteristic (ROC) curve and an area under the curve (AUC). AUC values were: 0.6552 for the FS FIORI model, and 0.7238 and 0.7186 for scenarios 1 and 2 of the TRIGRS model, respectively. The models performed well, with values considered to be acceptable. These results demonstrate an advancement in slope stability modeling studies, including conditioning factors associated with LULC for slope stability calculations.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available